Haier ADP8152 User Manual

NOTES

DISHWASHER

INSTALLATION AND USE
ADP8152

Safety Is a Good Habit to Get Into

R

1

4

3

2

5

ON
OFF

1
2

12345

S

DECLARATION OF CONFORMITY

The manufacturer of the product/s described herein, to which this description refers, declares on its sole responsibility that the
product/s meet the relevant fundamental satety, health and protection requirements of the relevant EU guidelines and that corre­sponding test reports are available for examination by the relevant authorities and can be requested from the seller of the appliance ,
especially with regard to CE Declaration of Conformity issued by the manufacturer or with the manufacturer's approval.

Moreover, the manufacturer declares that the parts of the appliance described in this user manual, which come into contact with fresh
food, do not contain any toxic substances.

Please keep this handbook for future reference or for anyone else who may use this appliance.

CONTENTS

Safety Is a Good Habit to Get Into

○○○○○○○○○○○○○○○○○○○○

1

NOTICE
Carefully read the instructions contained in this manual,as they
provide importion which is essential to safe and proper installation,
use and maintenace of the appliance.

This appliance complies with the following EEC

directives:

-73/23/EEC of 19/02/73(Low Voltage)and subsequent
modifications;

- 89/336/EEC of 03/05/89 (Electromagnetic
Compatibility) and subsequent modifications.

- Carefully dispose of the packing material.

- After removing the packing,check to make sure that the appli­ ance is not damaged.If in doubt,contact a qualified professional.

- The dishwasher must only be used by adults for the washing of
household dishes and cooking utensils.

- Fundamental rules to follow when using the appliance:
* Do not use extension cords or multiple sockets;
* During installation,the power supply cord must not be exces
sively or dangerously bent or flattened;
* If the appliance is not operating properly, or, maintenance must
be performed,disconnect the appliance from the power supply.

- Keep detergents out of the reach of children,who must also be
kept away from the dishwasher when it is open.

- This appliance cannot be installed outdoors,not even if the
area in which it is installed is covered by a roof;it is also very
dangerous to leave it exposed to the rain and elements.

- Do not touch the heating element during or after a wash cycle.

- Do not lean or sit on the door when it is open ,as this could
overturn the dishwasher.

- Do not use solvents of any kind inside your dishwasher. They
could cause an explosion.

- If the appliance malfunctions,turn off water supply to the appli
ance and disconnect the plug from the wall socket.Then,con
sult the section entitled, "Troubleshooting."If you cannot re
solve the problem,contact a service centre.

- Only specialised personnel are authorised to make repairs.

- Appliances which are no longer being used must be made
inoperable by cutting the power supply cord and removing the
the plugs from the socket .

- The appliance must be positioned so that the plug is accessible.

- The carpet must obstruct the opening when the appliance is in
stalling on the ground with carpet.

- If the supply cord is damaged , it must be replaced by a
special cord or assembly available from the manufacturer or
its service agent.

Close-up View (control panel)
Close-up View (Interrior)
Salt

○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○

○○○○○○○○○○○○○○○○○○○○○○○○○○○○

Detergent and Rinse Aid
Loading the Dishwasher
Turning on the Appliance

○○○○○○○○○○○○○○○○○○○○○○○○○○○○○

○○○○○○○○○○○○○○○○○○○○○○○○○○○○○

Wash Cycle adjustment Buttons
Energy Saving Tips

○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○

○○○○○○○○○○○○○○○○○○○○○○○○

○○○○○○○○○○○○○○○○○○○○○○○○○○○

○○○○○○○○○○○○○○○○○○○○○

How to Keep Your Dishwasher in Shape

Wash Cycle Table

○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○

Cleaning and Special Maintenance
Troubleshooting
Installation

○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○

○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○

○○○○○○○○○○○○○○○○

○○○○○○○○○○○○○○○○○○○

1
2
3
4
5
6
6
7
8
8
9
9
10

Close-up View (Control Panel)

A B C D

I H G

A
B
C

ON-OFF Light
ON-OFF Button
Low Salt Indicator Light

F
G
H

E

Handle For Opening Door

"Eco" Button
"HALF LOAD" Button

F

Electrical Safety Instruction

○○○○○○○○○○○○○○○○○○○○○○○○○○○○

12

D
E

Low Rinse Aid Indicator Light
Knob For Selecting Program

.1.

I

"RAPID"Button

Close-up View (Interrior)

Salt

Salt

The hardness of the water varies from place to place. If hard
water is used in the dishwasher,deposits will form on the dishes
utensils.
The appliance is equipped with a special softener that uses a salt
specifically designed to eliminate lime and minerals from the water.

Loading the Salt into the Softener

Always use salt intended for use with dishwashers.
The salt container is located beneath the lower rack and should
be filled as follows:

- Remove the lower rack , unscrew and remove the cap
from the salt container;

- If you are filling the container for the first time, fill it with water;

- Place the end of the funnel(supplied) into the hole and intro­ duce about 2 kg of salt.It is normal for a small amount of water
to come out of the salt container.

- Carefully screw the cap back on.

Adjusting Salt Consumption

The dishwasher is designed to allow for adjusting the amount of
salt consumed based on the hardness of the water used.This is
intened to optimize and customize the level of salt consumption
so that it remains at a minimum.
To adjust salt consumption,proceed as follows:

A
B
C
D

Upper Rack
Rack Height Adjustor

Top Sprayer Arm
Lower Rack

Technical characteristics

Width

Depth
Height

Capacity

Mains water pressure

Voltage
Total power

E
F
G
H
I

Washing Filter
Bottom Sprayer Arm
Detergent and Rinse Aid Dispenser

Salt Container Cap
Third Sprayer

60 cm
60 cm
85 cm

12 standard place settings

Minimun30Kpa / Maxmun6Kpa

220-240V~ 50Hz

2100W

The salt container must be filled when the "low salt" indicator
light (located on the control panel),comes on.

To prevent the formation of rust,load the salt just before be­ginning a wash cycle.

.

- Unscrew the cap from the salt container;

- There is a ring on the container with an arrow on it (see figure to
the side),

- If necessary, rotate the ring in the anticlockwise direction from
the "-" setting towards the "+" sign,based on the hardness of
the water being used.
It is recommended that adjustments be made in accordance with
the following scheme:

Water Hardness

Clarke
detergent

0 14

dH

mmol/l

Selector
position

Salt
consumption
(Grams/cycle)

Autonomy
(cycles\2kg)

.2.

.3.