GSI PNEG-130 User Manual

Instructions

1004 East Illinois Street • Assumption, IL 62510 • 217-226-4421

1. Be sure and use caulking that is provided on all seams and corners throughout the assembly.

2. Bottom panel flanges should always be on the “outside” of the transition assembly. Refer to b ottom
panel flange detail in Figure 1 for proper flange direction and assembly of individual flange type. Bolt
bottom panel to all entrance collar braces and side entrance collar pieces. Be sure and use
5/16" x 3/4" bolts and nuts.

3. Install and bolt top entrance collar to entrance collar braces and side pieces. Bolt transition sides to
bottom panel. After sides are complete, bolt top panel into position. Be sure and use 5/16" x 3/4" bolts
and nuts on all pieces.

4. Field cut hole in bin sidewall 68-1/4" x 11-3/4" to allow transition to fit properly.

5. Install entrance collar mounting brackets to transition on inside of bin. Be sure and use 5/16" x 3/4"
bolts and nuts.

6. Using 5/16" x 1-1/4" bolts and nuts, install entrance collar mounting brackets to bin sidewall. Installer
must seal between bin sidewall and entrance collar mounting brackets. No sealer is provided.

7. After putting transition on bin, locate sizing angle to curvature of bin, screw to top en trance collar and
to bin sidewall. Use #10 x 1" screws.

Installation of TR-6207

Figure 1 Bottom Panel Flange Detail

Date: 10-17-08 PNEG-130

Printed in the U.S.A.
Copyright © 2008 by GSI Group
www.gsiag.com

PNEG-130

Page 1 of 2

Installation of TR-6207

TR-6207 Parts List

Ref # Part # Description Qty

1 TR-6205 Top Panel 1
2 TR-6194 Sizing Angle 1
3 TR-6206 Bottom Panel 1
4 TR-6312 Entrance Collar Brace 4
5 TR-6476 Entrance Collar Mounting Bracket 2

6 TR-6196 Side Entrance Collar 2
7A TR-6203-1 R.H. Side Panel 1
7B TR-6203-2 L.H. Side Panel 1

8 TR-6192 Top Entrance Collar 1

PL-8079 Hardware Package 1
A S-275 Bolt HH Bin 5/16"-18 x 3/4" YDP Grade 5 130
B S-277 Bolt HH Bin 5/16"-18 x 1-1/4" YDP Grade 5 10

C S-396 Hex Nut 5/16"-18 YDP Grade 2 140
D S-7621 Screw SDS #10-16 x 1" HWH ZN Grade 2 36

Page 2 of 2 Pneg-130