Grundig RP 4200 User Manual

PORTABLE RADIO

Music Boy 40

ǵ

RP 4200

2

3 Sicherheit/Informationen 6 Radio-Betrieb
4 Auf einen Blick 44 Service
5 Stromversorgung

7 Safety/Information 11 Radio mode
9 Overview 44 Service

10 Power supply

12 Sécurité/Informations 15 Fonctionnement
13 Vue d’ensemble 44 Service
14 Alimentation électrique

16 Sicurezza/Informazioni 19 Funzionamento radio
17 In breve 44 Service
18 Alimentazione elettrica

20 Segurança/Informações 23 Função rádio
21 Vista geral 44 Service
22 Alimentação de corrente

24 Seguridad/Información 27 Modo radio
25 Vista general 44 Service
26 Alimentación de corriente

28 Veiligheid/informatie 31 Radiofunctie
29 In een oogopslag 44 Service
30 Stroomtoevoer

32 Sikkerhed/Informationer 35 Radiofunktion
33 Kort oversigt 44 Service
34 Strømforsyning

36 Säkerhet/Information 39 Radio
37 En överblick 44 Service
38 Strömförsörjning

40 Turvallisuus/tietoja 43 Radiokäyttö
41 Yleiskatsaus 44 Service
42 Virransyöttö

___________________________________________________________________

DEUTSCH

ENGLISH

FRANÇAIS

ITALIANO

PORTUGUÊS

ESPAÑOL

NEDERLANDS

DANSK

SVENSKA

SUOMI

ENGLISH

7

Safety

This device is designed for the playback of audio signals. Any other use is
expressly prohibited.

Protect the device from moisture (water drops or splashes). Do not place any
vessels such as vases on the device. These may be knocked over and spill
fluid on the electrical components, thus presenting a safety risk.

When deciding where to place the device, please note that furniture surfaces
are covered by various types of varnish and plastic, most of which contain
chemical additives. These additives can corrode the device supports, leaving
residues on the furniture surfaces which can be difficult or impossible to
remove.

Do not use any cleaning agent, as this may damage the casing. Clean the
device with a clean, moist leather cloth. Never open the device casing. The
manufacturer will not accept any liability for damage resulting from impro­per handling.

The type plate is located on the bottom of the device.

Information

This device is noise-suppressed according to the applicable EU directives.
This product fulfils the European directives 89/336/EEC, 73/23/EEC and
93/68/EEC.
This device conforms to the safety regulation VDE 0860 and therefore the
international safety regulation IEC 65.

Technical data

Power supply: 230 V, 50/60Hz
Max. power consumption: <5 W (operation), <0.5 W (stand-by)
Output: DIN 45324, 10% THD 750 mW
Frequency bands: FM 87.5 …108.0 MHz

MW 526.5 … 1606.5 kHz
SW 5.8 … 18.5 MHz (49 … 16 m)

Dimensions and weight W x H x L 247 x 127 x 62 mm

Weight approx. 0.9 kg

Environmental note

As little material as possible was used in the packaging of your device.
It consists of two separate materials: cardboard (box) and polyethylene
(bag). Please observe the local regulations for disposing of the packing
material.

Technical and design modifications reserved!

SAFETY, INFORMATION

_____________________

ENGLISH

! SERVICE !! SERVICE !

LIFT

! SERVICE !

AC~

8

SAFETY, INFORMATION

________________________________

Additional information for units sold in the UK.

Units sold in the UK are suitable for operation from a 240V ac, 50Hz mains
supply.
The range of multi-system receivers is built to work in most European coun­tries. However, the mains plug and socket system for the UK differs from
many European countries.
This appliance has been supplied with a fitted, non-removable, approved
converter plug for use in the UK. This converter plug is fitted with a 5A rated
fuse.

In case this appliance is supplied with a moulded 2-pin Euro plug only,
which is unsuitable for UK operation, this must be cut off and immediately
disposed of. An approved 13A, 3-pin UK plug should then be fitted by a
qualified electrician.

Note:

The severed Euro plug must be destroyed to avoid a possible shock
hazard should it be inserted into a socket elsewhere.

If a non-rewireable 3-pin plug or a rewireable 13A (BS1363) 3-pin plug is
used, it must be fitted with a 5A ASTA or BSI approved BS1362 fuse. If any
other type of plug is used it must be protected by a 5A fuse either in the
plug, or at the distribution board. If this type of plug becomes defective,
ensure that the fuse is removed before disposal, to eliminate potential shock
hazard.

If it is necessary to change the fuse in the non-rewireable plug, the correct
type and rating (5A ASTA or BSI approved BS1362) must be used and the
fuse cover must be refitted. If the fuse cover is lost or damaged, the lead and
plug must not be used until a replacement is obtained. Replacement fuse
covers should be obtained from your dealer.

Important:

The wires in the mains lead are colour coded in accordance with the follo­wing code:

BLUE – NEUTRAL
BROWN – LIVE

As the colours of the wires in the mains lead of your appliance may not cor­respond with the coloured marking identifying terminals in your plug, pro­ceed as follows:

Connect the BLUE coloured wire to plug terminal marked with the letter “N”
or coloured black.
Connect the BROWN coloured wire to the plug terminal marked with the let­ter “L” or coloured red.
In no circumstance must any of the wires be connected to the terminal mar­ked with the letter “E”, earth symbol “

z”, coloured green, or green & yel-

low.

Replacement mains lead sets can be obtained from your local dealer, or by
contacting Grundig Consumer Relations (01788 570088)
Moulded 3-pin lead set, suitable for UK use:

Ref: Leadset UK 8290-991-224

Moulded 2-pin Euro lead set, not suitable for UK use:

Ref: Leadset Euro 8290-991-316

ENGLISH

9

OVERVIEW

___________________________________________

Controls on the top

ON/OFF Switches the device on and off.

ɷ

TONE ɦFor setting the tone.

ļ For raising the telescopic antenna (FM and SW reception).

LIFT

Controls on the front

FM MW SW Station and waveband scale.

Controls on the sides

+

VOL. – Adjusts the volume.

0 Earphone socket (3.5 mm stereo plug);

Mono playback via earphones.

TUNING For tuning to a radio station.

SW

•MW•FM Waveband switch: switches between the wavebands FM

(UKW), MW (medium wave) and SW (short wave).

Controls on the back

AC ~ Connection socket for power cable supplied.

Battery compartment.

Handle.

ON/OFF

TONE

USIC BOY 40

M

ǵ

PORTABLE RADIO

FM 88 92 100 104 106 108 MHz

MW 540 600 700 800 1000 1200 1400 1600 kHz

SW 6 6.5 7 8 10 12 14 16 18 kHz

LIFT

AC~

TUNING

SW MW FM

+

VOL.

10

Mains operation

Note:

Check that the mains voltage on the type plate (on the bottom of the
device) corresponds to your local mains supply.
If this is not the case, contact your specialist dealer.

1 Plug the mains cable supplied into the »AC ~« socket on the device.

2 Plug the mains cable into the socket (230 V~, 50/60 Hz).

Note:

If there are batteries in the device, these are switched off automatically
during mains operation.

Caution:

The only way to disconnect the device from the mains supply is to pull
out the plug.

Battery operation

You can also operate the device using standard batteries (not supplied). In
this case, you must disconnect the mains power cable.

1 Open the battery compartment by pressing the marked area and pus-

hing down the cover.

2 Insert four batteries (4x1.5 V, Type IEC, AM2, LR 14, C-size) according

to the polarity marked on the battery compartment.

Note:

Remove the batteries when they are flat or when you know that the
device will not be used for a long period of time.
No liability is accepted for damage resulting from leaking batteries.

Environmental note:

Batteries, including those which contain no heavy metal, must not be
disposed of with household waste. Please dispose of used batteries in
an environmentally sound manner. Observe the legal regulations which
apply in your area.

POWER SUPPLY

___________________________________

LIFT

AC~

LIFT

AC~

AC~

ENGLISH

11

RADIO MODE

_______________________________________

Tuning radio stations

1 Press »ON/OFF« to switch on the device.

2 Adjust the volume using »VOLUME«.

3 Select the waveband with the waveband switch.

Note:

For the best FM or SW reception, extend the telescopic antenna and
direct it accordingly.
The radio has a built-in rod antenna for MW reception. Turn the device
around to direct the antenna.

4 Find and tune the station using »TUNING«.

5 Use »TONE« to adjust the tone as required.

44

GRUNDIG Service

______________________________

GRUNDIG BELUX N.V.
Deltapark, Weihoek 3, Unit 3G

B-1930 Zaventem

+32/2-7 16 04 00
GRUNDIG UK LTD.

Elstree Way, Borehamwood,
Herts, WD6 1RX

GB Großbritannien/
Great Britain

+44/1 81-3 24 94 00
Technical Service

Unit 35, Woodside Park,
Wood Street
Rugby, Warwickshire, CV21 2NP

Großbritannien/
Great Britain

+44/1 78-8 57 00 88
GRUNDIG IRELAND LTD.

2 Waverley Office Park,
Old Naas Road

EIR Dublin 12

+3 53/1-4 50 97 17
GRUNDIG FRANCE S.A.

5 Boulevard Marcel Pourtout

F-92563 Rueil
Malmaison Cedex

+33/1-41 39 26 26

GRUNDIG SCHWEIZ AG
Steinacker Straße 28

CH-8302 Kloten

+41/1-8 15 81 11
GRUNDIG PORTUGUESA

Comércio de Artigos
Electrónicos, Lda.
Rua Bento de Jesus Caraça 17

P-1495 Cruz Quebrada,
Lisboa

+3 51/1-4 19 75 70
GRUNDIG ESPAÑA S.A.

Solsonés, 2 planta baja B3
Edificio Muntadas (Mas Blau)

E-08820 El Prat De
Llobregat (Barcelona)

+34/93-4 79 92 00
GRUNDIG NORGE A.S.

Glynitveien 25, Postboks 234

N-1401 Ski

+47/64 87 82 00
GRUNDIG DANMARK A/S

Lejrvej 19

DK-3500 Værløse

+45/44 48 68 22

GRUNDIG OY
Luoteisrinne 5

SF-02271 Espoo

+3 58/9-8 04 39 00
GRUNDIG SVENSKA AB

Albygatan 109 d, Box 4050

S-17104 Solna

+46/8-6 29 85 30
GRUNDIG POLSKA SP.Z.O.O.

Ul. Czéstochowska 140

PL-62800 Kalisz

+48/62-7 66 77 70
GRUNDIG AUSTRIA

Ges.m.b.H.
Breitenfurter Straße 43-45

A-1120 Wien

+43/1-81 11 70
GRUNDIG NEDERLAND B.V.

Gebouw Amstelveste
Joan Muyskenweg 22

NL-1096 CJ Amsterdam

+31/20-5 68 15 68
GRUNDIG ITALIANA S.P.A.

Via G.B. Trener, 8

I-38100 Trento

+39/4 61-89 31 11

GRUNDIG Deutschland

Ihre regionale Kundendienst-Stelle in Deutschland erreichen Sie unter:

Telefon [phone]* • Telefax 0180/5 23 18 46*

*gebührenpflichtig

GRUNDIG Kundenberatungszentrum

Haben Sie Fragen?
Unser Kundenberatungszentrum steht Ihnen werktags
stets von 8.00 – 19.00 Uhr zur Verfügung.
Haben Sie Fragen zur Umweltverträglichkeit unserer
Geräte, wenden Sie sich an die GRUNDIG Öko­Technologie,
Fax: [phone].

Grundig Kundenberatungszentrum

Montags bis Freitags
von 8.00 bis 19.00 Uhr
Deutschland: 0180 / 530 21 22*
Österreich: 0800 / 700 600*

*gebührenpflichtig

Grundig AG • Beuthener Str. 41 • D-90471 Nürnberg • http://www.grundig.com 72011 401 7500