HAIR AND BEARD
CLIPPER
MC 8641
_________________________________________________________
D
2
C
A
E
G
H I J
M
DEUTSCH
B
F
L
K
O
P
N
Q
_________________________________________________________
DEUTSCH 4 - 15
ENGLISH 16 - 25
ESPAÑOL 26 - 35
POLSKI 36 - 45
ČESKY 46 - 55
MAGYAR 56 - 65
TÜRKÇE 66 - 75
ΕΛΛΗΝΙΚA 76 - 85
DEUTSCH
3
3
SAFETY
_______________________________________________
Please note the following when
starting up the appliance:
7
This appliance is intended for
domestic use only.
7
To avoid damage and risks due
to improper use, please read the
instructions for use and store in a
safe place.
7
When the mains adapter is
connected, never use the
appliance in the bath, shower or
over a washbasin full of water
or with wet hands.
7
If the appliance is charged or
operated with the mains adapter,
always ensure it does not come
into contact with water or other
liswuids. Even the proximity of
water is a risk.
7
Always disconnect the mains
adapter after charging.
7
Protect the mains adapter from
water, especially dripping or
splashing water.
7
Do not charge the appliance in
the bathroom.
7
Make sure that the accessories
are properly attached to prevent
them falling into water.
7
Never fully immerse the appliance in water.
7
The appliance may only be
allowed to come into contact
with water if it is disconnected
from the mains adapter and
the mains adapter is no longer
plugged into the socket.
7
Do not let the appliance fall.
7
Keep the appliance out of reach
of children.
.
16
ENGLISH
SAFETY
_______________________________________________
7
The device may not be used by
the following people, including
children: those with limited
physical, sensory or mental
capabilities and also those with
a lack of experience and knowledge. This does not apply to the
latter if they were instructed in the
use of the device or if they use it
under the supervision of a person
responsible for safety. Children
should always be supervised to
ensure that they do not play with
the device.
7
If the power cord is damaged, it
must be replaced by the
manufacturer, its service centre or
a similarly qualified person to
prevent danger arising.
7
Never open up the appliance.
All rights to claim under the
guarantee are invalidated
for damage caused by improper
interventions
ENGLISH
17
AT A GLANCE
______________________________________
See the illustration on page 2.
Controls
A
Slide switch for switching on
and off, switches to two speed
settings.
B
Switch for adjusting
the comb attachment position
or removing the comb attachment, rear of the appliance.
C
Indicator for the comb
attachment positions,
rear of appliance.
D
Ceramic/stainless steel cutting
head (trimming width 40 mm).
E
LED indicator for charging.
F
Socket for docking into the
charging station or connecting
the mains adapter.
G
Charging station.
Accessories
H
Comb attachment 1 for shorter
hair lengths (up to 20 mm).
I
Comb attachment 2 for longer
hair lengths (from 24 mm to
40 mm).
J
Stainless steel cutting head for
trimming beards (trimming
width 25 mm).
K
Beard attachment trimming
lengths of 2 mm to 18 mm
L
Power supply unit.
M
Storage case.
N
Attachment for thinning out
hair.
O
Cleaning brush.
P
Oil.
Q
Comb.
18
ENGLISH
POWER SUPPLY
___________________________________
Runs on rechargeable
batteries
If run with the installed
rechargeable nickel metal hydride
batteries, use the supplied mains
adapter as a charger.
1 Insert the mains adapter cable
into the socket ; plug the
mains adapter plug into the
mains socket.
– The indicator lights up.
Note
7
Fully charge the batteries
(24 hours) before using for the
first time or if the batteries have
not been used for a long time.
7
After the batteries are first
charged, the charging time is
approx. 12 hours when the
appliance is switched off. If you
switch on the appliance while it is
charging, charging will stop.
7
The ambient temperature should
be between 5˚C and 40˚C.
F
E
7
When fully charged, the
appliance works for around
45 minutes. It is not advisable to
charge the batteries after every
use, especially if you do not use
the appliance for the full 30 minutes. Only charge the batteries
when they are completely discharged. This increases their life.
Do not charge them every day.
Charge at the charging
station
1 Push the appliance's socket
F
onto the charging station
connector.
2 Insert the cable of the mains
adapter into the socket of the
charging station.
3 Plug the mains adapter plug into
the mains socket.
ENGLISH
19
POWER SUPPLY
___________________________________
Mains operation
(with the mains adapter)
Check whether the mains voltage
given on the rating plate of the
mains adapter supplied matches
the local mains voltage.
The appliance is not disconnected
from the power supply until the
mains adapter is disconnected.
1 Insert the cable of the mains
adapter into the socket .
2 Plug the mains adapter plug into
the mains socket.
– The installed batteries are
switched off.
Important
7
If using the appliance in the
bathroom or next to a water
connection, use battery (cordless)
mode only and never use mains
mode.
F
Environmental
information
This product has been made from
high-quality materials and parts,
which are suitable for recycling and
can be reused.
Therefore, at the end of its life,
the product must not be disposed
of in the normal domestic waste but
must be taken to a collection point
for recycling electrical and electronic appliances. This is indicated
by the following symbol on the
product, in the instructions for use
or on the packaging.
Please contact your local authority
to find out where your local
collection points are.
Reusing and recycling old
appliances is an important
contribution to protecting our
environment
20
ENGLISH
___________________________________________________
USE
Special features
The appliance is equipped with a
ceramic/stainless steel blade.
Cut hair
1 Push on the comb attachment
I
or .
Important
7
Before attaching the comb
attachment, always switch off the
appliance first and if necessary
disconnect the mains adapter
cable.
2 To do this, push the side guide
grooves inside the comb
attachment onto the side guide
rails of the appliance until the
attachment latches into position.
3 Press down the switch and set
the required cutting length (from
1 to 7) (see the following tables).
Note the indicator for the
comb attachment positions.
B
C
4 Place a hand towel around the
neck and shoulders of the
person whose hair is to be cut.
Seat the person so that their
head is roughly at your eye
level. Before cutting, comb the
H
hair so that it falls loosely and
you can see the natural growth
direction.
5 Switch on the appliance using
the switch and start to cut the
A
hair.
6 If necessary, use the switch
to set the required speed setting
(1 or 2).
Note
7
Speed setting 2 is a switchable
turbo setting for more power for
thick and long hair.
7 After cutting the hair, switch
off the appliance at the switch
(setting 0).
8 Remove the comb attachment by
pressing the switch and
B
pulling off the comb attachment.
A
A
ENGLISH
21
___________________________________________________
USE
Cutting lengths of comb
attachment 1 ( )
Position 1
Position 2
Position 3
Position 4
Position 5
Position 6
Position 7
H
4 mm
7 mm
9 mm
12 mm
15 mm
17 mm
20 mm
Cutting lengths of comb
attachment 2 ( )
Position 1
Position 2
Position 3
Position 4
Position 5
Position 6
Position 7
Notes
7
If you use the appliance without
the comb attachment, the cutting
length is 1.5 mm.
7
The cutting lengths given are the
remaining hair lengths after
cutting. All the measurements
given here are approximate
values.
I
24 mm
27 mm
29 mm
32 mm
35 mm
37 mm
40 mm
Useful tips
7
Use the appliance with a relaxed
and comfortable grip.
7
Always cut against the natural
direction of hair growth.
7
Pause cutting at short intervals.
You can always make corrections
later, but you can't replace cut
hair.
7
When using for the first time,
cut small amounts of hair only.
This enables you to get used to
the adjustable cutting lengths.
7
Do not force the comb attachment
through the hair. Let it lead you.
7
Comb the hair repeatedly.
While combing, look for hair that
is too long and remove cut hair.
7
N
Use the attachment for thinning
out hair.
Insert it from above, as you did
for comb attachment 1, into the
side grooves until it catches.
22
ENGLISH
___________________________________________________
USE
Beard trimming
1 Press the button to switch off
the appliance (level 0).
2 Remove the hair comb by press-
ing the button and taking it
off.
3 Remove the cutting head for hair
and replace it with the cutting
head for the beard .
4 Put the beard comb on.
5 Slide the comb with the inner
side grooves onto the side guide
rails on the appliance.
6 Press the switch down and set
the cutting length (from 1 to 7)
(see the following table).
Observe the display for the
comb positions.
7 Switch on the appliance with the
A
beard.
A
B
J
K
B
C
button and start trimming the
8 If required, set the speed to level
2 with the button.
A
Note
7
Speed level 2 is a turbo level with
extra power for strong beard
hair.
Trimming lengths of the
beard comb ( )
Position 1
Position 2
Position 3
Position 4
Position 5
Position 6
Position 7
Notes
7
If you use the appliance without
the beard attachment, the cutting
length is 1.5 mm.
7
The trim lengths given here
describe the remaining hair
length. All the lengths here are
approximate.
K
2 mm
5 mm
7 mm
10 mm
13 mm
15 mm
18 mm
ENGLISH
23
CLEANING AND CARE
___________________________
Cleaning and care
1 Switch off the appliance and, if
using in mains mode, remove
the mains adapter plug from the
socket.
2 Remove the comb attachment
and clean the blade with the
supplied brush.
3 Clean the housing and comb
attachment with a soft cloth
moistened with water.
Important
7
Never hold the appliance,
cable or mains adapter in water
or any other liquid.
4 Before using again, ensure all
parts have been carefully dried
with a soft cloth.
5 Do not use cleaning agents.
6 Re-attach the comb attachment.
Notes
7
Remove any remaining hair after
each use.
7
Your appliance's comb
attachment does not usually need
oiling. If you want to retain the
original condition of the blade
for a long time, it is worthwhile
oiling the blade at regular
intervals using the oil supplied.
Storage
If you are not going to be using
the appliance for a lengthy time,
please store it carefully.
7
Ensure the appliance is switched
off and is completely dry.
7
Pack the parts in the original
packaging and store them in a
cool, dry place.
7
Ensure the appliance is kept out
of reach of children.
24
ENGLISH
INFORMATION
____________________________________
Guarantee
The guarantee does not include
the blade or defects, which have
an insignificant effect on the
appliance's value or fitness for use.
The guarantee is invalidated if the
appliance is damaged, opened or
improperly used.
Technical specifications
This product fulfils the
European Directives
2004/108/EG and
2006/95/EG.
Power supply
Rechargeable battery:
Nickel metal hydride 900 mA
Power supply unit:
100 – 240 V˜, 50/60 Hz
3.4 V DC 1000 mA
Weight (WEEE)
520 g
Ni-MH
Subject to technical and visual changes!
ENGLISH
25
Loading...