Grundig ESP-2000 Owners Manual

Functions

- Normal Time with PM Indicator

- 12/24 hour selectable

- Dual Alarm, Snooze, Sleep Timer Green LED Backlight display

- Month and Date Display

- Thermometer (32oF - 122-F)

- AM/FM Radio Receiver

Control Location

1. OCEAN button 11. 1-5/1-7/SLEEP button

2. RAIN button

3. STREAM button 13. SET button

4. HEART BEAT button 14. ON/OFF button

5. WOODLANDS button 15. Volume knob

6. Radio/Sound/Beep function slide switch 16. Tuning knob

12. ALARM / button

7. DIAL scale 17. FM/AM slide switch

8. SNOOZE button 18. DC jack

9. MODE button 19. Battery compartment

10. ALARM / button

20. LCD display

Replacing Battery

When the low battery symbol shows on the LCD display (20), open the Battery door (19)
at the bottom, replace the exhausted batteries with three new alkaline "AA" batteries.

Note: If theAC/DC adapter is connected to the DC jack, the batteries are used to maintain
clock function only. The batteries can operate the unit with full functions for only a few
hours. The unit should be operated with the included adapter.

Setting Normal Time
When power is on, the clock starts to enter the radio controlled clock mode. The LCD
display (20) initially shows:

- L: 0-5 receiving signal strength, 5 indicates signal level OK, 0-4 signal weak.

- 00-59: a count of seconds

- OFF: Alarm off mode

- The receiving tower symbol starts to blink. It indicates that the unit has entered the time
signal-receiving mode.

- If this unit is within the signal area: after receiving all signals successfully, the clock
shows the correct time and starts to work. The blinking receiving tower symbol becomes
steady. The time signal is transmitted four times a day to auto-adjust the clock.

-If this unit is out of the signal area: Press MODE button (9) once, the clock changes to
normal clock mode. To set the correct time, hold SET button (13) for two seconds to enter
set mode.

Year/Month/Date SETTING

- The LCD display (20) showing the year digits flashes, press UP (10) or DOWN (12)
button to set the year.

- Press MODE button (9) once to flash the month digits, then press UP (10) or DOWN (12)
button to set the month.

- Press MODE button (9) once again to flash the date digits, then press UP (1 0) or
DOWN (12) button to set the date.

- Press MODE button (9) once again to finish the setting or press SET button (13) once to
continue time setting.

Time Setting

- After entering set mode, press SET button (1 3) once to flash the hour digits, then press
UP (1 0) or DOWN (1 2) button to set the hour.

- Press MODE button (9) once to flash the minute digits, then press UP (10) or DOWN
(12) button to set the minute.

- Press MODE button (9) once again to finish the time setting or press SET button (1 3) to
continue alarm time setting.

Setting Alarm Time
(Remark: please make sure the 'e' ONIOFF switch is in 'OFF' position to set alarm time or
operate the alarm function)
To set alarm time:
Hold SET button(13) for two seconds to enter set mode, press SET button (1 3) twice to
show the symbol and flash the alarm hour digits, then press UP
(10) or DOWN (12) button to set alarm l hour.