Grizzly G4223 User Manual

Figure 2.

Figure 3.

Figure 1.

G4223 Instructions

1. Attach sides and the bottom panel (panel

with the 1'' hole in it) to the cover as

shown in figure 1 using the sheet metal

screws supplied. Do not tighten down the screws yet.

2. Insert the rubber grommet into the 1'' dia

hole in the bottom of the cover.

3. Attach the top panel as shown in Figure 2 and tighten down all the screws.

4. Center the cover over the opening in the

cabinet and mark holes for drilling.

Figure 3. NOTE: If you have a saw with

the switch mounted to the cabinet, make sure the flange of the cover clears the switch mounting screw holes.

5. Using a 1/8'' drill bit, drill the six holes for

the #8 x

/2'' self tapping screws that

attach the cover to the cabinet.

6. If you have a cabinet mounted switch,

unplug the saw, remove the old motor wire and replace it with 3 feet of 10-12 AWG wire. Re-route the new motor wire through the hole in the bottom of the cover.

7. Mount the cover using the six #8 x

/2'' self

tapping screws supplied.