Grizzly G1794, G1026, G1705, G1035 User Manual

Figure 3. Inserting Router Bit Spindle.

Figure 1. Router Bit Spindle.

Figure 2. Draw Bar & Nut.

G1705 & G1794 Router Bit Spindle

For The G1035 & G1026 Shapers

To install the router bit spindle, proceed as follows:

1. Remove existing spindle from the shaper by holding the top of the spindle with a wrench and remove the tie rod nut from the bottom of the spindle housing. Figure 2. Pull the spindle out of

the spindle cartridge. Notice that the bottom portion of the spindle is identical to the bottom portion of the router bit spindle.

4. Place a router bit into the router bit spindle and

tighten the collet nut.

Caution: Do not run the router bit spindle in reverse

direction (clockwise if you look down on the spidle).This can cause the collet nut to loosen, allowing the router bit to come out.

2. Unthread the tie rod from

the spindle and completely thread into the bottom of the router bit spindle.

3. Place the router bit spindle

into the spindle housing and line up the pin with the key-

way. Figure 3. Tighten the

tie rod nut to secure. Use a back-up wrench on the router bit spindle while tightening the tie rod nut.

Collet Nut

Spindle Cartridge

Spindle Housing

Router Bit Spindle

Tie Rod

Tie Rod Nut

⁄2'' TO 1⁄4'' Adapter

Keyway