Grindmaster Espressimo 625, Espressimo 650 Instruction Manual

600 Series Espressimo

™

Series

Espresso Coffee Grinders

Instruction Manual for Models 625 and 650

Grindmaster® Coffee Grinders and Brewers • Espressimo® Espresso Machines • Crathco® Hot Beverage Dispensers

Crathco® Cold and Frozen Beverage Dispensers • American Metal Ware® Coffee and Tea Systems

Tel [phone] • Fax [phone] • Toll-Free 1-800-695-4500

P. O. Box 35020 • Louisville, KY 40232 • USA

www.grindmaster.com • email: [e-mail]

©Grindmaster Corporation, 1995
Printed in USA 0804 Form# ES-365-04

Model 625

Model 650

600 SERIES ESPRESSO GRINDERS

INSTRUCTION MANUAL

WARNING - UNPLUG GRINDER FROM
OUTLET BEFORE SERVICING OR
ADJUSTING

1) Bean Hopper Lid

2) Bean Hopper

3) Grind Adjustment Dial

4) Dosing Chamber

5) Dosing Lever

6) Filter Holder Guide

7) On/Off Switch

INSTALLATION

1. Place bean hopper on grinder base

2. Press grind adjustment tab down

3. Turn grind adjustment dial clockwise until grinding burrs touch

4. Turn dial back counterclockwise five notches

5. The grinder should now be set to the correct grind (slight adjustment may
be necessary)

6. Place whole bean coffee in hopper

7. Plug grinder into grounded outlet

8. Turn power switch on

9. Open bean hopper shutoff by pulling out bean hopper shutter

10. If grinder does not start grinding, grind may need to be adjusted to a coarser
setting by turning the adjustment dial counterclockwise

HOW TO OPERATE

1. Remove bean hopper lid

2. Fill bean hopper with whole bean coffee

3. Turn the grinder “on” to fill the doser with ground coffee
For the Model 625, turn the grinder “off” when the doser is filled
For the Model 650, leave the switch in the “on” position — The grinder will
automatically turn on and refill the dosing chamber when the sensing switch
senses it is low

4. Place the filter holder under the doser outlet until it rests at the filter stop

1

2

4

5

6

7

3

5. Pull the dosing lever once for a single serving or twice for a double serving

NOTE: The coffee in the dosing chamber must cover the portioning dividers in
order to accurately dispense a portion

6. Lightly tamp and level the grounds with even pressure as needed

7. Wipe or brush away any excess grounds on the rim of the filter holder

8. You are now ready to load the filter holder into the espresso
machine and start the
brewing process

TO ADJUST THE PORTION (DOSER)

The amount of coffee dispensed from the doser
may be adjusted as follows:

1. Remove the doser lid

2. Locate the knob in the center of the dosing chamber

3. To decrease the portion size turn the knob clockwise

4. To increase the portion size turn the knob counterclockwise

NOTE: You will feel/hear the knob click at each setting. When increasing the setting
take care not to turn the knob too far. When clicking stops, turn clockwise until you
reach the first click. This setting is the maximum dosage.

TO ADJUST THE GRIND

1. Locate the grind adjustment dial

2. Press down grind adjustment tab

3. To adjust to a finer grind turn the dial clockwise

NOTE: If dial stops, the grinding burrs are touching. Turn dial back a minimum
of two notches. The approximate range for espresso grind should be 4-6 notches
back after the burrs are touching.

4. To adjust to a coarser grind, turn the dial counterclockwise

NOTE: The precision burrs are very sensitive to adjustments; therefore, a slight
adjustment is all that may be needed. Only adjust one notch at a time.

Knob

TROUBLE SHOOTING GUIDE

IF YOU STILL NEED HELP, CALL OUR SERVICE DEPARTMENT (1-800-695-4500)
OR AN AUTHORIZED SERVICE CENTER IN YOUR AREA. PLEASE HAVE THE MODEL
AND SERIAL NUMBER READY SO ACCURATE INFORMATION CAN BE GIVEN.

PROBLEM

Grinder will not start.

Motor runs but no coffee is
ground.

Motor hums but no coffee
comes out.

Metal scraping sound from
grinder.

PROBABLE CAUSE

Not plugged in.

Automatic reset has
tripped.

Bean shutoff is closed.

Beans placed in dispenser,
not hopper.

Coffee jammed in burrs.

Foreign object in burrs.

Burrs touching each other.

REMEDY

Plug grinder in outlet.

Turn grinder off and wait
five minutes.

Open bean shutoff.

Remove beans from
dispenser and place in
hopper.

Turn grinder off. Coarsen
grind adjustment and try
again.

Unplug grinder, close bean
shutoff and remove hopper.
Unscrew grind adjustment
dial and remove foreign
object.

Turn off grinder. Coarsen
grind adjustment.