Grand Hall Freedom 445 Owner's Manual
Operating and assembly instructions
• Drain hose included
• Tap connection and hose not
included
Tap inlet suitable for 3/4" BSP snap-on hose adaptor
These instructions are a
guide to assembling and
using the Freedom 440
Sink / Workstation.
Please read carefully, and
retain for future reference
Illustration may vary from unit
contained in carton.
.
2
GENERAL INFORMATION
2
TABLE OF CONTENTS
General Information 2
Pre-Assembly 2
Assembly 3-6
Assembly – General 7-8
Maintenance 9
Parts Diagram / List 10-11
PRE-ASSEMBLY
GENERAL
FOR CUSTOMER REFERENCE
(Record and file in a safe place)
Purchased from
Date purchased
Serial No.
Sales docket must be kept as proof of purchase date.
NOTE:
TOOLS YOU WILL NEED
While it is possible for one person to assemble the
Workstation, we recommend asking for the assistance
Sink /
of another
person when manoeuvring some of the larger and heavier pieces.
ASSEMBLY TIPS
1. Flatten cardboard packaging and use this as a protective
work surface to assemble upon.
2. Some protective coating may need to be removed from
components prior to assembly.
3. Unless specified otherwise, do not tighten screws and nuts
until trolley is fully assembled.
4. Pre-screwing of connection points for securing the side
shelves will assist in securing shelves smoothly.
CHECK FOR ANY DAMAGE
Before attempting to assemble this appliance, check that all the
necessary parts have been included using the parts list opposite.
Inspect parts as you proceed.
Contact your place of purchase for assistance regarding
replacement of any damaged or missing parts. Supplier contact
details are on the back cover of the instruction manual.
Do not assemble or operate an appliance that appears
damaged.
Standard Phillips-head screwdriver.
Adjustable spanner
(open end shifter).
CARTON CONTENTS
Description Qty
Trolley side panel – right 1
Trolley side panel – left 1
Trolley rear panel 1
Castors 4
Bottom shelf 1
Trolley bracket – front 1
Doors 1
Sink / Workstation body assembly 1
Cutting board 1
Tap – with hose adaptor 1
Drain assembly – factory fitted to sink 1
Drain hose 1
Lid – sink 2
Hardware pack 1
3
LEFT
SIDE
RIGHT
SIDE
INSTALL CASTORS
• Place the trolley bottom shelf on the cardboard work surface
with the bottom side of shelf facing up. Install the four (4)
castors onto the castor seats as shown.
Phillips flat-head screw 1/4" x 1/2"
Qty: 16
ASSEMBLY
3
INSTALL TROLLEY LEGS WITH SIDE PANELS
• Install the left and right trolley legs with side panel (parts
are labelled ‘L’ or ‘R’)
Phillips flat-head screw
Qty: 8
to trolley bottom shelf.
1
/4" x 2"
4
INSTALL TROLLEY REAR PANEL
Phillips flat-head screw 1/4" x 1/2"
Qty: 4
ASSEMBLY
4
INSTALL TROLLEY BRACKET
• Install the trolley bracket in the up position (part is labelled
‘UP’ to ensure proper assembly)
between front trolley legs
as shown.
Phillips flat-head screw
Qty: 4
1
/4" x 2"
Loading...