Graco Nursery Monitor User Manual
Family Listen 'n Talk Plus™ Monitor
Owner’s Manual • Please save for future use.
Family Listen 'n Talk Plus™ Moniteur
Manuel d’utilisateur
Veuiller garder pour usage ultérieur.
Monitor Family Listen 'n Talk Plus™
Manual del propietario
Por favor, conservélo para utilizarlo en el futuro.
2780
Model • Modèle • Modelo: _____________________ Serial No. • No. de Série • N° de Serie:_______________________
Dear Customer,
Please fill in the model and
serial numbers above from
the label inside the battery
compartment of your new
nursery monitor.
Graco is the recognized
leader in the design and
manufacture of quality baby
products. We believe your
new Graco nursery monitor
is a wise choice.
Before using your nursery
monitor, please take a few
minutes to read this Owner’s
Manual. The short time
you spend reading these
instructions will help you use
your nursery monitor properly.
Cher client,
Veuillez inscrire ci-haut les
numéros de modèle et de
série que vous trouverez
sur l’étiquette à l’intérieur
du compartiment de la pile
de votre moniteur.
Graco est le chef de file
dans la conception et la
fabrication de produits de
qualité pour bébé. Nous
croyons que le moniteur
de nursery de Graco est
un choix judicieux.
Avant d’utiliser votre moniteur
de nursery, prenez quelques
minutes pour lire le manuel
d’utilisateur. Ce court instant
que vous prendrez à lire les
instructions vous aidera à
utiliser correctement votre
moniteur de nursery.
Estimado cliente,
Complete los números de
modelo y de serie arriba
indicados de la etiqueta dentro
del compartimiento de pilas de
su nuevo monitor de bebés.
Graco es el líder reconocido
en el diseño y fabricación de
productos infantiles de calidad.
Creemos que su nuevo
monitor de bebés Graco es
una buena selección.
Antes de usar su nuevo
monitor de bebés, tome unos
minutos para leer este manual
del propietario. Los pocos
minutos que tome leyendo
estas instrucciones le
ayudarán a usar su monitor
de bebés correctamente.
© 2002 Graco 906-2-02
Product Features
Caractéristiques
du produit
Características
del producto
A
B
ON/OFF/Volume
C
Power Light/Low
Battery Indicator
D
AC Adapter Jack
E
Push to Talk
Parent “A”
F
Button
Push to Talk
G
Baby “B” Button
Channel
H
Selector*
Antenne AntenaAntenna
Interrupteur
marche/arrêt et
contrôle de volume
Voyant lumineux/
Indicateur de pile faible
SoundLights™ SoundLights™SoundLights™
Prise pour
adaptateur CA
Bouton “A” appuyer
pour parler-parent
Bouton “B” appuyer
pour parler-bébé
Sélecteur de fréquence* Selector de canal*
Encendido/Apagado/
Volumen
Luz de encendido/
Indicador de baja
potencia de pila
Enchufe adaptador
VCA
Botón “A” de
comunicación con
los padres
Botón “B” de
comunicación
con el bebé
*The Parent Units and the Nursery Unit MUST be set to the same channel. If receiver detects
sounds from another nursery monitor or cordless phone, set units to the other channel.
If problem persists, contact Graco.
*Les unités des parents et celui de la nursery DOIVENT être réglés à la même fréquence. Si
le récepteur détecte des sons d'un autre moniteur de nursery ou de téléphones sans fil,
placez les unités à une autre fréquence. Si le problème persiste, contactez Graco.
*Tanto la unidades de los padres como la unidad del bebé DEBE sintonizarse al mismo canal.
Si el receptor detecta sonidos de otro monitor de bebés o un teléfono inalámbrico, sintonice
ambas unidades al otro canal. Si el problema persiste, póngase en contacto con Graco.
FCC ID M6Y 001020900Tand M6Y001020900R
906-2-02
2
Nursery Unit
A
Unité de la nursery
Unidad del bebé
B
H
Parent’s Unit (2)
Unité des parents (2)
Unidad de los padres (2)
E
C
AC Adapter (3)
Adaptateur CA (3)
Adaptador VCA (3)
A
F
G
B
H
D
C
E
3
906-2-02 906-2-02
Questions?
Des questions?
¿Preguntas?
In the U.S.A. or Canada,
please contact our Customer
Service Department with any
questions you may have
concerning parts, use, or
maintenance. When you
contact us, please have your
product’s model and serial
numbers ready so that we
may help you efficiently.
Telephone us at:
Téléphonez-nous au:
Llámenos al:
USA: 1-800-345-4109
Canada: 1-800-667-8184
Montreal: 514-344-3533
Aux Etats-Unis ou au Canada,
veuillez contacter notre
département du service
à la clientèle avec des
questions que vous pourriez
avoir concernant les pièces,
l’utilisation ou l’entretien.
Lorsque vous nous contactez,
soyez prêt à fournir les
numéros de modèle et de
série afin que nous puissions
vous aider plus rapidement.
or visit our website,
ou visitez notre website,
o visite nuestro sitio Web,
USA: www.gracobaby.com
Canada: www.graco.net
En los EE.UU. y Canadá,
por favor contacte a nuestro
Departamento de Servicio
al Cliente con cualquier
pregunta que pueda tener
sobre las piezas, uso o
mantenimiento. Cuando
nos contacte, por favor
tenga el número del
modelo y número de serie
listos para que podamos
ayudarlo mejor.
or write to us at:
sinon, écrivez-nous à:
o escribanos a:
USA:
Graco Children’s Products
Customer Service Department
P.O. Box 100, Main Street
Elverson, PA19520
Canada: distributed by
Elfe
4580 Hickmore
St. Laurent, Quebec H4T 1K2
4
Failure to follow these warnings and the assembly
instructions could result in serious injury or death.
This device is designed only to monitor the sounds of your child. It will not alert you to your
child’s silent activities. This product is not designed or intended for use as a medical monitor.
Always be sure that both the transmitter and receiver are working properly and are within range
of each other.
•
STRANGULATIONHAZARD. Keep the adapter cords out of the reach of children. Do not use
with extension cords.
•
DO NOT place the Nursery Unit or its cord within your child’s reach. Do not put the Nursery
Monitor inside a crib or playard.
•
USE ONLY WITH 110-120 VOLT AC ELECTRICALOUTLETS.
•
PROTECT THE AC ADAPTER CORDS. Place them so they are not walked on or pinched by
furniture or other items.
•
ALLOW FOR PROPER VENTILATION WHEN UNITS ARE IN USE. Do not cover the Nursery
Unit or Parent Units with any object such as a blanket. Do not place it in a drawer or in any location
which would muffle the sound or interfere with the normal flow of air.
•
DO NOT immerse any part of the Nursery Monitor in water. Clean only with a dry cloth.
•
DO NOT place unit near water and moisture. Do not use the Nursery Unit outdoors. Do not use
the monitor near possible wet areas, such as a bathtub, shower, wash basin, sink, laundry tub,
swimming pool, wet basement, etc.
•
KEEP NURSERY MONITOR AWAY FROM HEAT SOURCES, such as fireplaces, radiators,
stoves, and TVs or other appliances. Heat can damage the case or electrical parts.
•
DO NOT use the monitor if:
•
The adapter cords or plugs have been damaged.
•
The unit has been exposed to liquids.
•
Unit has been dropped or is damaged.
•
DO NOT OPEN THE TRANSMITTER, RECEIVER OR ADAPTER. No user-serviceable parts
inside. Risk of electrical shock, fire or death.
5
906-2-02 906-2-02
System Setup
Installing a Battery
The Parent Units can be operated on 9 volt battery power. An alkaline battery is
recommended. Battery changing should only be done by an adult.
1 2
Battery Use Tips
• Remove battery from Parent’s Unit if it will not be used for a long time.
• Remove a dead battery promptly. Adead battery left in unit may leak, damaging your unit.
• Do not attempt to recharge a non-rechargeable battery.
• Arechargeable battery CANNOT be recharged by plugging AC adapter into the Parent’s Unit.
Remove the battery from unit to recharge it.
• Charging of a rechargeable battery should only be done by an adult.
• Battery power will be conserved when Parent’s Unit is powered through AC adapter. It is not
necessary to remove battery when using AC adapter.
• Change battery if:
• Signal reception becomes poor.
• Static noise develops (also check for appliance interference).
• Green power light blinks continuously and sound is muted.
906-2-02
6
Using AC Adapters
• The Parent Units can use either a 9 volt battery or standard 120 volt AC household current.
The Nursery Unit uses standard 120 volt AC household current only. The included AC
adapters must be used for this purpose.
• To use AC adapters, plug the connector on the cord into the AC adapter jack on the side of
the unit. Then plug adapter into a standard wall outlet.
• Use ONLYthe Graco adapters included with the unit. Do not use these adapters with
other equipment under any circumstances.
• If units do not work, check that AC adapters are plugged into working outlets.
• When electricity is off (from a power failure, etc.), the transmitter will NOT work, since it only
operates on AC current.
• If the power light is blinking, turn the unit off and back on.
Selecting Channels
• Check that both Nursery Unit and Parent ’s Unit are set to the same channel.
• To change channel, slide Channel button to either Aor B on BOTH units.
Low Battery Indication
• When battery is low in the parent unit the green power light will blink continuously and the
speaker volume will be muted automatically.
• You may either turn off the unit and replace the battery or plug in the A/C adapter.
• When the unit is turned back on the green power light will stay on and the volume will
return to normal.
7
906-2-02
Setting Up the Baby Monitor
1. Check that Nursery Unit and Parent Units are set to the same channel.
2. Place the Nursery Unit within 10 feet (2-3 meters) of your baby. Plug an AC adapter into the
jack on the side of the Nursery Unit. Plug it into a working 120 volt AC outlet.
3. Aim the Nursery Unit toward your baby. Check that there are no walls or large objects that
could block sound transmission.
4. Turn on the Nursery Unit using the ON/OFF switch. The green power light should come on.
5. Install 9 volt batteries into the Parent Units, or plug them into a working 120 volt AC outlet
using the other two AC adapters.
6. Turn on the Parent Units using the volume control dial. The green power light will come on.
Testing the System
It is VERY IMPORTANTto test the system when first set up, and at regular times thereafter.
Test the units any time they may have been damaged or have not been used for a long time.
1. If two adults are present, have one take the Parent Units to different locations, trying various
volume settings, while the other speaks into the Nursery Unit.
2. If only one adult is available, place a ticking clock, radio, or other sound-producing device
near the Nursery Unit to test it.
3. When testing, keep the level of your child’s sounds in mind, and adjust the
volume accordingly.
4. If there is sound interference, switch the Nursery Unit and the Parent Units to the other
channel setting (page 7).
NOTE: As with all radio frequency devices, transmission range and reception may vary. Your Nursery
Monitor uses public airwaves, so it is possible for conversations near the Nursery Unit to be broadcast to
other nursery monitors, radios, cordless phones or scanners outside your home. For your privacy,
always turn off the Nursery Unit when not in use.
This monitor operates on one or more of the following frequencies: 925.7-927.5 Mhz and
902.5-904.3 Mhz.
906-2-02
8
Operation
To Listen To Baby
• Turn on Nursery Unit using the Volume ON/OFF switch.
• Turn on one or both Parent Units using the Volume ON/OFF switch.
To Speak to Baby
• Turn on Nursery Unit using the Volume ON/OFF switch.
• Turn on one or both Parent Units using the Volume ON/OFF switch.
• On one Parent’s Unit, press and hold the Push-To-Talk-Baby “B” Button. Parent’s Unit is
ready to transmit when green power light blinks once. (If green light does not blink, you will
not transmit to Nursery Unit. Refer to Solving Problems on page 10.)
• Speak into Parent’s Unit holding unit 12”-24” from your mouth. Holding unit closer will cause
the sound to be distorted.
• Release button when finished speaking.
NOTE: When one Parent’s Unit is transmitting to the Nursery Monitor, neither Parent Unit will
receive from the Nursery Unit. The Parent’s Unit NOT transmitting to the baby will not receive
the Parent’s Unit transmitting to the baby.
To Speak to Parent
• Turn on Nursery Unit using the Volume ON/OFF switch.
• Turn on one or both Parent Units using the Volume ON/OFF switch.
• On one Parent’s Unit, press and hold the Push-To-Talk-Parent “A” Button. Parent’s Unit is
ready to transmit when green power light blinks once. (If green light does not blink, you will
not transmit to Parent’s Unit. Refer to Solving Problems on page 10.)
• Speak into Parent’s Unit holding unit 12”-24” from your mouth. Holding unit closer will cause
the sound to be distorted.
• Release button when finished speaking.
NOTE: When one Parent’s Unit is transmitting to the other Parent’s Unit, neither unit will
receive the Nursery Unit. The receiving Parent’s Unit will not be able to transmit to the Nursery
Unit or the other Parent’s Unit.
9
906-2-02
Loading...