Graco Nautilus 65, NAUTILUS 65 LX Instruction Manual

Download

Do not install or use

this child restraint until

you read and understand

the instructions in this

manual.

FAILURE TO PROPERLY

USE THIS CHILD

RESTRAINT INCREASES

THE RISK OF SERIOUS

INJURY OR DEATH IN A

SUDDEN STOP OR CRASH.

NAUTILUS 65/NAUTILUS 65

CHILD RESTRAINT/BOOSTER SEAT

www.gracobaby.com

PD310058C 9/15

FEATURING

1-A Quick Guide to Your Manual 1-B Welcome to the Graco Family 1-C Height and Weight Guidelines 1-D Before You Begin

If You Need Help Certification Car Seat’s Useful Life Vehicle Seat Protection Warm Weather Use

1-E Safety Warnings

1 Important Pages 6-25

2 Features Pages 26-31

3-A Forward-Facing Use 3-B Install Forward-Facing with LATCH Straps 3-C Install Forward-Facing with the Vehicle Seat Belt

3 Forward-Facing Pages 32-43

4-A Booster Use 4-B Install Backed Booster 4-C Install Backless Booster

4 Booster Pages 44-57

6 Accessories Page 75

5-A Securing Child 5-Point Harness 5-B Securing Child Backed Booster 5-C Securing Child Backless Booster

5 Securing Child Pages 58-74

7-A How to Remove LATCH and Top Tether 7-B Choosing Vehicle Seat Location 7-C Unsafe Vehicle Seat Location 7-D Vehicle Seat Belts

8-A Cleaning Seat Pad 8-B Cleaning Buckle Strap 8-C Cleaning Harness and LATCH Straps

7 Vehicle Information Pages 76-86

8 Care & Cleaning Pages 87-90

1-A Quick Guide to Your Manual

This car seat is for children: Forward-Facing: 22-65 lb (10-30 kg)

Booster: 30-100 lb (14-45 kg)

Car Seat Assembly (On Select Models)

(Follow the directions that matches your model)

Attach Head Support

Squeeze height adjust button and push head support into slots on the back support as shown. Head support will click into the back support.

You may need to unfasten the hook and loop attachment tape on both sides at the top of the back support to allow for easier access to the slots.

Always use child restraint with head support installed and properly adjusted.

Click!

Adult Assembly Required

1. Raise Seat Back

Grab seat pad fabric in sitting area to expose the gutters.

Make Sure all hands, fingers and other objects are clear of the gutters.

Make Sure the harness straps are securely attached within the “T”-shaped slots around the arms as shown.

With your other hand, raise seat back so that both arms LOCK into the gutters. Arms should CLICK into the gutters. Seat assembly should appear as shown.

Harness Strap

T-Slot

Arm

Click!

Car Seat Assembly (On Select Models)

(Follow the directions that matches your model)

2. Attach Seat Pad Side Loops

Pull elastic loop on the seat pad through the vehicle belt guide on side of seat and attach to hook as shown. Repeat on other side.

3. Remove Zip Ties

From the bottom of the seat, cut the zip ties off. Remove the zip ties and card board.

4. Assembly Complete

Review section 2-A to see all of the features of this car seat.

The best seating location for this car seat is one that:

• Is recommended by your vehicle owner’s manual, and

• Results in a secure installation of this car seat. Some vehicles have specific requirements for where the car seat can be

installed, so be sure to check your vehicle owner’s manual for available seating positions, if any. For example, sometimes the center rear seat has a lap belt only vehicle seat belt, which cannot be used when this car seat is in Booster mode.

Review section 7-B, 7-C of this manual AND your vehicle owner’s manual.

Get to Know Your Car Seat

What Seating Location Should I Use?

Review section 2-A to see all of the features of this car seat.

The best seating location for this car seat is one that:

• Is recommended by your vehicle owner’s manual, and

• Results in a secure installation of this car seat. Some vehicles have specific requirements for where the car seat can be

Review section 7-B, 7-C of this manual AND your vehicle owner’s manual.

Which Installation Method Should I Use?

This car seat can be installed in your vehicle using either the vehicle seat belt OR the LATCH system. Both are equally safe to use. DO NOT USE BOTH AT THE SAME TIME.

Vehicle Seat Belt: Review section 7 and your vehicle owner’s manual to learn how to install your car seat with the vehicle seat belts.

LATCH: The LATCH system allows you to securely attach your safety seat in your car without using the vehicle seat belt and possibly to get a better fit. All 2003 and newer model year vehicles are required to have a LATCH system, although some manufacturers began including LATCH earlier. Some vehicle owner manuals use the term ISOFIX to identify the LATCH system.

According to accident statistics, the safest place for your child in any vehicle is the back seat. The center of the back seat can be the safest during a possible side impact.

LATCH consists of lower anchors and top tether anchors, which are builtin to your vehicle, and connecting hooks that are built-in to your car seat. Lower anchors are used INSTEAD of the vehicle’s seat belt to secure the child seat to the vehicle. Top tethers are used IN ADDITION to the lower anchors OR the vehicle’s seat belt to secure a forward-facing car seat to the vehicle.

Review your vehicle’s owner manual for exact location and use.

What is LATCH?

Vehicle Top Tether

Anchor Points

Vehicle Lower Anchor Points

Typical seat in a passenger

vehicle. Other vehicle types

may have different LATCH

locations.

Vehicle Seat Bight

continue next page

When Installing Forward-Facing

Vehicle Seat Belt

There are two types of vehicle seat belts that can be used. Lap/Shoulder Seat Belt or Lap Only Seat Belt.

Review section 3-C of this manual AND your vehicle owner’s manual.

LATCH System

LATCH consists of lower anchors, which are built-in to your vehicle, and connecting hooks that are built-in your car seat.

Review section 3-B of this manual AND your vehicle owner’s manual.

Vehicle Seat Belt

Only use the Lap/Shoulder seat belt configuration.

Review section 3-B, 3-C of this manual AND your vehicle owner’s manual.

When Installing As a Booster

Does Your Car Seat Fit Your Child Correctly?

To make sure your child is secured properly, review section 3 and 4 to understand all of the actions you need to take to properly adjust the car seat to fit your child.

Harness Height, Forward-Facing (A)

Harness straps at or just above the child’s shoulders and top of child’s ears below top of headrest (B). Review section 6.

Buckle Position (C)

The correct slot is the one that is closest to your child without being underneath them. Review section 6.

Harness Tightness (D)

If your fingers slide off the harness straps without pinching the straps, it is tight enough. Review section 6.

For Forward-Facing, You Need to Adjust:

continue next page

Use Lap/Shoulder Belt Only

Position Lap Belt

Lap belt must go behind armrest and lie low across your child’s hips and thighs.

Position Shoulder Belt

Shoulder best lies across shoulder between neck and edge of shoulder.

For Booster, You Need to Adjust:

Use the top tether strap when using forward-facing (A)

When used properly, the top tether helps reduce injury in a sudden stop or crash. Review section 4

Car Seat Does Not Move More than 1” (2.5 cm) at the Belt Path (B)

Review section 4

Harness Straps at or Just Above Child’s Shoulders (C)

Review section 5

Chest Clip Even With Armpits (D)

Review section 5

Cannot Pinch Harness Straps at the Shoulder (E)

Review section 5

Forward-Facing Installation

D E

Never Use Lap Belt Only

Review section 5

Lap Belt Behind Armrest and Lies Low Across Hips and Thighs

Review section 5

Shoulder Belt Lies On the Shoulder, Between the Neck and Edge of Shoulders

Review section 5

Booster Installation

1-B Welcome to the Graco Family!

Your child’s safety depends on you. No car seat can guarantee protection from injury in every situation, but proper use helps reduce the risk of serious injury or death. Even if this car seat seems easy to figure out on your own, you must follow the detailed instructions in this instruction manual to ensure the steps below are performed correctly.

continue next page

22 lb (10 kg)

30 lb (14 kg)

40 lb (18.1 kg)

65 lb (30 kg)

100 lb (45 kg)

Forward-Facing with 5-Point Harness 22-30 lb (10-14 kg) and can sit upright unassisted MUST be forward facing. 30-65 lb (14-30 kg) SHOULD be forward-facing.

High Back Booster Mode with Vehicle Lap/Shoulder Seat Belt 30-65 lb (14-30 kg) CAN be in high back booster mode. Over 65 lb (30 kg) MUST be in booster mode.

Backless Booster Mode with Vehicle Lap/ Shoulder Seat Belt 40-65 lb (18.1-30 kg) CAN

be in booster mode. Over 65 lb (30 kg) MUST be in booster mode.

1-C Height and Weight Guidelines

1-D Before You Begin

Please fill out the prepaid registration postcard attached to the harness and mail it in today or register online at www.gracobaby.com/ carseatregistration.

Child restraints could be recalled for safety reasons. You must register this restraint to be reached in a recall. Send your name, address, and the restraint’s model number and manufacturing date to:

Graco Children’s Products, Inc.

Attn: Customer Service

P.O. Box 169, Elverson, PA 19520-9901

or register online at www.gracobaby.com/carseatregistration

or call 1-800-345-4109

For recall information, call the U.S. Government’s Vehicle Safety Hotline at

1-888-327-4236

(TTY: 1–800–424–9153), or go to http://www.NHTSA.gov.

Model Name _________________________ Model Number _______________________ Date of Manufacture __________________ Date of Purchase _____________________

For future reference or if you change addresses, record the model name, model number, date of manufacture and purchase date of this car seat on the below. You can find this information either on the registration card if you still have it or on the date label located on the back of the car seat.

In the U.S.A, please contact our Customer Service Department with any questions you may have concerning parts, use, or maintenance. When you contact us, please have your product’s model number and date of manufacture ready so that we may help you efficiently. These numbers can be found on a sticker on the back side of your car seat. For additional resources or to get your car seat checked by a child passenger safety technician, please visit the following web sites:

www.nhtsa.gov • www.seatcheck.org • www.safekids.org

If You Need Help

STOP using this car seat and throw it away 10 years after the date of manufacture. Look for date of manufacture label on back of the car seat.

Graco Children’s Products Inc. advises against loaning or passing along a car seat unless you know the complete history of the product. We also advise against purchasing a car seat second hand.

This child restraint meets or exceeds all applicable requirements of Federal Motor Vehicle Safety Standard 213 for use in motor vehicles.

This child restraint is certified for use in aircraft only when used with the internal harness system. Use only forward-facing aircraft seats. Follow the instructions for vehicle installation. See section 3-C.

This child restraint is NOT certified for use in aircraft when used as a booster seat because aircrafts do not have shoulder belts.

Contact the airline for their specific polices.

Certification

Car Seat’s Useful Life

Protect vehicle seat. Use a car seat mat, towel, or thin blanket under and behind car seat.

Vehicle Seat Protection

Car seat parts can get very hot in the sun or warm weather. To avoid burns, always check before putting child in car seat.

Warm Weather Use

continue next page

Failure to follow these instructions and child restraint’s labels can result in child striking the vehicle’s interior during a sudden stop or crash.

1-E Safety Warnings

No car seat can guarantee protection from injury in every situation, but proper use helps reduce the risk of serious injury or death. READ THIS MANUAL

CAREFULLY.

! Review your vehicle owner’s manual for more

information about air bags and car seat use.

! If your vehicle does not have a back seat, review your

vehicle owner’s manual.

! Select a suitable location for the car seat in your vehicle. ! Secure car seat with a vehicle seat belt or LATCH that

is properly routed as shown in this manual.

! Vehicle seat belt system MUST hold car seat securely.

Not all vehicle seat belts can be used with a car seat.

! If vehicle seat belt does not hold car seat securely,

read “Vehicle Seat Belts” section 7-D and your vehicle

owner’s manual.

! Always secure car seat with LATCH or a vehicle seat

belt, even when unoccupied. In a crash, an unsecured

car seat can injure passengers.

! If car seat is in a crash, it must be replaced. DO NOT

use it again! A crash can cause unseen damage and

using it again could result in serious injury or death.

! DO NOT use car seat if it is damaged or missing parts. ! DO NOT use accessories or parts other than those

provided by Graco. Their use could alter the performance of the car seat.

! DO NOT remove LATCH system from car seat. If using

vehicle seat belt to secure car seat, LATCH hooks must be stored.

! Never leave child unattended, even when sleeping.

Child may become tangled in harness straps and suffocate or strangle.

! Never attach two LATCH hooks to

one vehicle lower anchor point unless specifically allowed by the vehicle manufacturer.

! Do not use both the vehicle seat belt and LATCH strap

at the same time when using the car seat rear-facing or forward-facing.

2 Features

Safety Surround

Head Support

(On Select Models)

2-A Car Seat Features

H I

M N

2 Features

A Height Adjust Button B Head Support C Shoulder Belt Guide D Harness Strap E Harness Covers F Chest Clip G Body Support

(On Select Models)

H Harness Buckle I Buckle Strap J Storage Compartment

(One on Each Side) K Harness Adjuster Lever L Recline Handle M Recline Foot N Harness Adjustment Strap

2 Features

A B

Back Support

B C

D E

2 Features

A Tether Storage Bar B Tether Strap C LATCH Storage Bar D LATCH E LATCH Adjuster F Cup Holder G Vehicle Belt Guide

2 Features

B C

+ 154 hidden pages

Graco Nautilus 65, NAUTILUS 65 LX Instruction Manual

Specifications and Main Features

Frequently Asked Questions

User Manual