Graco 1991895 Owner's Manual

Download

Page 1

OWNER'S MANUAL

Read all instructions BEFORE assembly and USE of product.

KEEP INSTRUCTIONS FOR FUTURE USE.

Page 2

Prevent serious injury or death: follow these warnings and the

instructions. Failure to follow these warnings and the

instructions could result in serious injury or death.

Setting Up the Playard

• THIS PRODUCT REQUIRES ADULT ASSEMBLY.

• Keep fingers clear of top corners during setup. Be sure playard is completely set up before use. Check that the four top rails are completely latched, the center of the floor is pushed down, the mattress/pad is flat, and the straps are securely fastened to the bottom of the unit. Always follow the instructions in the owner’s manual to set up the playard.

• Never use this product if there are any loose or missing fasteners, loose joints, broken parts or torn mesh. Check before assembly and periodically during use.

Using the Playard

• The playard is for playing or sleeping. When used for playing, never leave child unattended and always keep child in view. When used for sleeping, you must still provide the supervision necessary for the continued safety of your child.

• Always keep the playard away from hazards in the area that may injure your child.

• When child is able to pull to standing position, remove large toys and other objects that could serve as steps for climbing out.

• Stop using this product when your child reaches 35 inches (89 cm) in height, weighs more than 30 pounds (14 kg), or is able to climb out.

• Do not modify playard or add any attachments that are not listed in the owner’s manual, including an add-on bassinet.

• Child can become entrapped and die when improvised netting or covers are placed on top of a playard. Never add such items to confine child in playard.

• NEVER leave child in product with side lowered. Be sure side is in raised and locked position whenever child is in product.

• If refinishing, use a nontoxic finish specified for children’s products.

Page 3

Avoiding Suffocation Hazards

• Unlike cribs that have rigid sides, the playard has flexible sides. As a result, the playard mattress/pad is specially designed to prevent suffocation. The playard mattress/pad has a solid base, a certain length and width, and is less than one inch thick in order to meet safety standards. Using a thicker or a different sized mattress/pad may allow a child’s head to get between mattress/pad and the side of the playard causing suffocation.

• Infants can suffocate

• In gaps between a mattress too small or too thick and products sides

• On soft bedding.

NEVER add a mattress, pillow, comforter or padding. Use ONLY mattress pad provided by Graco.

• To reduce the risk of SIDS, pediatricians recommend healthy infants be placed on their backs to sleep, unless otherwise advised by your physician.

• Never use plastic shipping bags or other plastic film as mattress covers not sold and intended for that purpose. They can cause suffocation.

• NEVER use a water mattress with the playard.

Avoiding Strangulation Hazards

• Strings and cords can cause strangulation. Keep strings and cords away from child.

• NEVER place the playard near a window where cords from

blinds or drapes can strangle a child.

• NEVER hang strings on or over the playard.

• NEVER place items with a string around a child’s neck, such as hood

strings, pacifier cords, etc.

• NEVER attach strings to toys.

This product is not intended for commercial use.

Page 4

Parts list

ALL MODELS

This model may not include some

features shown below. Check that

you have all the parts for this model

BEFORE assembling your product. If

any parts are missing, call Customer

Service.

Tools required:

Phillips

Screwdriver

FEATURES ON CERTAIN MODELS

Page 5

Setup

DO NOT push center

down yet.

SNAP!

Page 6

•

When setting up, lock rails BEFORE lowering

center.

Be sure top rails have become rigid. If not, pull up again until they are rigid. If top rails do not latch, lift the center of the floor higher.

SNAP!

Hold one end of the unit up and push the center of the floor down.

Page 7

Always use mattress/pad soft side up.

Page 8

Put two tabs under mattress/pad through button holes and fasten securely on bottom of unit.

Pull strap through bottom of playard and wrap around tube and refasten snap. Repeat on other corners.

SNAP!

Page 9

To Fold

Release straps.

DO NOT

unlock top rails yet. Center of floor must be halfway up before top rails will unlock.

Page 10

Center of floor must be up.

1. Lift up slightly on the top rail.

2. Push in on the button located on the side of the top rail to release the two tubes.

3. Push down.

• If top rails do not unlatch, DO

NOT FORCE. Lift the center of the floor higher.

• Both tubes must be released

for the top rail to fold.

Page 11

Do not force. If unit will not fold, look for a partially latched top rail. Squeeze the latch button to release the rail.

Page 12

To Cover

Cover unit with handle out. Zip together.

Page 13

Accessories (On certain models)

Bassinet

WARNING

SUFFOCATION HAZARD Infants have suffocated:

• In gaps between extra padding and side of the bassinet, and

• On soft bedding.

Use ONLY mattress/pad provided by Graco. NEVER add a pillow, comforter or another mattress for padding.

• FALL HAZARD: To help prevent falls, do not use this product when

the infant begins to push up on hands and knees or weighs over 15 lbs (6.8 kg), whichever comes first.

• Use bassinet with only one child at a time.

• Never place a child under the bassinet.

• The bassinet must be fully assembled and installed, including four

metal tubes, eight clips and mattress/pad, before using. Do not modify bassinet or add any attachments that are not listed in the owner’s manual.

• DO NOT store the bassinet in the playard while in use.

• To help prevent heat build-up inside the playard and to avoid

overheating your child, when using the bassinet DO NOT use an outdoor canopy.

• To reduce the risk of SIDS, pediatricians recommend healthy

infants be placed on their backs to sleep, unless otherwise advised by your physician.

• If a sheet is used with the pad use only the one provided by Graco

or one specifically designed to fit the dimensions of the bassinet.

• Never place child in bassinet while bassinet/napper is attached.

This model may not include some

features shown.

Page 14

You will need to remove the mattress/pad from the bottom of the playard to use inside your bassinet.

NOTE: Bassinet mounts should always be attached on the end with the wheels as shown.

Insert tapered end of bar into end of other bar with hole in it. Repeat with other set of bars.

CHECK: Tubes MUST be assembled before placing mattress/pad in bassinet.

Mounts

8 Clips

Page 15

Remove 2 screws from back of electronics module.

Remove battery door and insert 3-AA (LR06) batteries (not included). Replace door and screws.

SNAP!

Page 16

Page 17

Keep the batteries out of children’s reach. Any battery may leak battery acid if mixed with a different battery

type, if inserted incorrectly (put in backwards) or if all batteries are not replaced or recharged at the same time. Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries. Any battery may leak battery acid or explode if disposed of in fire or an attempt is made to charge a battery not intended to be recharged. Never recharge a cell of one type in a recharger made for a cell of another type. Discard leaky batteries immediately. Leaky batteries can cause skin burns or other personal injury. When discarding batteries, be sure to dispose of them in the proper manner, according to your state and local regulations. Always remove batteries if the product is not going to be used for a month or more. Batteries left in the unit may leak and cause damage. Recommended type batteries—alkaline disposables. NEVER mix battery types. Change batteries when product ceases to operate satisfactorily.

TROUBLESHOOTING: If your device is not functioning properly, check for the following problems:

1. No batteries in electronics module.

2. Batteries dead.

3. Batteries in backwards—check “+” and “-”.

4. Corrosion on battery terminals. Rotate batteries in place against terminals, or clean with sandpaper or steel wool if corrosion is severe.

5. Batteries too weak.

For Safe Battery Use

Page 18

The vibration unit may ONLY be used with the bassinet or portable newborn bassinet and napper.

WARNING

You must remove the module from the unit when your child can pull up to a standing position.

TO TURN OFF ANY FUNCTION— Press and hold the button for 2 seconds.

Using Electronics Module

MUSIC— Each press will start the next music

function in sequence, after the 5th song is selected, the next press will turn music off.

Page 19

LIGHTS— Press once to turn top light (A) on, press twice to turn both lights on, press three times to turn bottom light (B) on, and four times to turn lights off.

(A)

(B)

VOLUME— Press the plus (+) to raise the volume

and the minus (-) to lower the volume.

Page 20

NATURE SOUNDS— Each press will change to the next nature sound. After the 5th sound is selected, the next press will turn sound off.

TIMER— Press once to set timer to 5 minutes, Press twice for 10 minutes, Press 3 times for 15 minutes.

Page 21

WARNING

FALL HAZARD- To prevent death or serious injury,

• Always stay within arm’s reach of your child when using the

changing table. Never leave child unattended.

• The changing table is designed for use only with this Graco

playard. Do not use on the floor, bed, counter or other surfaces. Before each use make sure the changing table is properly secured to the playard by pushing down firmly in the middle of the changing table.

• Do not use changing table as a sleeping or play area.

• Weight limit for the changing table is 30 lbs (13.6 kg). Do not use

the changing table as extra storage. Always remove the changing table when your child is in the playard.

• Use only the pad provided by Graco.

• Do not use changing table if it is damaged or broken.

• Strangulation Hazard: Child can lift changing table and get neck

trapped between changing table and playard frame. Always remove the changing table when your child is in the playard.

• Never use changing table on the same side as bassinet/napper.

Changing Table

Slide tube through fabric as shown. Repeat with other tube.

Page 22

SNAP!

Tubes should appear exactly as shown.

Snap leg tubes together as shown.

Attach short tubes into changing table mounts.

Conecte los tubos

Page 23

To remove, push in button while pulling up on corner of changing table. Repeat for other side.

SNAP!

Page 24

Portable Newborn Bassinet & Napper

WARNING

Prevent serious injury or death: follow these warnings and the instructions.

• This product is not intended for unsupervised or prolonged periods of sleep.

FALL HAZARD: To prevent falls, stop using the product when infant:

• Begins to wiggle out of position or turn over in the product or

• Head touches the upper edge of the product or

• Weights more than 15 lb (6.8 kg) (approximately 3 months

of age).

• Never use for a child able to sit up unassisted.

• NEVER leave child unattended.

• Always use restraint system. Adjust belt as needed to get a snug fit around your child.

• Child’s activity may move product. Use only on floor.

Never use on any elevated surface.

• NEVER attach bassinet/napper on the same side as the changing table.

• NEVER use this product as a means to transport an infant in a motor vehicle.

• ALWAYS use on floor. Never use on any elevated surfaces.

• Do not carry child in bassinet/napper.

• Always check that the bassinet is securely locked on the base/stand by pulling upwards on the bassinet bed.

SUFFOCATION HAZARD: Infants have suffocated

• On added pillows, blankets and extra padding. ONLY use the pad provided by the manufacturer. NEVER place extra padding under or beside infant.

• When trapped between product and adjacent surfaces. Only use in bassinet when it is securely attached. NEVER use

napper in different product.

• Never use on a soft surface (bed, crib, sofa, cushion), as

seat may tip over and cause suffocation.

Page 25

• ALWAYS place child on back to sleep.

• Use bassinet/napper with only one child at a time.

• NEVER place a child under the bassinet/napper.

• The bassinet/napper must be fully assembled before using. Do not modify bassinet/napper or add any attachments that are not listed in the owner’s manual.

• Always check to make sure bassinet/napper is

securely attached to bassinet.

• NEVER place child in bassinet while newborn

bassinet/napper is attached.

• To avoid suffocation, never use bassinet/napper

inside bassinet unless it’s attached to the mounts on the bassinet. Never place bassinet/napper in the bottom of playard.

STRANGULATION HAZARD:

• Do not use this product if it is damaged or broken.

• Strings and cords can cause strangulation. Keep strings

and cords away from child.

• NEVER place the bassinet/napper near a window

where cords from blinds or drapes can strangle a child.

• NEVER hang strings on or over the newborn

bassinet/napper.

• NEVER place items with a string around a child’s neck,

such as hood strings, pacifier cords, etc.

• NEVER attach strings to toys.

• DO NOT store the bassinet/napper in the playard while in use.

• To reduce the risk of SIDS, pediatricians recommend healthy infants be placed on their backs to sleep, unless otherwise advised by your physician.

• Never place any objects in bassinet/napper while child is in it.

• Never use this bassinet/napper on any other product.

• To prevent serious injury or death, DO NOT REMOVE FOAM.

Page 26

WARNING

•

To prevent serious injury or death, DO NOT REMOVE FOAM.

• Remove and IMMEDIATELY discard the zip tie.

Ziptie

With the napper side up, insert one of the napper tubes into napper as shown.

When assembling the napper/bassinet, assemble head portion first, then the feet.

Page 27

Insert the tube into the TOP button housing tube as shown. The metal button should be facing out when snapped in place as shown.

CHECK that the webbing attached the napper to the button housing is not twisted.

SNAP!

Page 28

Insert the tube into the other TOP button housing tube as shown. The metal button should be facing out when snapped in place as shown.

SNAP!

With the napper side up, insert other napper tube into napper as shown.

Page 29

Open the battery compartment lid by inserting a screwdriver in the slot. Insert one D (LR20) cell battery (not included).

Replace lid.

Insert one napper tube into top housing tube as shown.