Graco 16U505 User Manual

Instructions

Hopper Kit for GH5040ES, GH733ES, GH933, and GH933ES Big Rig Sprayers

Model 16U505

Series Maximum Working Pressure

GH733ES Bare 4000 psi (27.6 MPa, 276 bar)

GH5040ES Bare 5000 psi (34.5 MPa, 345 bar)

GH933ES Bare 7250 psi (50.0 MPa, 500 bar)

GH933 Bare 7250 psi (50.0 MPa, 500 bar)

IMPORTANT SAFETY INSTRUCTIONS Read all warnings and instructions in sprayer manual. Save these instructions.

Related Manuals:

332156

332157

332158

332234A

ti20999a

Pressure Relief Procedure

System pressure must be manually relieved to prevent it from starting or spraying accidentally. Fluid under high pressure can be injected into the skin and cause serious injury. To reduce risk of injury from injection, follow this procedure whenever you are instructed to relieve pressure, stop spraying, service equipment or install or clean spray tip. Read warnings, in operation manual.

1. Set pump valve OFF. Turn engine OFF.

2. Turn pressure to lowest setting. Trigger gun into pail to relieve pressure.

3. Rotate handle counter-clockwise to open prime valve.

If you suspect that the spray tip or hose is completely clogged, or that pressure has not been fully relieved after following the steps above, VERY SLOWLY, loosen tip guard retaining nut or hose end coupling to relieve pressure gradually, then loosen completely. Then clean tip and hose.

Parts Drawing

Hopper Kit Instructions

Initial Setup

1. Follow Pressure Relief Procedure on page 1.

2. Remove fitting from bottom of pump.

3. Apply sealant to nipple (5). Assemble to female fitting (6) and female fitting (4) and tighten.

4. Apply sealant to male fitting (3) and tighten to hopper (1).

5. Apply sealant to bottom of pump and assemble subassembly from step 3.

ti21000a

Parts List

Ref. Part Description Qty.

1 16U536 HOPPER, weldment 2 16U537 COVER, weldment 3 120307 FITTING, hose adapter, male 4 120308 FITTING, hose adapter, female 5 108209 NIPPLE, pipe 6 126939 FITTING, elbow, 90, female, reducing 7 16U538 BRACKET, mount, hopper 8 111195 SCREW, cap, flnghd 10 110110 SEALANT pipe, sst

6. Loosely install bracket (7) with two screws (8) into pump bracket.

7. Install hopper assembly (1) into subassembly from step 4 and tighten quick disconnect fitting (4).

8. Push bracket (7) up to secure hopper.

9. Tighten screws (8) to 30-35 ft-lb.

Removal

1. Loosen quick disconnect fitting (4).

2. Remove hopper.

Installation

1. Set hopper on bracket (7).

2. Rotate hopper into quick disconnect fitting (4).

3. Tighten quick disconnect fitting (4).

1 1 1 1 1 1 2 1

All written and visual data contained in this document reflects the latest product information available at the time of publication.

GRACO INC. AND SUBSIDIARIES • P.O. BOX 1441 • MINNEAPOLIS MN 55440-1441 • USA

Graco reserves the right to make changes at any time without notice.

For patent information, see www.graco.com/patents.

Original instructions.

International Offices: Belgium, China, Japan, Korea

This manual contains English. MM 332234

Graco Headquarters: Minneapolis

www.graco.com

Revision A - January 2013