Gorenje D98F65F operation manual

DRYING STEPS

START|PAUSE

90'

30'

DRYING STEPS

Program Laundry

Cotton

Ultra

Storage

Standard

Iron

Non-delicate cotton laundry

• towels, terry towels, stockinette, T-shirts, trousers, kitchen cloths etc.

Mix

Storage

Iron

Clothing made of a mixture of fibres

• trousers, T-shirts, suits etc.

Timed program

30´/ 90´

• laundry that needs to be thoroughly dried

• a small amount of laundry, or individual garments

Bed linen

Larger pieces of laundry

• bedding, large tablecloths, towels etc.

• prevents the laundry from forming into a bulk.

Program Laundry

Refresh steam

Clothing that you wish to treat with steam

• seasonal clothing, preparing the laundry for easier ironing

Wool softening

Wool garments

• garments with mixed fibres containing wool, which you wish to soften

• sweaters, scarves, shawls etc.

Shirts Shirts & blouses

Synthetics

Standard

Ultra

Synthetic garments

• T-shirts, trousers, suits, socks and stockings, gowns etc.

Delicate (Sensitive)

Laundry that requires drying at lower temperatures

• blouses, delicate underwear, shirts with additional decor etc.

STEP 3

PROGRAM SELECTION TABLE

DRYING IN TUMBLE DRYER

IS ALLOWED

DRYING IN TUMBLE DRYER IS NOT ALLOWED

Drying at high

temperature

Drying at low

temperature

Tumble

drying not

allowed

Place on

flat surface

Hang

Hang wetDrying in

tumble dryer

STEP 1

CHECK THE TAGS ON YOUR LAUNDRY

Close the zips and tie

any ribbons.

Close the

buttons.2

Turn the pockets

inside out.

Place

sensitive clothes in a laundry washing bag.

Insert wrung or spun

laundry into the drum.

Recommended spinning rate is at least min. 800 rpm.

STEP 2

PREPARING THE LAUNDRY AND LOADING THE DRYER

Sort the laundry by type

and fabric thickness

(see program table below).

STEP 4

EXTRA DRY

Press key up to three times to increase the level of laundry dryness and drying time.

STEAM

Smoothes wrinkles and freshens laundry.

ANTICREASE EXTRA

Prevents creasing if laundry is not taken from the dryer immediately after drying (default is 2 h, possible to set from 0-4 h)

START light is lit PAUSE light flashes

= CHILD LOCK

Simultaneously press the two keys and hold for 3 sec.

SIGNAL LIGHTS ARE ON:

when it is

necessary to clean the filter;

when it is necessary

to empty the condensate tank;

when the child lock

is on.

PRESS TO START / PAUSE

Turn the knob left or right to select the program.

Turn the knob to the »OFF« position to turn the dryer off.

SELECT MODE

(STYLE)

care

(default setting)

care for sensitive drying at lower temperature.

SELECT START DELAY

Select start delay by pressing the button several times (30 min – 24 h).

Countdown will be indicated on the display unit above the key.

SET ADDITIONAL

FUNCTIONS 1

SELECT THE PROGRAM OR TURN ON/OFF THE

DRYER

Unplug the power cord

from the outlet.

Open the

dryer door and clean the

filters (see section

Cleaning at the back page).

Take the laundry

from the drum.

Rotate

the program selector dial to the "OFF" position.

Empty

the condensate tank.

STEP 5

END OF DRYING CYCLE

An acoustic signal will indicate the end of the drying cycle. Signal lights will light up and the light on the START/ PAUSE key will flash.

Close the dryers

door.

575577en.indd 1575577en.indd 1 16.8.2016 13:22:5216.8.2016 13:22:52

www.gorenje.com

en (07-15)

SP10 EXCL HP GP ND

(1a)

EMPTYING THE CONDENSATE TANK

CLEANING THE STEAM GENERATOR TANK FILTER

Remove the condensate

tank and turn it upside down

above the sink or vessel to

empty.

Pull out the spout at the opening for easier emp-

tying (only some models).

Each time you empty the condensate tank, clean the

steam generator tank filter

Remove the filter from the support bed in the condensate tank housing.

Clean the filter thoroughly under running water, if

necessary

Also clean the filter support bed.

Put the filter and the condensate tank back into place.

Empty the condensate tank after

each drying cycle.

Make sure the remains of the fibres do not enter the dryer as this may clog the system.

CLEANING THE HEAT PUMP FILTER

Place an absorbent cloth on the floor in front of the dryer.

Open the outer cover, then hold the handle on the left side and pull downwards.

Use the handle to remove

the heat pump foam filter

from the dryer.

Remove the filter from

its handle and use a damp cloth to clean the housing.

Wash the filter under running water. Dry the filter and put

it back.

Clean the foam

filter at least

after every five drying cycles

Push the exterior cover upwards towards the appliance until it snaps back into place.

TIPS

FOR ECONOMICAL USE OF YOUR DRYER

FOR SMOOTH AND SOFT LAUNDRY

• Dry the recommended amount of laundry in each batch (see step 3 - Program Table).

• It is not recommended to dry laundry made of particularly delicate fabrics that may be deformed.

• Drying time will be shorter and power consumption will be lower if the garments are thoroughly wrung or spun before drying.

• Regular cleaning of the filters will lead to optimum drying time and minimum power consumption.

• Use of conditioner in the washing cycle is not necessary when the clothes are dried in a dryer.

TIPS FOR ECONOMICAL USE TIPS FOR SMOOTH AND SOFT LAUNDRY

• Select the appropriate drying program to avoid over-drying your laundry and problems with ironing or shrinkage of fabric.

• Remove laundry right after the end of the drying cycle to prevent it from creasing again.

• Use steam generator to straighten the creases and refresh the laundry.

• Ionizer system adds negative ions into dryers drum - the fibre will be flexible and your clothes will be tender and easy to iron.

• Dry smaller amount of laundry or single items with the timed program. When drying smaller amounts of laundry, the sensor may not perceive the actual level of moisture.

For detailed instructions please read the

extended manual.

QUICK INSTRUCTIONS

HOW TO USE YOUR

DRYER

CLEANING THE NET FILTER

Clean the filters

after each drying.

Be careful not to harm yourself during opening/closing of the net filter cover.

PROBLEM/ ERROR CAUSE

WHAT TO DO ...?

Problem/error Cause What to do ...?

Laundry is not dried, or drying temperature is longer than 4h.

• Filters are not clean.

• The room is not sufficiently ventilated.

• Inappropriate temperature in the room

• Laundry was not sufficiently wrung or spun.

• Amount of laundry dried in the appliance is too large or insufficient.

• Clean the filters.

• Install the dryer in an appropriate room.

• Check if the temperature in the room where the dryer is installed is too high (over 25°C) or too low (below 10°C).

• Laundry inserted into the dryer was not sufficiently wrung or spun, or an inappropriate drying program was selected.

Unevenly dried laundry.

• The amount of laundry dried at a time is too large.

• Drying the pieces of different thicknesses

• Drying the different types of laundry

• Make sure the laundry is sorted by type and size of items given the selected program.

Error in the drum lighting.

• There is no lighting when the dryer door is opened.

• Disconnect the dryer from the power mains and call an authorized service unit.

On display: F3 • Full condensate tank

• If the condensate tank is empty, there is a pump failure.

• Empty the condensate tank.

• Disconnect the appliance and call the nearest service unit.

On display: F4 • Clogged filters

• If the filters are clean, there may be a compressor failure.

• Clean the filters.

• Disconnect the appliance and call the nearest service unit.

On display: "LO" • Steam generator tank is empty • Add distilled water

Write down the failure/error code: F0, F1, or F2, disconnect the appliance and call thenearest authorized service (call center).

MAINTENANCE & CLEANING

Open the filter cover, and

remove the net filter. 2

Scrape the filter cover to

remove the layer of lint and

threads.

Replace the net filter, and

close the filter cover.



575577en.indd 2575577en.indd 2 16.8.2016 13:23:0216.8.2016 13:23:02