Goldstar Cube II Installation Manual

Cube II

Installation Guide

Version 1.0

Technical Support: 877-563-0012 Page 1

Technical Support:

OBJECTIVE

The objective of

1.

2.

3.

ONTENTS

GPS

Tracking Device

Select a suitable mounting location under the top dash pad

pad skin, above the g

Ensure the “SIM Card Lock” is positioned to the lock per example below.

WIRING CONNECTIONS. (Make connections, but do not plug into Device)

BLACK WIRE

RED WIRE

WHITE

STARTER

GREEN

W

YELLOW WIRE

-

this document

12V+ Constant Input, c

WIRE

IRE

on the supplied

is to provide

Power Harness

box, or above the gauge

chassis Ground, c

this wire to the ignition wire

(1 amp negative output)

SPDT Relay and harness (See

Test Wire for Starter Disable (optional)

user with information on how to install

onnect to a solid chassis ground.

onnect to a constant 12volt power source.

Relay & Socket

cluster.

Starter Disable output wire. Connect to the Orange

. Ideal locations are directly under th

diagram)

the

Cube II GPS device.

Accessory Kit

2

KIT

C

Cube II

a.
b.
c.

e dash

love

connect

.

DISABLE

d.

W

-

ire

e.

877-563

-

0012

relay

Page

Ground this wire momentarily (one second) after installation and harness has been connected to the device. This
will test “Starter Disable” output installation. The relay will close and open circuit to starter for 30 seconds. If
properly installed, the vehicle should not turn over/start during this time.

Place electrical tape over wire to prevent Test Wire from contacting ground in the future. Failure to do
so could result in unexpected messaging charges

 GREEN starter disable/unlock output (-)
 BLUE alarm trigger input
 YELLOW test mode wire(starter disable)
 RED-12v (+) Input
 BLACK ground input
 WHITE 12v (+) ignition input

4. Plug in supplied wire harness to device.

5. Make sure the vehicle is parked outside and has a clear view of the horizon for GPS to “lock in”

6. Observe LED status to confirm proper installation and if device is receiving GPS/GSM signals.

PWR

This LED will move to a solid RED state as soon as the
device receives constant power.

USR2

GPS signal. When the GPS has locked on, this LED will
move to a solid RED state. It may take up to fifteen
minutes to lock on, although generally less than five
minutes.

USR1

GSM/Cellular Status. This LED should move to a solid
GREEN state within one minute of the device being
powered up.

Starter Disable with ECM

If you’re doing a starter interrupt install on a vehicle with ECM, then the standard installation does not apply.
The starter wire goes into an onboard computer, generally carrying a low voltage into it instead of the standard
12 volt.

YOU NEED TO HAVE A VOLTAGE METER; NOT A STANDARD ‘ICE PICK!’ THE LIGHT WILL
COME ON WITH THE PICK AND GIVE YOU A FALSE READING! IF YOU TAP A WIRE WITH A LOW
VOLTAGE (3-5 VOLTS), YOU WILL LOCK DOWN THE VEHICLE!

Follow the low voltage wire from the ignition key to the ECM. Use your voltage meter to ensure that it is a 12
volt supply coming out. Once you’ve located the proper 12 volt wire after the ECM, proceed with the regular
starter interrupt instructions using this wire.

Technical Support: 877-563-0012 Page 3

Technical Support: 877-563-0012 Page 4