Goldmund SRP2.3 User Manual

1

GOLDMUND SRP2.3

PREAMPLIFIER

2

GOLDMUND SRP2.3 PREAMPLIFIER

USER MANUAL

ATTENTION :

No connection or manipulation must be done before reading these instructions. Damage to
the preamplifier may result if the following instructions are not consciously understood and
applied.

3

1 - UNPACKING

You will find in the GOLDMUND SRP2.3 box :

- The preamplifier.

- The remote Controller

- The power cord.

- This manual.

- Accessories and spare fuses.

Please keep the packaging in case you need to transport the preamplifier at a later date or if
you have to send it for maintenance.

2 - CHOICE OF PREAMPLIFIER LOCATION

The GOLDMUND SRP2.3 preamplifier generates a small amount of heat.
It is necessary to allow a proper cooling of the circuits. Avoid any location which is not
properly ventilated and avoid to put on top any equipment sensitive to temperature.

It is also a safe precaution to avoid direct proximity of the power amplifier, since the field
generated by some units can be detrimental for the SRP2.3.

3 - LINE VOLTAGE

A voltage indication is provided on the back plate of the unit. Check if this is appropriate for
your AC line voltage.

ATTENTION : With a 220V setting, the SRP2.3 preamplifier will function properly for AC line
voltage between 200V and 250V. On the 110V position, the AC mains must deliver between
95V and 125V. If your AC mains is usually out of these tolerances, please consult your
GOLDMUND dealer.

Please check the value of the AC line fuse. This fuse is located on the power cord receptacle.
The lid can be removed with a small screwdriver when the cord is removed.
Use a .5A slow-blow fuse for 220V and a 1A slow-blow fuse for 110V.