Global Industrial 7241M, 818M1, 733P10P, 72401 User Manual

Safety Data Sheet (SDS)

No.: SP116917

Date: 2015-05-05

Page 2 of 9

Name: Instant cold pack

STC (Shanghai) Company Limited

No.130, Huashen Road, Waigaoqiao Free Trade Zone, Shanghai, China (Zip code: 200131)

Tel: [phone] Fax: [phone] Homepage:www.shstc.org Email:[e-mail]

This report shall not be reproduced unless with prior written approval from STC (Shanghai ) Company Limited.

For conditions of Issuance of this test report, Please refer to the overleaf or homepage

Please refer to the original test report as this e-report is for reference only!

Safety Data Sheet(SDS)

Complies with 91/155/EEC, 1907/2006 (REACH) and amendments, OSHA's Hazard

Communication Standard, 29 CFR 1910.1200; and the requirements of the U.S. Department of

Labor Occupational Safety & Health Administration.

Regulatory Status:

This preparation is not classified as dangerous according to U.S. OSHA 29 CFR 1910.1200; E.C.

Directive 1999/45/EC; Canadian R.S. 1985, c. H-3; U.K. CHIP 2002 No. 1689; and/or U.N. GHS

ST/SG/AC 10/30.

None of the components present in this preparation at concentrations equal to or greater than 0.1% are

listed by IARC, NTP, OSHA or ACGIH as a carcinogen.

SECTION 1: PRODUCT IDENTIFICATION

1.1 Product identifier:

Instant cold pack

1.2 Recommended use and restrictions on use:

Recommended use:
Cold application for cold therapy

1.3 Supplier’s details:

Manufacturer：Rapid Aid Corp.
Address：4120A Sladeview Crescent, Mississauga Ontario, Canada L5L 5Z3
Telephone：[phone]

SECTION 2: HAZARD IDENTIFICATION

CLASSIFICATION OF THE SUBSTANCE OR MIXTURE:

The product is not classified as dangerous according to U.S. OSHA 29 CFR 1910.1200; E.C. Directive
1999/45/EC; Canadian R.S. 1985, c. H-3; U.K. CHIP 2002 No. 1689; and/or U.N. GHS ST/SG/AC 10/30;

The ocular irritation test report (Nucro-Technics’ Study No.: 292901-1)

GHS LABEL ELEMENTS: The substance is classified and labeled according to the Globally
Harmonized System (GHS).

HAZARD PICTOGRAMS & SIGNAL WORD

This product is not a hazardous article and need not be labelled

HAZARD-DETERMINING COMPONENTS OF LABELING:

None

HAZARD STATEMENTS:

None

PRECAUTIONARY STATEMENTS:
Prevention

None

Response

None

Storage

None

Disposal

None.

CLASSIFICATION SYSTEM: NFPA DEFINITIONS: 0-LEAST, 1-SLIGHT, 2-MODERATE, 3-

Safety Data Sheet (SDS)

No.: SP116917

Date: 2015-05-05

Page 3 of 9

Name: Instant cold pack

STC (Shanghai) Company Limited

No.130, Huashen Road, Waigaoqiao Free Trade Zone, Shanghai, China (Zip code: 200131)

Tel: [phone] Fax: [phone] Homepage:www.shstc.org Email:[e-mail]

This report shall not be reproduced unless with prior written approval from STC (Shanghai ) Company Limited.

For conditions of Issuance of this test report, Please refer to the overleaf or homepage

Please refer to the original test report as this e-report is for reference only!

HIGH, 4-EXTREEM

NFPA RATING DIAMOND (SCALE 0-4):

HEALTH=0
FIRE=0
REACTIVITY=2

HMIS-RATINGS (SCALE 0-4):

HEALTH : 0
FIRE : : 0

REACTIVITY: 2

SECTION 3: COMPOSITION INFORMATION

COMPOSITION: Mixture consisting of the following components

IUPAC

Concentration (weight percent, %)

MOLECULAR FORMULA

IDENTIFIERS

Water 40-60 H2O CAS: 7732-18-5

Calcium Ammonium Nitrate 40-60 CaH4N4O

9

CAS: 15245-12-2

SECTION 4: FIRST AID MEASURES

DESCRIPTION OF FIRST AID MEASURES

GENERAL INFORMATION: If medical attention is required. Show this safety data sheet (SDS) to the

doctor in attendance.

PRIMARY ROUTES OF ENTRY: Primary routes of entry: Eye and skin contact; ingestion; inhalation.

AFTER INHALATION:

Move victim into fresh air. If breathing is difficult, give oxygen.
Do not use mouth to mouth resuscitation if victim ingested or inhaled the substance.

AFTER SKIN CONTACT:

Immediately remove all contaminated clothing, including footwear.
Flush skin and hair with running water (and soap if available).

AFTER EYE CONTACT:

Wash out immediately with fresh running water.
Ensure complete irrigation of the eye by keeping eyelids apart and away from eye and moving the eyelids
by occasionally lifting the upper and lower lids.
If pain persists or recurs seek medical attention.
Removal of contact lenses after an eye injury should only be undertaken by skilled personnel.

AFTER SWALLOWING:

Do not induce vomiting. gargle with water，get medical attention.

MOST IMPORTANT SYMPTOMS AND EFFECTS, BOTH ACUTE AND DELAYED:

No information available

Safety Data Sheet (SDS)

No.: SP116917

Date: 2015-05-05

Page 4 of 9

Name: Instant cold pack

STC (Shanghai) Company Limited

No.130, Huashen Road, Waigaoqiao Free Trade Zone, Shanghai, China (Zip code: 200131)

Tel: [phone] Fax: [phone] Homepage:www.shstc.org Email:[e-mail]

This report shall not be reproduced unless with prior written approval from STC (Shanghai ) Company Limited.

For conditions of Issuance of this test report, Please refer to the overleaf or homepage

Please refer to the original test report as this e-report is for reference only!

SECTION 5: FIRE & EXPLOSION HAZARD DATA

GENERAL INFORMATION: Non flammable liquid

FLASH POINT: No information available

AUTOIGNITION TEMPERATURE:

No information available

EXTINGUISHING MEDIA: USE FLOODING QUANTITIES OF WATER.

SPECIAL FIRE FIGHTING PROCEDURES: DO NOT use dry chemical, CO2, foam or

halogenated-type extinguishers.

UNUSUAL FIRE AND EXPLOSION HAZARDS:

Avoid storage with reducing agents. Avoid
any contamination of this material as it is
reactive and any contamination is potentially
hazardous

HAZARDOUS DECOMPOSITION PRODUCTS:

Nitrogen oxide

SECTION 6: ACCIDENTAL RELEASE MEASURES

PERSONAL PRECAUTIONS, PROTECTIVE EQUIPMENT AND EMERGENCY
PROCEDURES

1 、 Remove all sources of ignition. Ensure adequate ventilation. Take precautionary measures against
static discharges.
2 、 Evacuate personnel to safe areas. Keep people away from and upwind of spill/leak. Use personal
protective equipment. Avoid breathing vapors and contacting with skin and eyes.

3、Wear protective clothing, gloves, safety glasses and dust respirator.

SPILL AND LEAK PROCEDURES:

1、Remove all sources of ignition. Use spark-proof tools and explosion-proof equipment.
2、 Absorb spilled material in dry sand or inert absorbent. In case of large amount of spillage,
contain a spill by bunding.

3、Adhered or collected material should be promptly disposed of, in accordancewith appropriate laws and
regulations.

ENVIRONMENTAL PRECAUTIONS:

1、Prevent further leakage or spillage if safe to do so.
2、Do not let product enter drains.