Gentex MUAHL5 Users Manual
Programming and Information Guide
Information on compatible products and video programming instructions are available at
www.homelink.com
Only press the transmitter button on the integrated garage door opener if there are no
persons or objects present within the sweep of the garage door. People could otherwise be
injured by the movement of the door.
1
2
4
3
Integrated garage door opener on the rear-view mi
rror Garage door remote control 5 is not part
of this integrated garage door opener.
To achieve the best result, insert new b
atteries in garage door remote control 5 before
programming.
•► For first tim
e programming, clear all HomeLink memory by following the instructions in the
"clearing memory" section (page 333)
•► Turn the SmartKey to position 2 in
the ignition lock.
•► Press and release one of buttons 2 to 4 on the integrat
1 lights up yellow.
•► Point remote co
ntrol 5 towards buttons 2 to 4 on the rear-view mirror at a distance of 2 to 8
inches (5 to 20 cm).
ed garage door opener. Indicator lamp
•► Press and hold bu
tton 6 on remote control 5 until indicator lamp 1 lights up green. If the
indicator lamp 1 does not turn green, reposition the remote control 5 and repeat this step.
HomeLinkandtheHomeLinkhouseareregisteredtrademarksofGentexCorporation.
•► Release button 6 on remote control 5.
•► Firmly press, and release the programmed button 2, 3, or 4 of the integrated garage door
opener up to three separate times to activat
e the device. If the device activates, programming is
complete. If the device does not activate, continue with "Synchronizing the Rolling Code."
Synchronizing the rolling code
Your vehicle must be within range of the garage or gate opener drive. Make sure that neither
your vehicle nor any persons/obje
cts are present within the sweep of the door or gate. A ladder
and/or second person may simplify the following steps.
Observe the safety notes when performing the rolling code synchronization.
•► Turn the SmartKey to position 2 in the ignition lock.
•► At the garage door opener receiver (motor-head unit) in the garage, locate the “Learn” or
“Smart” Button. This can usually be found directly on th
e motor-head unit (see the Garage
Door Opener manual to identify the “Learn Button”).
There are typically 30 seconds to complete the next step.
•► Press the previously programmed transmitter button 2, 3, or 4 of the integrated garage door
opener up to three separate times to activate the device. If
the device activates, programming is
complete.
Notes on programming the remote control
Canadian radio frequency laws require a "break" (or interruption) of the transmission signals
after broadcasting for a few seconds. These sig
nals may not therefore last long enough for the
integrated garage door opener to recognize the signal during programming. Comparable with
Canadian law, some U.S. garage door openers also feature a “break.”
If you live in Canada or have difficulties programming the garage door opener (regardless of
where you live) when using the programming steps above, proceed as
•► Press and hold one of transmitter buttons 2 to 4 of the integrated garage door opener. Afte
follows:
r a
short time, indicator lamp 1 lights up yellow.
•► Release the button. Indicator lamp 1 flashed yellow.
•► Press button 6 of the garage door remote control 5 for two seconds, then release it for two
seconds.
•► Repeat this sequence on button 6 of remote control 5 until indicator lamp 1 lights up green.
HomeLinkandtheHomeLinkhouseareregisteredtrademarksofGentexCorporation.
Loading...