Active Monitoring System
(DCW
frequency balance in difficult acoustic environ-
Audio input is via a 10 kOhm balanced fe-
Volume control and stand-by
for analyzing the effects of the adjustments,
Location of the acoustic
Type of cable needed
Control and connector layout on the rear panel
for the bass response of the loudspeaker below
filtering at 85 Hz to complement the low-pass
filter on a Genelec 7050B or 7050A subwoofer.
Align the loudspeakers correctly
Always place the loudspeakers so that their
Acoustic reflections from objects close to the
Suggested tone control settings for differing acoustical enviro nments
for Omnimount® size 20.5 brackets or the key-
Although the 8020A has been designed in ac-
performed by qualified service personnel.
The loudspeaker must not be opened.
mains cable or an unearthed mains
connection as this may compromise
electrical safety.
moisture. Do not place any objects filled with
liquid, such as vases on the loudspeaker or
near it.
sound pressure levels in excess of 85 dB,
which may cause permanent hearing
damage.
necessary to maintain sufficient cooling.
Do not obstruct airflow around the
loudspeaker.
disconnected from the AC mains service
unless the mains power cord is removed
from the amplifier or the mains outlet.
Amplifier system distortion at nominal output:
THD
0.08 %
SMPTE-IM
0.08 %
CCIF- IM
0.08 %
DIM 100
0.08 %
Bass
95 dB
Treble
95 dB
100, 120, 220 or 230 V
according to region
Voltage oper ating rang e: ±10 %
Full o utput 50 VA
21 kHz
66 Hz – 20 kHz (± 2.5 dB)
@ 1 m
96 dB SPL
@ 0.5 m
102 dB SPL
95 dB SPL
105 dB
10 dB (A-weighted)
Freq: 50…100 Hz < 3 %
> 100 Hz < 0.5 %
Treble 19 mm (
/
Both drivers are
magnetically shielded
/
(including Iso-Pod™ table stan d)
Height
/
(without Iso-Pod™ ta ble s tand)
Width
Depth
/
Input: XLR female, balanced 10 kOhm,
pin 1 gnd, pin 2 +, pin 3 -
Output: XLR male, balanced 100 kOhm
Pin 1 gnd, pin 2 +, pin 3 -
-6 dBu at volume control max
Volume contr ol ra nge:
-80 dB relative to max output
0 to –2 dB @ 15 kHz
0 to –6 dB @ 100 Hz
AMPLIFIER SECTION
CROSSOVER SECTIONSYSTEM SPECIFICATIONS
Ilpo Martikainen
Loading...