SpectroLED 14
PRODUCT GUIDE
Genaray SpectroLED 14 Guide | Page 1
INTRODUCTION
Genaray SpectroLED 14 Guide | Page 2
Thank you for choosing Genaray.
The Genaray SP-AD75 LED Light uses 1144 LED lights
installed on a 13.25” diameter circuit board array for an
approximate output equivalent to 75 W.
The light is balanced at 5600 K daylight temperature. The
LED emits very little heat, eliminating the need to wait for
it to cool off before handling.
A variable dimmer knob on the back of the lamp will allow
you to control the light output between 10% and 100%.
There is also an external dimmer available from Genaray,
so use can control the dimmer from a remote location.
The SP-AD75 LED Light may be powered by a 12 V DC battery (sold separately)
with the included cigarette lighter adapter cable, or by a 120 V AC source with the
included step down transformer and grounded AC plug. Fully charged, depending
on the capacity of the battery, you will get approximately 70 minutes of run time.
The light mounts onto any standard 5/8” light stand, and the mounting bracket
articulates over 90° vertically.
Uniquely featured with the Genaray LED is the umbrella socket built into the center
of the circuit board array. Diffuse the light from the array by inserting an umbrella
(sold separately) through the umbrella socket. You may also use the included
diffuser sock to fit around the circumference of the reflector. Additional diffuser
socks are available as an accessory from Impact.
Genaray SpectroLED 14 Guide | Page 3
Introduction
SPECIFICATIONS
• Light source – 1144 Super Bright
LEDs set at a 60° angle.
• Reflector diameter – 14.5”
• Weight – 3.95 lbs
Specifications
• Operating Voltage
• 19V DC 4.74A power supply or
storage battery
• Grounded AC plug + step down
transformer
• Built-in flicker-free dimmer – 10%
to 100%
Genaray SpectroLED 14 Guide | Page 4
• 5/8” mounting bracket
• Power consumption – 75 W
• Umbrella socket at center of LED
array
• 5600 K (± 200)
• Cable length – 2 m
• Bulb life – 50,000 hours