Gemini VHF-1000M, VHF-1000HL, VHF-2000M, VHF-2000HL Owner's Manual

Owners Manual

VH-SERIES

VHF-1000M
VHF-1000HL
VHF-2000M
VHF-2000HL

Parts of the design of this product may be protected by worldwide patents

Information in this manual is subject to change without notice and does not
represent a commitment on the part of the vendor. Gemini Sound Products

shall not be liable for any loss or damage whatsoever arising from the use of informa-

tion or any error contained in this manual.

No part of this manual may be reproduced, stored in a retieval system or

transmitted, in any form or by any means, electronic, electrical, mechanical,

optical, chemical, including photocopying and recording, for any purpose

without the express written permission of Gemini Sound Products.

It is recommended that all maintenance and service on the product should be carried out

by Gemini Sound Products or it’s authorized agents. Gemini Sound Products cannot ac-

cept any liability whatsoever for any loss or damage caused by service, maintenance or

repair by unauthorized personnel.

In the U.S.A., if you have any problems with this unit,

call 1-732-346-0061 for customer service. Do not

return equipment to your dealer.

Worldwide Headquarters • 1 Mayfield Dr, NJ 08837 • USA

Tel: [phone] • Fax [phone]

France • G.S.L.. France • 11, Avenue Leon Harmel, Z.I. Antony, 92160 Antony, France

Tel: [phone] • Fax [phone]

UK • Gemini Sound Products • 44 The Brambles Enterprise Center, Waterberry Drive,

Waterlooville P07 7TH, UK. Tel: [phone] Fax: [phone]

Spain • Gemini Sound Products S.A. • Mino, 112 Nave 1, 08223 Terassa, Barcelona, Spain

Tel: [phone] • Fax [phone]

© Gemini Sound Products Corp. 2007 All rights Reserved

VH- Series Operation Manual

English...............................................................................3-6

Español............................................................................7-10

Français..........................................................................11-14

Warranty Card.....................................................................15

Table Of Contents

V

olume Control

Power Indicator

Squelch

Signal Indcators

Volume Control

Power Indicator

Antenna

Signal Indcators

Volume Control

Signal Indcators

Antenna

Output to mixer

Line/Mic Switch

Power

Squelch

Output to mixer

Line/Mic Switch

Power

Squelch

Line/Mic Switch

Output to mixer

Channel Mixer

Antenna

Battery Door

ON/OFF Switch

Battery Low LED

1/4 inch input

Combo Head set

Snap-off Lavalier mic

XLR connector

Power Switch

Mic/Line Switch

INTRODUCTION

C

ongratulations on your purchasing a Gemini wirelesssystem. This system includes the latest features and is
backed by a one year limited warranty. Prior to use we suggest that you carefullyread all the instructions. This book includes
instructions for both the VHF-1000 and theVHF-2000 systems.

CAUTIONS

1

. All operating instructions should be read beforeusing this equipment.

2. To reduce risk of electrical shock, do not open the unit. There are NO USER OR SERVICABLE PARTS INSIDE. Please refer

servicing to a qualified service technician.

3. Do not expose this unit to direct sunlight or a heat source such as a radiator or stove.

4. Dust, dirt and debris can interfere with the performance of this unit. Make an effort to keep the unit away fromdusty, dirty

enviroments, and cover the unit when itis not in use. Dust it regularly with a soft clean brush.

5. When moving this equipment, it should be placed in its original carton and packaging. This will reduce the risk of damage

during transit.

6. DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.

7. DO NOT USE ANY SPRAY CLEANER OR LUBRICANT ON ANY CONTROLS OR SWITCHES.

FCC RULES AND REGULATIONS

Gemini wireless systems are the type acceptedunder FCC rules parts 74 and 15. Licensing of Gemini equipment is the user ’s
responsibility and licensability depends on the user’s classification and application.

NOTE

This equipment has been tested and foundto comply with the limits set forth under part 15 and 74 of FCC rules.
This equipment operates at a frequency thathas been authorized by the FCC. However, there is no guarantee that interference
will not occur in a particular installation.If this equipment does cause interference to radio or televison reception, try one or more
of the following suggestions:

1. Repoint or relocate the recieving antenna.

2. Plug the equipment into a socket or a different circuit.

3. Call your dealer to arrange to exchange the unit for one with a different frequency.

Remember, any changes made to the unit without authorazation from Gemini will void your warranty.

VH-1000 SINGLE CHANNEL WIRELESS SYSTEM

The VH-1000 single channel VH series wirelesssystem is a high quality audio product that provides excellent performance under
most operating conditions.
Four different models are available and all operate one VHF high band frequency between 177.60 MHZ to204.60 MHZ.

THE MODELS AVAILABLE ARE:
VHF-1000M - Which comes equipped with ahand held microphone transmitter.
VHF-1000HL - Which comes equipped with abelt pack transmitter and Headset/ lavalier combo.

ALL MODELS ARE AVAILABLE IN EIGHT DIFFERENT FREQUENCIES:

Frequency Conversion Chart:

Channel

Frequency
2 177.60 MHZ
4 186.60 MHZ
6 198.60 MHZ
8 204.60 MHZ

VH-1000 SINGLE CHANNEL RECIEVER OPERATION

Note: Effective range between the transmitter and reciever is up to 100 feet.

1. Remove all packing materials. Save the box and packing materials to transport the unitand in case the unit ever requires service.

2. Plug the AC adaptor into the rear of the reciever where the jack is labeled DC 12V. Then plug the adaptor into an appropriate AC
Outlet. The power indicator should be illuminated. NOTE: The adaptor is available in 120V AC or 230V AC.

3. Extend the antenna fully vertical and point it out into the direction you willbe speaking from.

4. Insert the 1/4” cable into the jack labeled AUDIO OUT on the rear of the reciever, and connect the other end of the cable
to your amp ,effects or mixer jack.

5 Adjust the volume using the level controlon the front panel

6. To adjust the squelch, place the small plastic tool (included with the unit) in the hole marked SQUELCH at the backof the unit,

and slowly turn the tool to adjustthe output level to just above the level of background noise. Setting the squelch to high will
reduce the range of the system. Settingthe squelch too low will increase the level of unwanted noise.

VHF- 2000 DUAL CHANNEL SYSTEM

T

he VHF- 2000 dual channel VH serieswireless system is two seperate single channel transmitters of different frequencies
transmitting to one unit that houses bothfrequency recievers, each one having its own seperate output, unless you choose mix mode
(

see back panel) which alows youto have both channels out of one output. There is also individual squelch and level control for

each channel.

Two different models are available and both operate on a VHF high band frequency between 177.60 MHZ to 204.60MHZ

THE MODELS AVAILABLE ARE:

VHF-2000M - Which comes equipped with (2)hand held microphone transmitters.
VHF-2000HL -Which comes equipped with (2) beltpack transmitters and (2) Headset/ lavalier combos.

ALL MODELS ARE AVAILABLE IN TWO SETS OF DIFFERENT FREQUENCIES:

Frequency Conversion Chart:

System

Channel Frequency
1 2&4 177.60 MHZ/198.60 MHZ
2 6&8 186.60 MHZ/204.60 MHZ

VHF- 2000 DUAL CHANNEL RECIEVER OPERATION

Note: Effective range between the transmitter and reciever is up to 100 feet.

1. Remove all packing materials. Save the box and packing materials to transport the unitand in case the unit ever requires service.

2. Plug the AC adaptor into the rear of the reciever where the jack is labeled DC 12V. Then plug the adaptor into an appropriateAC
Outlet. The power indicator should be illuminated. NOTE: The adaptor is available in 120V AC or 230V AC.

3. Extend the antenna fully vertical and point it out into the direction you willbe speaking from.

4. Insert the 1/4” cable into the jack labeled AUDIO OUT on the rear of the reciever, and connect the other end of the cable
to your amp ,effects or mixer jack.

5 Adjust the volume using the level controlon the front panel

6. To adjust the squelch, place the small plastic tool (included with the unit) in the hole marked SQUELCH at the backof the unit,
and slowly turn the tool to adjustthe output level to just above the level of background noise. Setting the squelch to high will
reduce the range of the system. Settingthe squelch too low will increase the level of unwanted noise.

HAND HELD TRANSMITTER FEATURES

• High sensitivity cardiod capsule for professional use

• Special noise absorption parts inside the barrelseliminating switch shock and handling noise

• Frequency with quartz locked control

CAUTIONS

1. Do not drop the microphone onto a hard surface.

2. Do not strike the microphone head front with fist or fingers, and do not blow strongly into the microphone headfront.

3. Do not use the microphone in areas of high humidity and /or high temperatureas this could lead to damage of the microphone.

HAND HELD TRANSMITTER OPERATION

1. Open the battery holder turning it counter clockwise. Insert a 9V battery into the battery holder according to the polarity
indication marked on the battery housing. Closethe battery holder.

2. Push the power switch to the ON position. The BATT indicator should flash once briefly as you turn onthe mic indicating that the
mic has sufficient power. If theBATT stays on, it indicates that the battery has insufficient powerand should be changed.
If the BATT does not light at all and the mic does not work, it indicates the the battery is deadand you should change the battery.
If the microphone is not going tobe used for any length of time, push the power switch to OFF and remove the battery.
Do not switch the mic on andoff rapidly, because you wont get a true indication from the BATT indicator.

PAGE 3 PAGE 4