GE Industrial Solutions TNK200 User Manual

DEH44150 Installation Instructions

Neutral mounting kit

Catalog number – TNK200

Introduction

This bulletin provides instructions for installing Neutral lug kit – TNK200 on all GE Double throw safety switch rated 200A.

WARNING: Hazard of electrical shock or burn. Turn off power before working inside this equipment.

Description

This neutral kit consists of the following parts:

1. One (1) Neutral assembly

2. Two (2) 10-32 X 1/4” mounting screws

3. One (1) Card for screw

4. One (1) 12-24 X 1-3/16” bonding screw

Mounting Instruction

1. Tighten item 2 (Mounting screws) in to mounting hole in the enclosure. Ref. Fig 1

2. For bonding, Insert item 4 (Bonding screw) through hole in neutral & thread screw in to tapped hole in mounting bracket of neutral assembly. Ref. Fig 2

Wire range: 6 – 250MCM CU/AL

These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in connection with installation operation or maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s purposes, the matter should be referred to the GE Company.

Fig 1

Fig 2

Visit us on the web at www.GEindustrial.com

GE Consumer & Industrial