GE Industrial Solutions Spectra Series Power Panelboards Drip-Resistant Cover User Manual

g

p

g

quip

p

y

g

quip

y

p

Spectra Series™ Power Panelboards

Drip-Resistant Cover

WARNING: Danger of electrical shock or injury.
Turn

OFF

switchboard before workin

ment or removing any component. Do

e
not remove circuit
other component until the power is turned
OFF.

ower ahead of the panelboard or

inside the

rotective devices or an

GEH5926 Installation Instructions R02

Installation

1. If the drip-resistant cover is to be installed in a 16.25­inch-deep Spectra Power Panelboard enclosure, two
cover-mounting brackets must be relocated, as shown
in Figure 1. For all other applications, do not move
the mounting brackets.

2. Remove four #10-32 screws from the enclosure top to
match the locations of the mounting brackets on the
drip-resistant cover. Save these screws, as they will be
used to install the drip-resistant cover on the
enclosure.

3. Attach the drip-resistant cover to the enclosure, as
illustrated in Figure 2, using the screws removed in
step 2. It may be necessary to loosen the screws in the
mounting brackets to adjust their positions to proper
alignment with the holes in the enclosure. Tighten all
screws.

Figure 1. Relocating the mounting brackets on 16.25-inch-deep

panelboards.

Figure 2. Attaching the drip-resistant cover.

These instructions do not cover all details or variations in e
ma

be met in connection with installation, operation, or maintenance. Should further information be desired or should

articular problems arise that are not covered sufficiently for the purchaser’s purposes, the matter should be referred to the

GE Company.

GE Industrial Systems

General Electric Company
41 Woodford Ave., Plainville, CT 06062

GEH5926 R02 1001 © 2001 General Electric Company

ment nor do they provide for every possible contingency that