GE ZIS360NRJ, ZIS360NRK, ZIS420NRA, ZIS420NRB, ZIS420NRI Installation Guide

...

Installation Instructions

SidebySide Refrigeraters

Design Guide

With Instannation instructions

Monogram:

Safety information

BEFORE YOU BEGBN

Read these instructions completely and carefully.

•IMPORTANT- Sa.e hese

for local h_spector's use. Observe a]] governim_g codes amid ordi m_am_ces.

• Note to Installer - Be sure to ]cave these

im_structions with the (}om_sm_er.

• Note to Consanler -Keep d]ese im_sm,cdo_s

with ,our Om_er's Mamta] for futm'e referem)ce.

WARNING:

This app]hmce ml*s[ be properly grom]ded. See

"C,rom)dh)g [he P,etHgeramr," page ]H.

AVERT SSEMENT

Cet appare]] doit 0tre correcteme])t m]s {t_]a terre. Consl*]ter << M]se fi ]a terre (h_ r(_iHg(_ratem" ,>,page ] 0.

lf"_ou received '_ darn'wed refrigerator, "_ou should immediateh _ontact _om" dealer or builder.

Dl*e to the weight am)dsize of this re{Hgerator, am] to recline the risk of persom:d iqim T or damage to the product - THREE PEOPI,E ARE RE@ lINED

FOR PROPER INSTAI,I,ATK)N OF A 36" WlDE UNIT. FOUR PEOPI,E ARE REQUIRED FOR

INSTAI,I,ATION OF A 42" OR 48" WIDE MODEl.

PRUDENCE

cause du poids et de ]a tai]]e de ce r_frige_rator et

pour r_4duire ]e risque de b]essm'e et de dommages,

li, FAIJT TROIS PERSONNES PO[JR INSTM,I,ER

COI_,RECTEMENT D'IJN &PP&REII, DE 91 cm (36 po)

DE LAk(,E. Ii, FAiJT Q[ J_TRE PERSONNES PO[JR I ilNSTM,I,ATION D' [JN MODI_I,E DE 1H7 O[ / 122 cm

) ,

(42 OI / 48 po) DE lARGE.

Skill Level - h_sta]]athm of this refrigerator

requires basic mecham_ica], carpem_tr? amid phm_bim_g skills. Proper i m>ta]h_ti(m is the reslxmsibi]it} of the im/sta]]er. Product {hi]m'e <]tie to improper im/sta]]atiom/ is Nmt covered m_der the (;E _pp]iam_ce _,_arr;mtv.

See t]_ e ()w]_ e]"s N_a _ I 0a] for WaFFa _1t_ ] _1['OFI)) a t] o11.

WARNING:

* These refrige_:m)rs are top-hea_) am] m_st

be secm'ed to preve_t the possibility of tippi_g flu'ward. A_ti-Tip protection is req_dred. See [)age ] 2 for detai]s.

* IJse this app]ia_ce only fin" its ]_temIed purpose. * Immediately repair or replace electric service cords

that become f}'ayed or damaged.

* I I_q)]ug the reiHgerator before c]ea_h_g or maki_g

* Repairs should be made b} a qualified service

tech _ icia _.

AVERTISSEMENT

*Ces r_}Hg&'a[eurs sm)[ ]om'ds e_) ham e[ il }im[ ]es

_vi [er ]e_r bascu] em e]_L I] fh m avoir

m) svstbme de protection) co_m'e ]e re])vergeme])t.

Voh" ]es d_tai]s page 12.

* II _]e [h_g uti]iser cet apparei] q_e po_r ]'_ti]isati(m

* Re, parer o_* remp]acer ]mm&]iateme_t tol*t cordo]l

_lectriq_*e eiti]och(_ o_* emIommag(_.

* l] %at dSbra_cher ]e r65igSrateur awmt ]e

aettoyage ou rouge h_te]we]]t](m.

* i,es reSparations doivent _tre f_dtes par m_

tec]micie]_ q _*a]ifi(_.

For Monogram local service in your area, call

1.800.444.1845.

For Monogram service in Canada, call

1.888.880.3030

For Monogram Parts and Accessories, car

1.800.626o2002.

www. mmmgram.com

Plam_i_g 6uide

The Installation Space ....................................3

Dimensions and Clearances ..........................3

130° Door Swing ..............................................4

%° Door Swing ................................................5

Customization Basics ......................................6

1/4"Framed Panel Dimensions ......................7

3/4"Overlay Panel Dimensions......................8

Raised Overlay Panel Design ........................9

Side Panels......................................................10

Installation Instmctieas

Tools, Hardware, Materials ........................ 10

Grounding the Refrigerator .......................... 10

Step 1, Remove Packaging .......................... 11

Step 2, Install Water Line ............................ 11

Step 2A, RO Water Line ................................ 12

Step 3, Install Side Panels ..........................12

Step 4, Install Anti-_p Brackets ................ 12

Step 5, Level Refrigerator ............................ 13

Step 6, Alternate Anti-_p Procedure ........ 13

Step 7, Secure Refrigerator to Cabinetry _14

Step 8, Adiust Door Swing .......................... 14

Step 9, Install Grille Panel ............................ 14

Step 10, install Framed Panels .................... 15

Step IOA, install Overlay Panels .......... 16-17

Step 11, install Dispenser Trim .................... 18

Step 12, Connect Water Supply .................. 18

Step 13, Cormect Power .............................. 19

Step 14, Start Icemaker ................................ 19

Step 15, install Toekick ................................ 19

Design Guide

THE INSTALLATION SPACE

36"Models12" 42"Models18" 48"Models20"

75"FromFloor

to Bottom

ff Electrical

Area

*The finished cutout width must be:

35-1/2" fin" 36" models 41-1/2" for 42" models 47-1/2" fin" 48" models

Water And Electrical Locations

The opening must be prepared with the electrical and water supi)ly located as shown.

The cutout depth must be 24" The refrigerator will project fin'ward, slightly beyond ac!jacent cabinetry, depending on yore" installation.

Cutout depth beneath a soffit:

When installed beneath a soffit, the soffit cannot

exceed the 24" installation depth shown. The top case trim overlaps the bottom of the soffit.

DIMENSIONS AND CLEARANCES

25-3/8"FramedModels

35",41",or47" _ 25-3/4"StainlessSteel Models

]._aCaseWidth_..] * Shippingheight.The

•84"From height.Notethatthe

832

Rea

36",42"or48"

Frameto Frame

DepthincludingHandles: 26-7/8"FramedModels 27-3/4"StainlessSteelModels 28-11/16"ProfessionalModels

Product Clearances

These refrigerators are equii_ped with a 2 position door stop. The tactorv set 130 ° door swing can be a(!justed to 90 ° if clearance to a(!jacent cabinets or

walls is restricted.

130° DoorSwing

Floorto top casetrim at the

TopFrame front is 1/2"higher

refrigeratorcanbe adjustedto fit intoa cutoutthat is 83-1/2" min.to 84-1/2"max.

andwill overlap uppercabinetryor

soffit. Useleveling legsandwheelsfor a

maximum1"height adjustment.

90° DoorSwing

23=7/8"

Behind

Frame

Additional Specifications

• A 115 _olt 60Hz., 15 or 20 amp power suppl_ is

required. An indixidual properl) grotmded branch circuit or circuit breaker is recommended. Install

a I_r° I_erlv, ,gr°tmded 3-i_ron _, electrical receptacle recessed into the back wall. Electrical must be located on rear wall as shown.

NOTE: GF] (grotmd tault interrupter) is not

recoi/llllended.

• Water line can enter the oi_ening, through, the floor

or back wall. The water line should be 1/4" O.D. copper tubing or (;E _martC_ nnect kit between

the cold water line and water connection location, long enough to extend to the front of the

refrigerator. Installation of an easily accessible shut off xalxe in the water line is required.

S _ ) ii

Models A B C *Min. Distance 36" 13" 15" 20-5/8"

42" 13" 19" 26-5/8" '4" Stainlessand 48" 15" 20" 28-5/8" TrimmedModels.

Allow minimmn clearances for fl'eezer door

(Dimension A) and fresh ti)od door (Dimension B)

tot a flfll 130 ° door swing and to allow tot pan

I'eII/ox_ll.

For a 90 ° door swing, allow 4" rain. clearance

to a wall, for framed and stainless steel models.

Allow 5" rain. clearance for professional series models.

If the 90 ° door stop position is used, pan access is

maintained, but pan remoxal is restricted.

See illustrations pages 4 and 5 to determine door swing interaction with ac!jacent cabinets or

cot/ntertol) S.

toWall

5" ProSeries

Refrigerator

Design Guide

FramelessCabinets:The case trim overlaps

cabinets atthe top and sides. Therefore, frameless cabinets may require filler strips to

prevent interfeence with cabinet door swing. Theopening must allow for filler strips.

23-7/8"From

Rearof

Refrigerator

Csse

Trim

3/4"

1/2"

1/4"

3/4"Overlay

Panel

"', (NominalSize)

Top View

130 ° DOOR SWING (factory setting)

Scale 1:1

IMPORTANTNOTE- FORDISPENSERMODELS:

Dispenser models are supplied with two dispenser trims, oneto fit framed panels and one for overlay panels.Dispenser trim

fitto thecustompanel dependsoncorrect panelthickness. Framedpanels must be

1/4"nominal. Overlay panelsshould be

constructed as shown to accomplish atotal

1.100"thickness. See pages 7 and 8 for details.

Door

Design Guide

Refrigerator

CaseTrim

FramelessCabinets: The case trim overlaps cabinets at the top

and sides.Therefore,

frameless cabinets may

require filler strips to prevent interference

with cabinet door swing. The opening must allow

for filler strips.

23-7/8"

FromRearof

Refricerator

k i i i i

' ' ' 1/4"

Top View 90 ° DOOR SWING

(optional setting)

Scale 1:1

IMPORTANTNOTE- FORDISPENSERMODELS:

Dispensermodelsare supplied

with two dispenser trims, oneto fit

framed panels and onefor overlay

panels. Dispensertrimfit tothe

custompaneldependsoncorrect panelthickness. Framedpanels

must be 1/4"nominal. Overlaypanels should be constructed as shown to

accomplish atotal 1.100"thickness. See pages 7 and 8 for details.

1-1/2"

Door

3/4" Overlay

Panel

(NominalSize)

Design Guide

CUSTOMIZATION BASICS:

Framed Or Overlay Panels, Custom Handles and Accessory Kits

Professional Style Stainless Steel Refrigerators

Stainless steel wrapped reti'igerators ha;'e beveled edges and professional style handles. These models are shii_ped ready fl)r installation.

Stainless Steel Wrapped Refrigerators

Stainless Steel wrapped refiigerators ha;'e wrapped doors and grille panel, beveled edges, and tubular

stainless steel handles that coordinate with other Monogram appliances. These models are shii)ped

ready for installation.

Trimmed Refrigerators

Trimmed refrigerators are designed to be customized with decorative panels. Field installed custom door and grille panels are required.

Framed panels

You may install 1/4" thick custom panels ti'om yore"

cabinet manufhctm'er. The decorative panel slides into the tactorv installed trim. Or, order black, white and

stainless steel accesso_ T panels fl'om yore" Monogram dealer.

Overlay panels

You may also choose to install custom overlay panels

fl'om wmr cabinet mantflhcturer. This design provides a seamless appearance which integrates smoothly with stu'rotmding cabinetry.

StandardDoorHandles

Standard supplied handles shown in 3/4"overlay panel position.

Door Handles

The standard supplied handles can be a(!iusted to accommodate both fl'amed or overlay panels. Custom handles of your choice, SUl_plied by your cabinet maker can also be installed on 3/4" overlay panels. If desired, you may order ZKHSS2 Monogram stainless steel tubular handle kit fl)r 3/4" overlay panels.

FramedPanel

StandardDoorHandles

Standard supplied handles shown in 1/4" panel position.

Optional Accessory Kits

ZKHSS2: Monogram Tubular Stainless Steel handles designed to fit. /4 oxerla) panels.

Accessory Panels

Black and stainless steel accessory panels are awfilable from vom" Monogram dealer. Panels are cut to size and

ready to install.

Side Panels

Side panels must be used whene_er the sides oI the refrigerator will be exposed.

ZISW480D ZPS480D

ZIS480N ZPB480N ZPS480N

ZISB420D ZPB420D ZPS420D

ZISW360D ZPS360D

ZIS360N ZPB360N ZPS360N

+ 14 hidden pages