GE PSA9120SFSS User Manual

PSA9120SF

GE Profile Series Advantium® 120 Over-the-Range Oven

Dimension Information (in inches)

Important: Please read carefully. For personal safety,

this appliance must be properly grounded to avoid
severe or fatal shock.

Do not, under any circumstances, cut, deform, or
remove any of the prongs from the power cord.
Do not use with an extension cord.

Installation Information: This information is not
intended to be used for installing unit described.
Before installing, consult installation instructions
packed with product/kit for current dimensional data.

Minimum distance from
door hinge side to
adjacent wall should
equal 1/2 inch.

24-1/2

105°

Door open

(without obstruction)

29-7/8"

66" MIN.

Mounting

height

from
floor

13"

MAX.

12"

MIN.

15-1/2"

15-3/4"

30"

MIN.

width

required

16-1/4"

(rear)

Exhaust outlet
connects to
3-1/4" X 10" duct

For answers to your Monogram® or GE® appliance
questions, visit our website at geappliances.com
or call GE Answer Center® service, 800.626.2000.

Specification Revised 7/13

Listed by
Underwriters
Laboratories

240452

PSA9120SF

GE Profile Series Advantium® 120 Over-the-Range Oven

Dimension Information (in inches)

Hood Exhaust Duct

Outside ventilation requires a HOOD EXHAUST DUCT. Read the following carefully.

EXHAUST CONNECTION:
The hood exhaust has been designed to mate with a standard 3-1/4” x 10”
rectangular duct.

If a round duct is required, a rectangular-to-round transition adaptor must be used.
Do not use less than a 6” diameter duct.

REAR EXHAUST:
If a rear or horizontal exhaust is to be used, care should be taken to align exhaust
with the space between studs, or wall should be prepared at the time it is constructed
by leaving enough space between the wall studs to accommodate exhaust.

MAXIMUM DUCT LENGTH:
For satisfactory air movement, the total duct length of
3-1/4” x 10” rectangular or 6” diameter round duct should
not exceed 140 equivalent feet.

ELBOWS, TRANSITIONS, WALL AND ROOF CAPS, etc.,
present additional resistance to airflow and are equivalent
to a section of straight duct which is longer than their
actual physical size. When calculating the total duct length,
add the equivalent length of all transitions and adaptors plus
the length of all straight duct sections. The chart below
shows the approximate feet of equivalent length of some
typical ducts.

Filter Kit Accessory

Grille

Duct Equivalent

Filter Kit

JX81D–Recirculating
Charcoal Filter Kit

To be used when
the Advantium oven
cannot be vented
to the outside.

For answers to your Monogram® or GE® appliance
questions, visit our website at geappliances.com
or call GE Answer Center® service, 800.626.2000.

A. Rectangular-To-Round 5 Ft.
Transition Adaptor

B. Wall Cap 40 Ft.

C. 90° Round Elbow 10 Ft.

D. 45° Round Elbow 5 Ft.

E. 90° Rectangular Elbow 25 Ft.

F. 45° Rectangular Elbow 5 Ft.

G. Roof Cap 24 Ft.

Specification Revised 7/13

Listed by
Underwriters
Laboratories

240452