GE Match, Match 2200, Match 3000 User Manual

Match

Uninterruptible Power Supply 2200 - 3000 VA

Manufactured by:

GE Digital Energy

General Electric Company Telephone +41 (0)91 / 850 51 51 CH – 6595 Riazzino (Locarno) Fax +41 (0)91 / 850 51 44 Switzerland Website www.gedigitalenergy.com

GE Digital Energy

Technology for the Digital World.

ver 2.0 - GB

Match UPS

LX: OPM_MAE_XXX_2K2_3K0_XGB_V020 1 GE DE Match 2200-3000: user manual 2.0 (GB)

GE Digital Energy

USER MANUAL

Match

Uninterruptible Power Supply

Uninterruptible Power SupplyUninterruptible Power Supply

Uninterruptible Power Supply

2200 - 3000 VA

2200 - 3000 VA2200 - 3000 VA

2200 - 3000 VA

Please read these instructions carefully before installation and st art-up of the Match UPS. Keep this manual in a safe place for future reference.

CONTENTS

1 INTRODUCTION............................................................................................................2

1.1 Introduction

1.2 Safety Rules

1.3 Transport / Storage

2 INSTALLATION..............................................................................................................2

2.1 Installation Rules

2.2 Installation Procedure

3 OPERATION...................................................................................................................4

3.1 Start-up

3.1.1 Start-up, mains available

3.1.2 Start-up, mains not available

3.2 Use: Normal Operation

3.2.1 Normal operating conditions

3.2.2 Load indication

3.2.3 Auto-off (no-load shutdown)

3.2.4 Battery test

3.2.5 Switching off

3.3 Use: Status and Alarm Indications

3.3.1 Charger on

3.3.2 Normal operation

3.3.3 AVR active

3.3.4 On battery

3.3.5 Battery low

3.3.6 Replace battery

3.3.7 Overload

3.3.8 High temperature

3.3.9 Programmed shutdown

4 COMMUNICATION ........................................................................................................7

4.1 RS232 Port

4.2 Relay Interface Card (option)

4.3 SNMP Interface Card (option)

5 OPTIONAL FEATURES.................................................................................................8

5.1 Extended Runtime

5.2 PowerFLAG SerVICe Box for Modem Connection

6 MAINTENANCE..............................................................................................................7

6.1 General

6.2 Batteries

6.3 UPS Configuration Tool

7 TROUBLESHOOTING ...................................................................................................9

8 SPECIFICATIONS........................................................................................................10

LX: OPM_MAE_XXX_2K2_3K0_XGB_V020 2 GE DE Match 2200-3000: user manual 2.0 (GB)

GE Digital Energy

1.1 Introduction

The

GE (General Electric) Digital Energ y Match UPS

, an uninterruptible power supply, protects your

equipment from all forms of power interference, including complete power failures.

1.2 Safety Rules

CAUTION: RISK OF ELECTRICAL SHOCK

. After installation, the UPS system (UPS + battery pack) contains batteries. The appliance outlets may be electrically live, even when the UPS is disconnected from the mains.

The UPS contains potentially hazardous voltages. Do not open the UPS, there are no user serviceable parts inside.

All maintenance and service work, including replacement of the batteries, should be performed by qualified service personnel.

1.3 Transport / Storage

No liability can be accepted for any transport damage when the equipment is shipped in nonoriginal packaging.

Store the UPS in a dry location with the batteries in a fully charged state. Storage temperature must be within -20 +45 "C. If the unit is stored for a period ex ceeding 3 months, optim al battery lifetime is obtained if the storage temperature does not exceed 25°C.

If the unit is stored for an extended per iod of time, the batteries m ust be rechar ged periodically. Connect the battery pack to the UPS. Subsequently connect the unit to a wall outlet and recharge the batteries for 24 hours:

- if the storage temperature is within -20 and +30°C: every 3 months,

- if the storage temperature is within -20 and +45°C: every month.

The shipment contains a Match UPS, a battery pack, one mains power cord, two IEC male-f emale output cords, a data cable, a CD ROM and this manual. After unpac king, inspect the UPS for damage. If any damage is present please immediately notify the carrier and place of purchase.

IMPORTANT

Before making any connection and switching on the UPS, please check the following conditions:

your mains supply is 220 - 240 Volts and 50 or 60 Hz, and

the total power demand of the connected equipment does not exceed the rated output power of the UPS (indicated on the rating label) (7, fig. 1).

2.1 Installation Rules

The UPS is intended to be used in normal domestic and office situations.

Protect the UPS, according to the wiring rules, with a 16A D-type fuse.

The UPS must be powered from a single phase grounded wall outlet. Do not use extension cords.

Avoid locations that are excessively humid, near water, near heat sources or in direct sunlight.

The ambient temperature should not exceed 40"C. Optimal battery lifetime is obtained if the ambient temperature does not exceed 30"C.

If you stack the UPS and its battery pack, always place the UPS on top.

It is important that ventilation air can move freely around and through the unit. Do not block the air vents.

Do not plug appliances such as electric heaters, toasters and vacuum cleaners into the UPS.

Be careful when connecting laser printers: be sure that the demanded power does not exceed the capacity of the UPS.

The sum of the leakage currents of the UPS and the connected loads should not exceed 3.5mA.

1 - Introduction

2 - Installation

LX: OPM_MAE_XXX_2K2_3K0_XGB_V020 3 GE DE Match 2200-3000: user manual 2.0 (GB)

GE Digital Energy

2.2 Installation Procedure

1. Loosen the two screws and remove the pull relief (2a, fig. 1). Connect the DC connector of the battery pack (8, fig. 1) to the DC socket (2, fig. 1) of the UPS. Re-install the pull relief with the two screws. Using the DC socket of the battery pack (9, fig. 1) you can install a second, third, etc. pack. See fig. 2 and section 5.1.

2. Using the output cord(s) provided, connect the computer(s) to the appliance outlet(s) (1, fig. 1) of the UPS. Spread the loads over the appliance outlets as equally as possible. If you use a distribution box to connect more than one appliance per outlet, please note that the maximum AC-cur rent rating of each appliance outlet is 10Am ps ( outlets 1) or 16Amps (outlet 1a). An output cord to c onnect a load to outlet 1a is not shipped with the unit. See fig.

3. Connect the mains power cord to the mains input socket (5, fig. 1) of the UPS. See fig. 4.

4. Connect the mains power cord to a working, grounded AC wall socket outlet. See fig. 4. The green LED 'on' (10, fig. 6) will blink, and after 30 seconds illuminate continuously: the unit has switched on, output power is available.

5. For best results, allow the UPS to recharge the batteries during a period of approx. 2 hours. It is acceptable to use the UPS without first charging the battery, but the runtime may be reduced.

6. For advanced comm unication possibilities, the RS232 interf ace port (6, fig. 1) can be connected to a computer system and/or optional interface cards (3, fig. 1) can be added. See chapter 4.

fig. 2

fig. 3

fig. 4

12a23

282a

fig. 1

+ 7 hidden pages

GE Match, Match 2200, Match 3000 User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual