GE JTS5000DN, JTS5000BN, JTS5000EN, JTS5000FN, JTS5000SN Specification

JTS5000DN/BN/EN/FN/SN

GE® 30" Smart Built-In Self-Clean Convection Single Wall Oven with Never Scrub Racks

DIMENSIONS AND INSTALLATION INFORMATION

NOTE: Single wall ovens are NOT approved for stacking above or below another single wall oven.

NOTE: Wall coverings, countertops and cabinets surrounding the wall oven must be able to withstand a temperature of up to 200°F (94°C).

NOTE: If the cabinet in which the wall oven is installed does not have a solid bottom, two braces or runners must be installed to support the weight of the oven. The runners and braces must support up to 220 lbs (99 kg).

NOTE: Door handle protrudes 3" from door face. Cabinets and drawers on adjacent 45° and 90° walls should be placed to avoid interference with the handle.

ATTENTION INSTALLER: Electric wall ovens are NOT approved for installation with a plug and receptacle. They must be hard wired into an approved junction box.

F

E

23" min. door opening allowance for drop-down doors, and 30" min. allowance for side-swing doors.

Conduit

48"

D

		Cutout width
		28-1/2" MIN.
	9-1/2" MAX.	28-5/8" MAX.
	Cutout depth	A
	23-1/2" MIN
	Junction box	B
	location
	22" to	C
	bottom of
	junction box

Cutout height

27-1/4" MIN.

27-5/16" MAX.

Recommended cutout location from the floor

32-1/2"

30''

IMPORTANT: Before installing, consult installation instructions packed with product for current dimensional data.

KW RATING

	240V	4.2
	208V	3.2
	BREAKER SIZE		Suitable
	240V	20 Amps
			bracing
	208V	20 Amps	to support
			runners

Dimension and installation information are shown in inches.

C

L

2 x 4 or equivalent runners

level with bottom of cutout and flush with sides of cutout or solid bottom floor.

(must support 220 lbs.)

	JTS5000
Cabinet	30"
A - Overlap of oven at top of cutout	1"
B - Overlap of oven other side of edge of cutout	3/4"
C - Overlap of oven at bottom of cutout	1-1/4"
Oven
D - Install depth	23-1/2"
E - Overall height with trim	28-5/8"
F - Overall width	29-3/4"

ADA	Listed by
	Underwriters
	Laboratories
COMPLIANT

For answers to your GE Profile™ or GE Appliances
product questions, visit our website at geappliances.com
or call GE Answer Center® Service, 800.626.2000.	Specification Revised 10/20

JTS5000DN/BN/EN/FN/SN

GE® 30" Smart Built-In Self-Clean Convection

Single Wall Oven with Never Scrub Racks UNDERCOUNTER INSTALLATION

DIMENSIONS AND INSTALLATION INFORMATION

NOTE: 30" Single electric wall ovens are approved for installation below a countertop, and below certain gas and electric cooktops. Refer to the Approved Combinations Matrix available at geappliances.com for specific information.

NOTE: 30" Single electric wall ovens are approved for installation above 27" and 30" warming drawers.

ATTENTION INSTALLER: Electric wall ovens are NOT approved for installation with a plug and receptacle. They must be hard wired into an approved junction box.

IMPORTANT: Before installing, consult installation instructions packed with ALL products for current dimensional and combination data.

Gas or Electric Cooktops May Be Installed Over This Oven. See Cooktop Installation Instructions for Cutout Size.

See Label on Top of Oven for Approved Models.

25" (63.5 cm)

Top and/or Side Fillers May Be Necessary if Unit is Positioned Between Existing Cabinets. Be Sure They Are Attached Securely, Since They Will Anchor the Oven in the Cabinet.

3/4" (1.9 cm) Support Platform Required

240V/208V Junction Box Location (junction box may be in adjacent cabinet)

SIDE-BY-SIDE INSTALLATION			MUST SUPPORT 220 lbs. (99 kg) FOR SINGLE OVENS
(TWO OVENS IN SEPARATE CUTOUTS)			Side-bySide Installations
Center Line	Center Line	Install two ovens in separate cutouts.

Gas or Electric Connections for Gas Cooktop Must be Located in an Adjacent Accessible Location to the Right

22" (55.9 cm) min.	36" (91.4 cm)
Above Support	Countertop
Platform	Height
Must Match
Toekick Height
24" (61 cm)

4" (10.2 cm) Toekick

30.5" (77.5 cm) 30" models

27" (68.58 cm) 27" models

INSTALLATION BELOW A COOKTOP

Cooktop
Cutout – observe		Cutout – observe
all dimensions and		all dimensions and
requirements		requirements

2" (5.1 cm) min.

NOTE: One cooktop may be centered over either oven in the side-by-side installation.

IMPORTANT:

Maintain a minimum distance of 31 1/4" from the top surface of the countertop to the wall oven platform to ensure that the cooktop and wall oven do not interfere with each other (see picture).

2 1/2" min. (6.4 cm)

Cooktop

31 1/4" min.

(79.4 cm)

Wall Oven

	For answers to your GE Profile™ or GE Appliances	SIDE OVEN
	product questions, visit our website at geappliances.com
	or call GE Answer Center® Service, 800.626.2000.	Specification Revised 10/20