GE GFDN110ED Specification
GFDN110ED
2-1/2
12
Connection
Connection
4-1/2
GE® Series 7.0 Cu. Ft. Super Capacity Front Load Electric Dryer
Dimensions anD installation information (in inches)
electric Dryer rating
120V/240V 5600W, 24A, 60Hz
120V/208V 4400W, 22A, 60Hz
exhaust options: 4-way via rear, right, left and bottom.
circuit requirements: An individual, properly grounded
branch circuit, protected by a 30-amp circuit breaker or a timedelay fuse, is required.
note: Dryer wall outlet must be located within 36" of service
cord entry and accessible when dryer is mounted in position.
installation information : For complete information,
see installation instructions packed with your dryer.
27 32-3/16
39-3/8
4-3/8
For answers to your Monogram, GE Profile™ Series
or GE® Series appliance questions, visit our website
at geappliances.com or call GE Answer Center®
service, 800.626.2000.
1-3/4
Gas Pipe
3-1/2
Electrical
Listed by
Underwriters
Laboratories
Speci fication Revised 10/15
GFDN110ED
49-5/8
GE® Series 7.0 Cu. Ft. Super Capacity Front Load Electric Dryer
special installation requirements:
stac k e D i n stallation:
Brackets for stacking dryer over washer are not included with the dryer.
GEFLSTACK or part no. WE25X10018.
alcove or closet installation:
If your dryer is approved for installation in an alcove or closet, it will be
stated on a label on the dryer back.
The dryer MUST be exhausted to the outside.
Minimum clearances between dryer cabinet and adjacent walls or other
surfaces are: 0" either side, 3" front and rear.
Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52".
Closet doors must be louvered or otherwise ventilated and must contain a
minimum of 60 sq. in. of open area equally distributed. If this closet contains
both a washer and a dryer, doors must contain a minimum of 120 sq. in. of
open area equally distributed.
No other fuel-burning appliance shall be installed in the same closet with
a gas dryer.
Bathroom or BeDroom installation:
The dryer MUST be exhausted to the outdoors.
The installation must conform with the local codes, or in the absence of
local codes, with the National Electric Code and National Fuel Gas Code,
ANSI Z223 for gas dryers.
minimum clearance other than alcove or closet
installations:
Minimum clearances to combustible surfaces 0" both sides, 3" rear.
for more information on venting kits anD accessories,
please call 1-800-ge-cares.
stackeD Dimensions
(in inches)
24
3-1/4
1/2
peDestal Dimensions (in inches)
sBsD137hWW - White
This optional 13" pedestal raises the door
opening and height of the washer or dryer.
Feet on 13" pedestal allow it to adjust to
13-3/8" height.
13
79-5/8
27
28-3/4
For answers to your Monogram, GE Profile™ Series
or GE® Series appliance questions, visit our website
at geappliances.com or call GE Answer Center®
service, 800.626.2000.
Listed by
Underwriters
Laboratories
Speci fication Revised 10/15
Loading...