Over-the-Range Advantium oven
Dimensions (in inches)
CSA1201RSS
GE Café Series Advantium® 120 Above-the-Cooktop Oven
Dimension Information (in inches)
Important: Please read carefully. For personal safety,
this appliance must be properly grounded to avoid
severe or fatal shock.
Do not, under any circumstances, cut, deform, or
remove any of the prongs from the power cord.
Do not use with an extension cord.
Installation Information: This information is not
intended to be used for installing unit described.
Before installing, consult installation instructions
packed with product/kit for current dimensional data.
Minimum distance from
door hinge side to adjacent
wall should equal 1/2-inch.
25-1/2
66" MIN.
Mounting
height
from floor
13"
MAX.
12"
MIN.
15-1/2"
MIN.
width
required
Exhaust outlet
connects to
3-1/4" X 10" duct
240V and 120V outlets
need to be spaced on
the side if the desire is
to setup with top
exhaust.
A
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
geappliances.com or call GE Answer Center®
service, 800.626.2000.
100˚
Door open
(without obstruction)
15-3/4"
16-1/4"
(Rear)
30"
Note: Outside venting is optional. Vent (duct) can be horizontal or vertical.
Cabinet Front
Cabinet Bottom Shelf
Oven Top
SIDE VIEW A-A
Filler Block
Equivalent
to Depth of
Cabinet Recess
Self-Aligning Screw
A
This distance can
NOT exceed 2” to
ensure proper
installation with
the provided
screws.
Listed by
Underwriters
Laboratories
Specification Revised 7/13
240451
CSA1201RSS
GE Café Series Advantium® 120 Above-the-Cooktop Oven
Dimension Information (in inches)
Hood Exhaust Duct
Outside ventilation requires a HOOD EXHAUST DUCT. Read the following carefully.
EXHAUST CONNECTION:
The hood exhaust has been designed to mate with a standard 3-1/4” x 10”
rectangular duct.
If a round duct is required, a rectangular-to-round transition adaptor must be used.
Do not use less than a 6” diameter duct.
REAR EXHAUST:
If a rear or horizontal exhaust is to be used, care should be taken to align exhaust
with the space between studs, or wall should be prepared at the time it is constructed
by leaving enough space between the wall studs to accommodate exhaust.
MAXIMUM DUCT LENGTH:
For satisfactory air movement, the total duct length of
3-1/4” x 10” rectangular or 6” diameter round duct should
not exceed 140 equivalent feet.
ELBOWS, TRANSITIONS, WALL AND ROOF CAPS, etc.,
present additional resistance to airflow and are equivalent
to a section of straight duct which is longer than their
actual physical size. When calculating the total duct length,
add the equivalent length of all transitions and adaptors plus
the length of all straight duct sections. The chart below
shows the approximate feet of equivalent length of some
typical ducts.
Filter Kit Accessory
Grille
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
geappliances.com or call GE Answer Center®
service, 800.626.2000.
Filter Kit
JX81D–Recirculating
Charcoal Filter Kit
To be used when
the Advantium oven
cannot be vented
to the outside.
Duct Equivalent
A. Rectangular-To-Round 5 Ft.
Transition Adaptor
B. Wall Cap 40 Ft.
C. 90° Round Elbow 10 Ft.
D. 45° Round Elbow 5 Ft.
E. 90° Rectangular Elbow 25 Ft.
F. 45° Rectangular Elbow 5 Ft.
G. Roof Cap 24 Ft.
Listed by
Underwriters
Laboratories
Specification Revised 7/13
240451