GE CGY366SELSS Specification Sheet
CGY366SELSS
GE Café™ Series 36" All Gas Professional Range with 6 Burners (Natural Gas)
DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
NOTE: Professional ranges offer a number of choices
in size and cooktop configurations. All Professional
Ranges are factory set for natural gas.
NOTE: Conversion kits are included with the range.
High Altitude kit, WB28K10553 for operation above
6,000 feet (for Natural and LP gas models), is also
available. The kits must be installed by a qualified
service technician at additional cost.
INSTA L LATIO N I NFO R MATION : Before
installing, consult installation instructions packed
with product or online at geappliances.com for
current dimensional data.
A suitable 36" or wider vent hood is required
for installation over ranges with a grill and
recommended for all other ranges.
ADVANCE PLANNING: Refer to dimensional
drawings for appropriate placement and necessary
clearances when planning the installation.
- Working areas adjacent to the range should have
18" minimum clearance between countertop and
cabinet bottom.
- Clearance between range and side wall or
combustible material must be at least 12" on
each side.
- Installation must conform with local codes.
In the absence of local codes, the range must
comply with the National Fuel Gas Code,
ANSI Z223.1-1990.
1 1/2"
35 7/8" width
35 1/4"
to
36 3/4"
height
28 1/4"
Depth
to front
of door
Countertop
to Cooking
Surface
3 1/4"
to 4 3/4"
Toekick/leg
height
WAR N I N G : Installations without a hood require
48" minimum to combustibles. A custom hood
installation with exposed horizontal combustible
surfaces must have an Auto-On feature. Refer to
hood installation instructions for specific hood
clearances.
The surface of the entire back wall above the range
and below the hood must be covered with a noncombustible material such as metal, ceramic tile,
brick, marble or other stone.
13"
max.
18"
min.
12" minimum
to adjacent wall
48" minimum
to combustibles
Non-Combustible
Material
12" minimum
each side
36" min.
ADDITIONAL CLEARANCES:
Allow 12" minimum clearance to an adjacent wall
on each side.
Working areas adjacent to the rangetop should have
18" minimum clearance between countertop and
the bottom of the wall cabinet.
For answers to your Monogram, GE Café™ Series, GE Profile™ Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center® Service, 800.626.2000.
All GE Appliances ranges are equipped
with an Anti-Tip device. The installation
of this device is an important, required
step in the installation of the range.
Listed by
Underwriters
Laboratories
Speci fication Revised 10/17
CGY366SELSS
Universal Utility Locations
A
GE Café™ Series 36" All Gas Professional Range with 6 Burners (Natural Gas)
DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
ELECTRICAL REQUIREMENTS: Ranges must
be hooked up to a 120V, 60Hz properly grounded
dedicated circuit protected by a 15-amp circuit
breaker or time-delay fuse.
GAS SUPPLY: The natural gas models are
designed to operate at 5" water column pressure.
For proper operation, the pressure of the natural
gas supplied to the regulator must be between 7"
and 13" water column.
The LP models are designed to operate at 10"
water column pressure. For proper operation, the
pressure of the LP gas supplied to the regulator
SIDE VIEW WITH BACKSPLASH
28-7/8"
10-1/2"
13/16"
to Front
Edge
must be between 11" and 13" water column.
OPTIONAL BACKSPLASH ACCESSORIES:
The range requires a 12" minimum clearance
to a vertical combustible surface at the rear. A
Optional
Backsplash
ccessories
backsplash is required for installations with less
than 12" clearance. The following backsplash
accessories are available, or a custom, noncombustible backsplash can be used.
Order one with a 36"-wide range backsplash
UXADJB36PSS – 30"-36" adjustable-height
backsplash with warming shelf
30-36"
35-1/4"
to
36-3/4"
12"
1-1/2"
3-3/16"
Control Panel
Depth
28-1/4" to
Beveled
Edge of Control
Panel Bullnose
27-1/2" to
Beveled Edge
- Maximum
Adjacent
Cabinet Depth
for
Flush
Installation
7" Control
Panel Height
UNIVERSAL UTILITY LOCATIONS
4 5/8"
3"
13 3/8"
G/E
11 3/8"
G/E
2"
36"
6 1/2"
28-1/4"
to Front of
For answers to your Monogram, GE Café™ Series, GE Profile™ Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center® Service, 800.626.2000.
Door
31-1/16"
to Front of
Handle
48-1/4"
with Oven Door
Open
All GE Appliances ranges are equipped
with an Anti-Tip device. The installation
of this device is an important, required
step in the installation of the range.
Listed by
Underwriters
Laboratories
Speci fication Revised 10/17
Loading...