GE AQP05 Owner’s Manual
Model: AQP05
Air Conditioner
Owner’s Manual
Important Safety Information
Operating Instructions
The Controls on Your Air Conditioner
Care of Product
Installation Instructions
Important Electrical Safety
Window Installation
Helpful Information
Things That Are Normal
3
4
7
12
If Something Goes Wrong
Before You Call for Service
GE Service Numbers
Warranty
GE Answer Center
®
800.626.2000
GE Appliances
13
Welcome
Welcome to the GE family. We’re
proud of our quality products and
we believe in dependable service.
You’ll see it in this easy-to-use
manual and you’ll hear it in the
friendly voices of our customer
service department.
Best of all, you’ll experience
these values each time you enjoy
the comfort of your air conditioner.
That’s important, because your
new air conditioner will be part of
your family for a long time.
Start Here!
Before using
your air
conditioner
Staple your receipt to the inside back
cover of this manual. You will need it
to obtain service under warranty.
Write down the model and serial
numbers here.
in the middle of the air conditioner below the air discharge area.
Model number
Serial number
Date of purchase
They are on a label
Need Help?
Help us
help you
800.626.2000
2
Before you call for service,
there are a few things you can
do to help us serve you better.
Read this manual.
instructions to help you use and
maintain your air conditioner
properly.
Save time and money.
section titled “If Something Goes
Wrong” before calling. This section was designed to solve common
problems that might occur.
It contains
Check the
If you do need service, you can
relax knowing help is only a phone
call away. Toll-free customer service
numbers are included in the back
of this manual. Or call the
Answer Center
24 hours a day, 7 days a week.
®
at 800.626.2000,
GE
Important Safety Information
Read all safety information before using
• This air conditioner must be
properly installed in accordance
with the Installation Instructions
before it is used.
• Repair or replace immediately
all electric service cords that have
become frayed or otherwise
damaged.
Extension Cord
If an extension cord is required to
reach the nearest wall receptacle,
use only a UL Listed, 3-wire,
grounded, 14 gauge, 15A, 125V
appliance extension cord. For
models with nameplate ratings
greater than 12 amperes, do not
use an extension cord.
• Turn the mode control knob
to
OFF
and unplug your air
conditioner before making any
repairs.
NOTE:
that any servicing be performed by
a qualified individual.
We strongly recommend
Adapter Plug
Because most 2-prong outlets are
not grounded, we strongly advise
against using an adapter plug.
However, a temporary connection
may be made where local codes
permit and if the 2-prong wall outlet is properly grounded.
This is a temporary method.
UL-listed adapters are available at most hardware stores.
When you plug the adapter in,
make sure the larger prong goes
into the larger slot to provide the
proper polarity for the power cord.
SAVE THESE INSTRUCTIONS
FOR PROPER GROUNDING:
1 Screw the adapter to the outlet,
using the outlet cover screw.
2 Ground the outlet through the house
wiring.
When disconnecting the power
cord from the adapter, hold the
adapter close to the outlet while
pulling the plug out. If this is not
done, the grounding connector is
likely to break with repeated use.
If the grounding connector breaks,
DO NOT USE
until a proper ground has again
been made.
the air conditioner
3
The
controls
on your
Operating Instructions
TEMP CONTROL MODE CONTROL
3
2
4
5
OFF
FAN
LOW
COOL
MED
COOL
HIGH
COOL
air
1
6
conditioner
1
1
Temp Control Mode Control
The temp control is used to maintain
the room temperature. The compressor will
cycle on and off to keep the room at the same
level of comfort. The higher the number
selected, the cooler the indoor air will become.
The blower runs as long as the mode control is
not on
OFF
.
2
HIGH COOL, MED COOL
cooling with different fan speeds.
FAN
provides air circulation and filtering
without cooling.
NOTE:
If you move the switch from a cool setting to
OFF or to the FAN setting, wait at least 3 minutes
before switching back to a cool setting.
2
and
LOW COOL
provide
4
Cooling Descriptions
FOR NORMAL COOLING
Select
thermostat at 3.
MED COOL
with the
3
FOR MAXIMUM COOLING
Select
thermostat at 6.
HIGH COOL
with the
FOR QUIETER & NIGHTTIME COOLING
Select
thermostat at 3.
LOW COOL
with the
3
Air Direction
Fingertip pressure on the louvers adjusts the
air direction up or straight ahead.
5
Loading...