GE AHD14AA, AHD20AA, AHD25AA, AHD30AA, AHD40AA Use and Care Guide

—.
HowtogetYour
the best from
Dehu~d~er
Use and Care of models
AHD
11 1
11
———
-
ml
.—==—-—===-
~––-----”---—
1“”11
II
I
‘Inlll I
I I
AHD20M
i
AHD25AA AHD30M AHD40AA
Energy-saving tips Operating the control
~eaning
Questions? Use the Problem Solver
14AA
the air filter
p2 p4
p5
p6
GENERAL
}hur
‘Ihe
@
ELECTRIC
~
=————
——
———
=——
[)irect line to General Electric
(;E inswer
(’enteF800.626.200()
~PO~ANT
Contents
Energy-Saving Tips . . . ........2
Important Safety Instructions. ...2
Electrical Safety . . . . . . ........3
Operating Your
Dehumidifier . . . . . .......4, 5
Care & Cleaning . . . . . ........5
The Problem Solver . . . ........6
If You Need Service . . . ........7
Warranty . . . . Back Cover
Ene~y-Saving ~ps
Keep the air filter clean. (See
instructions on
Keep the dehumidifier at least 10 inches away from the wall to ensure adequate air flow.
Do not block the front of the dehumidifier when it is operating. If you do, air flow essential to efficient operation will be restricted.
Close all doors and windows in the room being dehumidified.
Incoming moisture-laden air will reduce the dehumidifier’s
effectiveness.
page
6.)
Help us help you...
Read this book carefully.
It is intended to help you operate and maintain your dehumidifier properly.
Keep it handy for answers to your questions.
If you don’t understand something or need more help, write (include your phone number):
Consumer Affairs General Electric Company Appliance Park
Louisville. KY 40225
Write down the model and serial numbers.
You’ll find them on a label on the
side wall of the dehumidifier when the water collection bucket is removed.
These numbers are also on the Consumer Product Ownership Registration Card that came with your dehumidifier. Before sending in this card, please write these numbers here:
Model Number
Serial Number
SAFETY
~STRUCTIONS
When using this appliance, always exercise basic safety precautions, including the following:
o
Use this appliance only for its
intended purpose
this Use and Care Book.
This d~hu~idifier
properly grounded before it is used.
See
grounding instructions
on page 3.
Never operate this appliance
in an area that
accumulate standing water.
this condition develops, for your safety
dismnnect the
before stepping into the water.
Never unplug the dehumidifier
by pulling on
Always grip the plug firmly and pull it straight out
* Repair all ei@ric
or
repiace
service cords that have become damaged.
Do not use a cord that shows cracks or abrasion damage along its plug
lengti
or
connector end.
as described in
m~t
be
is
likely
to
power supply
the
power cord.
fmm
the outlet.
immediately
frayed
or otherwise
or at either the
If
Use these numbers in any correspondence or service calls concerning your dehumidifier.
If you received a damaged
dehumidifier,
the dealer (or builder) that sold you
the dehumidifier.
Save time and money. Before you
request service,
Solver on page 7. It lists minor
causes of operating problems that
you can correct yourself.
immediately contact
check the Problem
2
SAVE
T-E
mSTRUCTIONS
Electrical safety–IMPORTANT... Please Read Carefully
How to connect electricity
For personal safety, this appliance must be properly grounded.
The power cord on this appliance has a three-prong (grounding) plug that mates with a standard three-prong (grounding) wall outlet (Fig. minimize the possibility of electric shock hazard from this appliance.
PREFERRED METHOD
,
n
INSURE PROPER
GROUNO
Fig. 1
BEFORE USE
l)to
\h’
@
%
Q
4\
EXISTS
Use of adapter plug
(115-volt
Because of potential safety hazards under certain conditions, we
strongly recommend against use of an adapter elect to use an adapter, where local codes permit, a TEMPORARY
CONNE~ION
properly grounded two-prong wall outlet by use of a (Fig. 2) available at most local hardware stores.
TEMPORARY METHOD
modelsonly)
plug.
(AOAPTER
PLUGS NOT
PERMITTED IN
However, if you still
maybe made to a
UL listed adapter
CANAOA)
Use of extension
not
recommended
Because of potential safety hazards under certain conditions, we
strongly recommend against the use of an extension cord. However, if you still elect to use an extension cord, it is absolutely necessary that it be a UL listed 3-wire grounding type appliance extension cord and that the current carrying rating of the cord in amperes be equal to or greater than the branch circuit size shown on the rating nameplate of the appliance. Such extension cords are obtainable through your local service organization
cor~
Where a standard two-prong wall outlet is encountered, it is your personal responsibility and obligation to have it replaced with a properly grounded three-prong wall outlet.
The larger slot in the adapter must be aligned with the larger slot in the wall outlet to the connection of the power cord.
CAUTION:
ground terminal to wall outlet cover screw does not ground the appliance unless cover screw is metal, and not insulated, and wall outlet is grounded through house wiring. You should have the circuit checked by a qualified electrician to make sure the outlet is properly grounded.
When disconnecting the power cord from the adapter,
hold the adapter with one hand. If this is not done, the adapter ground terminal is very likely to break with repeated use.
Should the adapter ground terminal break, DO until a proper ground has again been established.
prov ide
proper polarity in
Attaching adapter
N~
USE the appliance
always
3
Loading...
+ 5 hidden pages