840173100
IRON
FER À REPASSER
PLANCHA
g
READ BEFORE USE
LIRE AVANT L’UTILISATION
LEA ANTES DE USAR
For Customer Assistance, call Customer Service at
1-877-207-0923 (US) or 1-877-556-0973 (Canada)
Pour l’assistance à la clientèle au Canada : 1-877-556-0973
Para comunicarse con Asistencia al Cliente en México: 01-800-343-7378
Le invitamos a leer cuidadosamente este instructivo antes de usar su aparato.
840173100 Ev02 12/11/07 1:11 PM Page 1
When using your flatiron, basic safety precautions should always be followed, including
the following:
This product is intended for household use only.
WARNING! Shock Hazard: This appliance has a polarized plug (one wide blade) that reduces the
risk of electric shock. The plug fits only one way into a polarized outlet. Do not defeat the safety
purpose of the plug by modifying the plug in any way or using an adaptor. If the plug does not
fit, reverse the plug. If it still does not fit, have an electrician replace the outlet.
Use the iron on an ironing board. Ironing on any other surface may damage that surface.
Do not iron or vertical steam clothes that are being worn.
Do not use vertical steam in the direction of people or pets.
READ ALL INSTRUCTIONS BEFORE USING
1. Use iron only for its intended use.
2. Verify that the voltage in your home corresponds to that of your appliance.
3. To protect against risk of electric shock, do not immerse the iron in water or other liquids.
4. The iron should always be turned to OFF before plugging or unplugging from outlet. Never
yank cord to disconnect from outlet; instead, grasp plug and pull to disconnect.
5. Do not allow cord to touch hot surfaces. Let iron cool completely before putting away. Loop
cord loosely around iron when storing.
6. Always disconnect iron from electrical outlet when filling with water or emptying and when
not in use.
7. Do not operate iron with a damaged cord or if the iron has been dropped or damaged. To
avoid the risk of electric shock, do not disassemble the iron. Call our toll-free customer service
number for information on examination and repair. Incorrect reassembly can cause a risk of
electric shock when the iron is used.
8. Close supervision is necessary for any appliance being used by or near children. Do not leave
iron unattended while connected or on an ironing board.
9. Burns can occur from touching hot metal parts, hot water, or steam. Use caution when you
turn a steam iron upside down – there may be hot water in the reservoir.
SPECIAL INSTRUCTIONS
1. To avoid a circuit overload, do not operate another high wattage appliance on the same
circuit.
2. If an extension cord is absolutely necessary, a 10-ampere cord should be used. Cords rated
for less amperage may overheat. Care should be taken to arrange the cord so that it cannot
be pulled or tripped over.
2
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS!
OTHER CONSUMER SAFETY INFORMATION
840173100 Ev02 12/11/07 1:11 PM Page 2
3
• During first use of iron, it may appear to smoke. This will stop and does not indicate
a defect or hazard.
• Steam vents should be cleaned before first use. Prepare iron for steam ironing, then
iron over an old cloth for a few minutes while letting the iron steam. Press the Blast
button several times. This will clean the vents. Then follow the Self-Clean instructions
(see page 5) beginning with Step 3.
• Many irons spit or sputter during the first few uses with tap water. This happens as
the steam chamber becomes conditioned. This will stop after a few uses.
BEFORE FIRST USE
PARTS AND FEATURES
Fabric
Setting
Indicator
Water Tank
Fill Cover
Spray Nozzle
Water Tank
Self Clean
Button
Soleplate
Power ON Light/
Auto Shutoff
Status Indicator
Heel Rest
Spray/Blast Buttons
Retractable Cord*
Cord Release Button*
Temperature Selector/
Auto Shutoff Reset Button*
*on selected models
Adjustable
Steam
840173100 Ev02 12/11/07 1:11 PM Page 3
4
1. Unplug iron. Open water tank fill cover. Using a cup, slowly pour 10 ounces (310 ml)
of tap water into the water tank opening. Close water tank fill cover.
2. Plug in iron.
3. Press Temperature Selector. With iron in an upright position, set Fabric Setting
Indicator to desired setting in steam range. Allow 3 minutes for iron to reach desired
temperature. Do not preheat the iron with the soleplate facing down.
4. Set Adjustable Steam to desired steam output.
5. To turn iron off, turn Adjustable Steam to Dry Iron. Press Temperature Selector.
Set Fabric Setting Indicator to OFF (O) and unplug iron.
6. Empty water from the iron following directions in “Caring for Your Iron and Soleplate.”
Water
Please use ordinary tap water. If you have extremely hard water, alternate between
tap water and distilled water for use in the iron.
1. Plug iron into outlet.
2. Turn Adjustable Steam to Dry Iron.
3. Set Fabric Setting Indicator to desired temperature. Allow three minutes for iron to
reach desired temperature.
4. To turn iron off, set Fabric Setting Indicator to OFF (O) and unplug iron.
Ironing Instructions
Dry iron on reverse side of fabric.
Dry iron on reverse side of fabric.
Dry iron on reverse side of fabric.
Iron while fabric is still damp.
Iron on reverse side of fabric.
Steam iron on reverse side of fabric.
Iron while still damp using steam and/or spray.
Iron on reverse side of fabric while still damp.
Temperature Setting
Off 0
Nylon 1
Acrylic 2
Silk 2
Polyester 3
Rayon 4
Wool 4
Cotton 5
Linen 6
Steam
Setting
TO DRY IRON
TO STEAM IRON
FABRIC SETTING CHART
840173100 Ev02 12/11/07 1:11 PM Page 4
5
Iron
1. The Water Tank of your iron should be emptied after each use. Set Fabric Setting
Indicator to OFF ( O). Unplug the iron and hold over a sink. Turn iron upside down
until Water Tank Opening is parallel with sink. Water will run out of water tank
opening.
2. After iron has completely cooled, fully retract cord into iron and store in an upright
position. Do not store iron laying flat on soleplate.
Soleplate
1. Never iron over zippers, pins, metal rivets, or snaps, as these may scratch the
soleplate.
2. To clean occasional build-up on the soleplate, wipe with a sudsy cloth. Do not use
abrasive cleansers or metal scouring pads.
3. Always store iron upright in the heel rest position.
Self-Clean
To keep the steam vents clear of any build-up, follow these instructions each time
you iron using steam.
1. Set Fabric Setting Indicator to OFF ( O). Fill iron with water to 1⁄2 of its maximum
capacity.
2. Set Adjustable Steam to Dry Iron position. Set Fabric Setting Indicator to Linen
setting and let iron heat for 2 minutes.
3. Set Fabric Setting Indicator to OFF ( O ). Unplug iron and hold over a sink with
soleplate facing down.
4. Press and hold the Self Clean Button. Boiling water and steam will flow out of steam
vents. Allow all water to drain from iron.
5. Gently move iron front to back to allow water to clean entire soleplate area.
6. If water still remains inside of soleplate, reheat iron as indicated in Step 2. Boiling
water and steam could still flow out of steam vents.
CARING FOR YOUR IRON
Blast of Steam and Spray Buttons
Push Steam Button for an extra blast of steam. Push Spray Button to release a fine
spray of water for difficult wrinkles in cotton or linen.
FEATURES
(on selected models)
Spray
Steam
840173100 Ev02 12/11/07 1:11 PM Page 5
6
Automatic Shutoff Status Indicator
If the iron is an Automatic Shutoff model, the light comes on when iron is first plugged in.
After 1 hour the iron will shutoff and the light will go out.
Press the Temperature Selector to turn the iron back on for
another hour of ironing.
Quick Off
Press and hold the Temperature Selector for three seconds to turn the iron off quickly.
Retractable Cord
1. Pull cord to desired length. Do not
unwind cord beyond colored tape
indicator on cord.
FEATURES
(cont.)
Auto Shutoff
Status
Indicator
Vertical Steam
1. Follow Steps 1 through 3 in “To Steam Iron.”
2. Hang garment in a location that is not susceptible to damage
from heat or moisture. Do not hang in front of wallpaper,
window, or mirror.
3. Hold iron about 6 inches away from garment. Press and
release Blast Button to steam out wrinkles. Do not press Blast
Button more than once every 2 seconds.
4. To turn iron off, turn Adjustable Steam to Dry Iron. Set Fabric
Setting Indicator to OFF
( O). Unplug iron.
5. Empty water from iron following directions in “Caring for Your Iron.”
NOTE: Do not allow hot soleplate to touch delicate garments.
Temperature
Selector
2. To store cord, press and hold Cord
Release Button while guiding cord into
storage area. CAUTION: Hold plug while
retracting cord.
Do not let cord
retract freely. Cord
may jam on reel or
loose cord may whip
back and forth and
could cause injury.
840173100 Ev02 12/11/07 1:11 PM Page 6
7
PROBLEM
Iron won’t heat.
Water is leaking
out of the iron.
Iron won’t steam.
Iron leaves spots
on clothing.
Retractable cord
will not unwind (on
select models).
THINGS TO CHECK
• Is the iron plugged in and the outlet working?
Check the outlet by plugging in a lamp.
• Is the Temperature Control turned to a fabric setting?
• If auto shutoff model, is light on? If not, push Reset Button.
• Do not overfill the water tank.
• If steam ironing, is Adjustable Steam in a steam position,
Fabric Setting Indicator in the steam range and did the
iron have enough time to preheat?
• If dry ironing, make sure the Adjustable Steam is in the
DRY IRON position.
• Check the water level.
• Is the Adjustable Steam Switch in the STEAM position?
• Has the iron had enough time to preheat?
• ALWAYS empty the water tank of the iron after using.
Water left in the tank may discolor clothing and soleplate.
• Rewind a small amount of cord then fully depress the Cord
Release Button and pull the cord to desired length.
TROUBLESHOOTING
840173100 Ev02 12/11/07 1:11 PM Page 7
If you have a claim under this warranty, please call our Customer Assistance Number.
For faster service please have model, series, and type numbers ready for operator to
assist you. These numbers can be found on the bottom of your appliance.
MODEL: ________________ TYPE: _________________ SERIES: ________________
Customer Assistance Number 1-877-207-0923 (US) or 1-877-556-0973 (Canada)
Keep these numbers for future reference!
For more information, please visit us at www.walmart.com
Two-Year Limited Warranty
What does your warranty cover?
• Any defect in material or workmanship.
For how long after the original purchase?
• Two years.
What will we do?
• Provide you with a new one.
• For those items still under warranty but no
longer available, WAL-MART reserves the
right to replace with a similar GE branded
product of equal or greater value.
How do you make a warranty claim?
• Save your receipt.
• Properly pack your unit. We recommend
using the original carton and packing
materials.
• Return the product to your nearest
WAL-MART store or call Customer
Assistance at 1-877-207-0923 (US) or
1-877-556-0973 (Canada).
What does your warranty not cover?
• Parts subject to wear, including, without
limitation, glass parts, glass containers,
cutter/strainer, blades, seals, gaskets,
clutches, motor brushes, and/or agitators,
etc.
• Commercial use or any other use not found
in printed directions.
• Damage from misuse, abuse, or neglect,
including failure to clean product regularly
in accordance with manufacturer’s
instructions.
How does state law relate to this warranty?
• This warranty gives you specific legal
rights, and you may also have other rights
which vary from state to state or province
to province.
• THIS WARRANTY IS IN LIEU OF ANY OTHER
WARRANTY OR CONDITION, WHETHER
EXPRESS OR IMPLIED, WRITTEN OR ORAL,
INCLUDING, WITHOUT LIMITATION, ANY
STATUTORY WARRANTY OR CONDITION OF
MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE.
• WAL-MART, GE, AND THE PRODUCT
MANUFACTURER EXPRESSLY DISCLAIM ALL
RESPONSIBILITY FOR SPECIAL, INCIDENTAL,
AND CONSEQUENTIAL DAMAGES OR LOSSES
CAUSED BY USE OF THIS APPLIANCE. ANY
LIABILITY IS EXPRESSLY LIMITED TO AN
AMOUNT EQUAL TO THE PURCHASE PRICE
PAID WHETHER A CLAIM, HOWEVER
INSTITUTED, IS BASED ON CONTRACT,
INDEMNITY, WARRANTY, TORT (INCLUDING
NEGLIGENCE), STRICT LIABILITY, OR OTHERWISE. SOME STATES OR PROVINCES DO NOT
ALLOW THIS EXCLUSION OR LIMITATION OF
INCIDENTAL OR CONSEQUENTIAL LOSSES
SO THE FOREGOING DISCLAIMER MAY NOT
APPLY TO YOU.
What if you encounter a problem with this
product while using it outside the country
of purchase?
• The warranty is valid only in the country of
purchase and you follow the warranty
claim procedure as noted.
CUSTOMER SERVICE
is a trademark of General Electric Company
and is used under license by
WAL-MART Stores, Inc., Bentonville, AR 72716
g
Marketed in Canada by:
Wal-Mart Canada Corp.
1940 Argentia Road, Mississauga, Ontario L5N 1P9
840173100 Ev02 12/11/07 1:11 PM Page 8
Loading...