GE 15091 User Manual

7-Day Digital Timer

User Instructions

A WARNING - Risk of fire or electric shock

• For indoor use only in dry locations.

• Do not exceed capacity.

• Do not use tinier with devices that could have dangerous conse
quences due to inaccurate timing, such as sun lamps, heaters, etc.

• Plug directly into receptacle.

NOTICE

> No user serviceahle parts.

1—Charge the Battery

Plug timer into wall outlet for a few minutes to charge internal battery.

NOTE- If it would be easier, you can now unplug the timer to set it.

2—Clear the Memory

Press the RESET button with a pencil or paper clip to erase any previous settings.

3—Select AM/PM Format

1. Press and hold the CLOCK button for about 5 seconds until display shows 24H
or 12H,then release.

2. Press the HOUR button as many times as necessary to change display to
"12H".

3. Press the CLOCK button to restore the normal clock display. The letters "AM"
should show in upper left corner of the display.

4—Set Time of Day

1. Press and hold the CLOCK button.

2. At the same time, press the HOUR and MINUTE buttons as necessary to
advance the display to the correct time.

3. Hold down the OAYS button until the display shows the correct day.

5—Set ON/OFF Times

1. Press the PROGRAM button once to display the first ON/OFF setting—
"1 ON

2. Press the MINUTE and HOUR buttons as necessary to set the ON time you
want.

3. Press the OAYS button as necessary to choose the day or group of days you
want for the time setting.

4. Press the PROGRAM button again to display the second ON/OFF setting—"1
OFF--:--".

5. Repeat the procedure to create the OFF setting.

6. Repeat Steps 1 thru 5 for additional ON/OFF settings.

7. Press the CLOCK button to exit from PROGRAM mode.

Things to know about ON/OFF times:

• Repeatedly pressing the PROGRAM button cycles through the possible 20 ON/
OFF pairs: 2 ON, 2 OFF, 3 ON, 3 OFF, etc.

• The display panel automatically returns to time of day if you don't press any
buttons for 15 seconds.

• If you are interrupted before completing a setting, simply press the PROGRAM
button until you reach the setting where you left off.

6—Review ON/OFF Settings

It is important to review all 20 settings, even if you only used a few, to make
sure there are no extra, unintended settings.

1. Press the PROGRAM button (hold down to scroll) until the display cycles
through all 20 ON/OFF pairs.

2. Stop on any setting you want to remove or change.

To Revise a Setting

1. Press the PROGRAM button (hold down to scroll) until the display shows the
setting you want to revise.

2. Press the HOUR, MINUTE and WEEK buttons as necessary to revise the dis
played ON or OFF time and day(s).

To Remove or Restore a Setting

1. Press the PROGRAM button (hold down to scroll) until the display shows the
setting you want to remove or restore.

2. Press the RST/RCL button.

- If removing, the display will replace the setting with dashes.

- If restoring, the display will show the previous setting.

To Operate the Timer

1. After setting the timer, plug it in and connect the device to be controlled.

2. Press the ON/AUTO/OFF button as necessary to display:

ON—^The timer remains ON and ignores your settings.
OFF—^The timer remains OFF and ignores your settings.
AUTO—^The timer follows your settings.