Garmin Monterra, Oregon 600 Quick Start Manual
™
Monterra
Quick Start Manual
September 2013 190-01601-01_0B Printed in Taiwan
Introduction
WARNING
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
Device Overview
Camera
À
Microphone
Á
Power key
Â
LED flash
Ã
Volume keys
Ä
Battery cover D-ring
Å
Waterproof speaker
Æ
Headphone port (under weather cap)
Ç
Mini-USB port (under weather cap)
È
Battery Information
WARNING
The temperature rating for the device may exceed the usable
range of some batteries. Alkaline batteries can rupture at high
temperatures.
Do not use a sharp object to remove batteries.
Press the battery into place.
4
Replace the battery cover, and turn the D-ring clockwise.
5
Charging the Battery Pack
WARNING
This product contains a lithium-ion battery. To prevent the
possibility of personal injury or product damage caused by
battery exposure to extreme heat, store the device out of direct
sunlight.
NOTICE
To prevent corrosion, thoroughly dry the mini-USB port, the
weather cap, and the surrounding area before charging or
connecting to a computer.
Do not attempt to use the device to charge a battery that was
not provided by Garmin®. Attempting to charge a battery that
was not provided by Garmin can damage the device and void
the warranty.
Before you can connect the straight connector of the USB cable
to your device, you may have to remove optional mount
accessories.
NOTE: The battery will not charge when outside the
temperature range of 32° to 122°F (0° to 50°C).
NOTE: The battery will not charge when outside the
temperature range of 32° to 113°F (0° to 45°C).
You can charge the battery using a standard wall outlet or a
USB port on your computer.
Pull up the weather cap À from the mini-USB port Á.
1
CAUTION
Contact your local waste disposal department to properly
recycle the batteries.
NOTICE
Alkaline batteries lose a significant amount of their capacity as
the temperature decreases. Therefore, use lithium batteries
when operating the device in below freezing conditions.
Installing the Battery Pack
WARNING
This product contains a lithium-ion battery. To prevent the
possibility of personal injury or product damage caused by
battery exposure to extreme heat, store the device out of direct
sunlight.
Turn the D-ring counter-clockwise, and pull up to remove the
1
cover.
Locate the metal contacts on the end of the lithium-ion
2
battery.
Insert the battery into the compartment, contacts first.
3
2
Plug the small end of the USB cable into the mini-USB port.
2
Plug the USB end of the cable into the AC adapter or a
3
computer USB port.
Plug the AC adapter into a standard wall outlet.
4
When you connect the device to a power source, the device
turns on.
Charge the battery completely.
5
Removing the Battery Pack
WARNING
Do not use a sharp object to remove batteries.
Turn the D-ring counter-clockwise, and pull up to remove the
1
cover.
Loading...