Page 1
INSTALLATION SUPPLEMENT
In-Hull: 1kW for Model: M260
Chirp Models: M265LH, M265LM
Install Transducer in Tank Supplied
Patent http://www.airmar.com/patent.html
17-446-02 rev. 02 07/19/18
CAUTION: Install the transducer in the tank supplied. Although tanks may look alike, some
dimensions may differ. If you want to mount the transducer in a previously installed tank, replace
the UPPER section. Failure to install the transducer in the proper tank may result in the corners
of the transducer and/or tank breaking.
Replacing Upper Section of Tank
WARNING: Always wear safety glasses, a dust mask, and ear
protection when installing.
CAUTION: Do not over-tighten the socket-head cap screws to
avoid cracking the tank.
Allen
wrench
1. Disassemble the new tank supplied with the transducer. Using
the Allen wrench included, remove the four socket-head cap
screws, lock washers, and flat washers (Figure 1). Set them
aside. (To remove the Allen wrench from the handle of the
transducer, use a blade screwdriver.)
2. Using the Allen wrench supplied, remove the four socket-head
cap screws, lock washers, and flat washers from the previously
installed tank. Save them as spares. Discard the upper section
of the tank.
3. Be sure that the gasket is in place around the opening of the
lower section of the tank. Fasten the new upper tank to the
previously installed lower section to form a complete unit. Use
the four socket-head cap screws, lock washers, and flat
washers. Lightly tighten the socket-head cap screws that hold
the two sections of the tank together with a force not exceeding
50 in.-lb. Do not over-tighten. After use, replace the Allen
wrench in the recess in the transducer.
4. Follow the installation instructions that came with the
transducer, starting with “Installing the Transducer” on page 4.
Replacement Parts
Obtain parts from your instrument manufacturer or marine dealer.
Gemeco
Airmar EMEA
USA
Tel: 803-693-0777
email: sales@gemeco.com
Europe, Middle East, Africa
Tel: +33.(0)2.23.52.06.48
email: sales@airmar-emea.com
socket-head
cap screw (4)
lock washer (4)
flat washer (4)
upper section
of tank
gasket
lower section
of tank
Figure 1. Replacing upper section of tank
Copyright © 2013 Airmar Technology Corp.
35 Meadowbrook Drive, Milford, New Hampshire 03055-4613, USA
•
www.airmar.com
Copyright © 2013 - 2018 Airmar Technology Corp. All rights reserved.
Loading...