Fujitsu fi-4110CU User Manual
fi-4110CU Image Scanner
Operator’s Guide
C150-E194-01EN
FOR SAFE OPERATION
Treatment of This Manual
Since this manual contains important information for using the fi-4110CU, read it thoroughly before
using the product. Use the fi-4110CU only after thoroughly reading and understanding especially the
section "Important Alert Messages" in this manual. Keep this manual handy, and store it carefully.
Notice to
American Users
Federal Communications Commission
Radio Frequency Interference Statement
This equipment has been tested and found to comply with the lim its for a
Class B digital device, pursuant to Part 15 of FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
· Adjust or relocate the receiving antenna.
· Increase the distance between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different from the
circuit the receiver is connected to.
· Consult your dealer or an experienced radio/TV technician for help.
FCC warning:
party responsible for compliance could void the user's authority to operate
the equipment.
Changes or modifications not expressly approved by the
Notes
·
The use of a non-shielded interface cable with the referenced device is
prohibited. The length of the parallel interface cable must be 3 meters
(10 feet) or less. The length of the serial interface cable must be 15
meters (50 feet) or less.
· The length of the power cord must be 3 meters (10 feet) or less.
Fi-4110CU Image Scanner Operator’s Guide
Notice to
Canadian Users
This digital apparatus does not exceed the class B limits for radio noise
emissions from digital apparatus set out in the Radio Interference
Regulations of the Canadian Department of Communications.
This class B digital apparatus complies with Canadian ICES-003.
Le présent appareil numériqué n'émet pas de bruits radioélectnques
dépassant les limites applicables aux appareils numériques de la classe B
prescrites dans le Règlement sur le brouillage radioélectrique édicté par le
ministère des Comunications du Canada.
Cet appareil numérique de la classe B est conformme à la norme NMB003 du Canada.
Notice to
German Users
Bescheinigung des Herstellers/Importeurs
Hiermit wird bescheinigt, daß der/dieldas
· fi-4110CU in Übereinsstimmung mit den Bestimmungen der
· AmtsblVfg 243/1991 funkentstört ist. Der Deutschen Bundespost wurde
das Inverkehrbringen dieses Gerätes angezeigt und die Berechtigung
zur Überprüfung der Serie auf Einhaltung der Bestimmungen
eingeräumt.
Maschinenlärminformationsverordnung 3. GS GV, 18.01.1991:
·
Der höchste Schalldruckpegel beträgt 70 dB (A) order weniger
gemäß ISO/7779.
fi-4110CU Image Scanner Operator’s Guide i
Warning
: This equipment may cause electromagnetic interference. It has not been tested to show
compliance with AS3548 Class A equipment, which is designed to provide reasonable protection against
such interference.
Operation of this equipment in a residential area is likely to cause interference in which case the user at
his own expense will be required to take whatever measures may be required to correct the interference.
As an E
NERGYSTAR
this scanner meets E
NERGYSTAR
E
® Partner, Fujitsu Limited has determined that
NERGYSTAR
® guidelines for energy efficiency.
® is a U. S. registered mark.
Trademark Acknowledgment
Fujitsu is a registered trademark of Fujitsu Lim ited .
First Edition March 2001
The contents of this manual may be revised without prior notice.
The contents of this manual shall not be disclosed in any way or reproduced in any media without the
express written permission of Fujitsu Limited.
All Rights Reserved, Copyright Ó
FUJITSU LIMITED
2001
ii fi-4110CU Image Scanner Operator’s Guide
Preface
Thank you very much for your purchase of the fi-4110CU Image Scanner.
The fi-4110CU Image Scanner can read very fine color images.
As this manual explains the basic handling of the scanner, read it carefully to use the
scanner properly.
In this manual, the MicrosoftÒ Windows 98Ò Operating System is referred to as
Windows 98, the MicrosoftÒ Windows MEÒ Operating System is referred to as
Windows ME, and the MicrosoftÒ Windows 2000Ò Operating System is referred to as
Windows 2000.
Microsoft, Windows, and Windows NT are registered trademarks of Microsoft
Corporation of the U.S. in the United States and other countries.
Other company names or product names appearing in this manual are trademarks or
registered trademarks of individual companies.
fi-4110CU Image Scanner Operator’s Guide i
Important Notes to Users
Every user is requested to use this product including the manuals and software supplied
with the product at the user's own responsibility.
Fujitsu assumes no liability with respect to any damage or loss caused to data as the
result of using this product.
Please understand that the warranty range for failure of this product will never exceed
the amount of money paid by the user for the product.
Fujitsu prohibits any user from using software supplied with this product or any other
update software for this product for any purpose other than incorporation into this
product. Fujitsu also prohibits any user from reworking or disassembling such
software.
Warning on Use Requiring Extremely High Safety Levels
This Product is designed, developed and manufactured as contemplated for general use,
including without limitation, general office use, personal use and household use, but is
not designed, developed and manufactured as contemplated for use accompanying fatal
risks or dangers that, unless extremely high safety is secured, could lead directly to
death, personal injury, severe physical damage or other loss (hereinafter “High Safety
Required Use”), including without limitation, nuclear power core control, life support,
weapon launching control. You shall not use this Product without securing the
sufficient safety required for the High Safety Required Use. If you wish to use this
Product for High Safety Required Use, please consult with our sales person in charge
before such use.
Conventions for Alert Messages
This manual uses alert messages to prevent users and bystanders from being injured or
from suffering damage to their property. An alert message consists of an alert signal
and alert statements. The alert signals and their meanings are as follows.
This indicates a hazardous situation that could
result in serious personal injury if the user
does not perform the procedure correctly.
This indicates a hazardous situation that could
result in minor or moderate personal injury if
the user does not perform the procedure
correctly. This alert signal also indicates that
damage to the products or other property may
occur if the user does not perform the
procedure correctly.
ii fi-4110CU Image Scanner Operator’s Guide
Contents
CHAPTER 1 Notes Concerning Use ..................................................................... 1-1
1.1 Outline........................................................................................................... 1-1
1.1.1 fi-4110CU Image Scanner .......................................................................... 1-1
1.2 Confirming the Content of Packing Box ....................................................... 1-1
1.3 Component Names and Functions................................................................. 1-2
CHAPTER 2 Installation and Connection............................................................. 2-1
2.1 Notes Concerning Installation
2.2 Mounting the Document Support.................................................................. 2-2
2.3 Connection..................................................................................................... 2-3
2.3.1 Notes Concerning Connection.................................................................... 2-3
2.3.2 Confirming the System Conditions............................................................. 2-4
2.3.3 Connecting the Power Cable....................................................................... 2-4
2.3.4 Connecting to the Computer....................................................................... 2-5
2.3.5 Installing Device Driver and Software........................................................ 2-5
2.4 Setting up the Stacker and Document Support.............................................. 2-6
................................................................... 2-1
CHAPTER 3 Operation........................................................................................... 3-1
3.1 Notes Concerning Operation......................................................................... 3-1
3.2 Before Scanning or Copying a Document..................................................... 3-2
3.2.1 Confirming Document Condition............................................................... 3-3
3.2.2 Setting Documents...................................................................................... 3-4
3.3 Scanning Documents..................................................................................... 3-5
CHAPTER 4 Daily Maintenance ............................................................................ 4-1
4.1 Handling a Paper Jam.................................................................................... 4-1
4.2 Daily Maintenance......................................................................................... 4-2
4.3 Cleaning......................................................................................................... 4-3
4.3.1 Cleaning the Surface of the Scanner and
the Document Support ................................................................................ 4-3
4.3.2 Cleaning the Automatic Document Feeder................................................. 4-3
fi-4110CU Image Scanner Operator’s Guide iii
4.4 Consumables and Regular Replacement Components .................................. 4-6
4.4.1 Parts Number and Replacement Cycle of Consumables and
Regular Replacement Components............................................................. 4-6
4.4.2 Procedure for Replacing the Pad Unit......................................................... 4-6
4.4.3 Procedure for Replacing the Pick Roller Unit............................................. 4-7
CHAPTER 5 When You Suspect That a Fault Occurred......................................5-1
APPENDIX Installation Specifications............................................................... A-1
vi fi-4110CU Image Scanner Operator’s Guide
CHAPTER
Notes Concerning Use
1
This section provides an outline of the product and explains its characteristics and
components.
1.1 Outline
This section provides an outline of the fi-4110CU Image Scanner and explains its
characteristics.
1.1.1 fi-4110CU Image Scanner
The fi-4110CU Image Scanner can read very fine color images. It can also work with
attached software as follows:
·
Scan software enables the saving of data scan ned with the scan ner in TIFF form at
in a personal computer.
·
Copy software enables the output of data scanned with the scanner to the printer
connected to a personal computer.
The fi-4110CU Image Scanner has the following features:
·
High reliable ADF
Performs document feeding at a level equivalent to business scanners.
·
Reading of color images on both sides
Can simultaneously read both sides of a document in full color.
·
Compact body for easy installation
Easy to install due to the lightweight, compact main body.
1.2 Confirming the Content of Packing Box
The fi-4110CU Image Scanner is packed together with accessories in a packing box.
Take out the scanner and accessories from the packing box and confirm missing items
with the attached packing list.
If you find an item to be missing or defective, call your sales agency.
fi-4110CU Image Scanner Operator’s Guide 1-1
1.3 Component Names and Functions
This section shows the components of the scanner and expla in s thei r funct ions .
Front
Automatic document feeder
Stacker
Document support
Document guide
Operator panel
Copy density dial
Function No. display panel
Function button
Duplex button
Send to button
Scan button
Powe lamp
Component Name Function
Document support Accommodates documents to be read by the automatic
document feeder.
Document guide Holds documents so that they are transported straight.
Automatic document feeder
Reads documents automatically.
(ADF)
1-2 fi-4110CU Image Scanner Operator’s Guide
Component Name Function
Operator
panel
Copy density
dial
Function No.
display panel
Function button Selects a function to be started using this button.
Duplex button Switches between read modes. You can confirm the
Send to button Copies documents loaded in the document support.
Adjusts copy density (dark/light) in five stages.
Displays the Function No. or also displays the scanner
read mode as follows;
On: Single-side reading mode
Blink: Double-sided reading mode
Mark: An application is being activated
When the AC adapter is connected to the scanner or the
PC’s power is turned on, the initialization of scanner is
executed. The display on the panel changes as follows;
P ® 0 ® 1 (When 1 appears, scanner becomes ready)
This button’s function is set using Launch.
current read mode with the Function No. display panel.
Starts the operation specified by the Function button.
Scan button Scans the document placed in position.
Power lamp Stay s lit wh ile pow er is being sup pli ed.
Stacker Stacks the scanned documents.
Note:
Pressing the Send to or Scan button initiates the application software. The
displayed until the application software is ready. If the application software fails to get
ready and the function No. display is restored, the Send to or Scan processing is
canceled.
mark is
fi-4110CU Image Scanner Operator’s Guide 1-3
Back
Cover open lever
カバーオープンレバー
ACアダプタ用コネクタ
Interface connector
インタフェースコネクタ
Inlet
Component Name Function
Cover open lever Opens and closes the automatic document feeder.
Inlet Accommodates the AC adapter.
Interface connector Accommodates an interface cable to be connected to a
personal computer. (Type B connector)
Internal
Feed roller
Eject roller
Component Name Function
Feed roller, eject roller,
Sends documents.
facing roller
Plastic roller
Facing roller
1-4 fi-4110CU Image Scanner Operator’s Guide
Loading...