Fujitsu D3035 data sheet
Data Sheet FUJITSU LAN Adapter D3035 Server
Data Sheet
FUJITSU LAN Adapter D3035 Server
D3035 dual port 1 Gbit PCIe x4 card
LAN Adapter D3035
Trust the network communication of the new Fujitsu
Ethernet LAN adapter. The new Fujitsu D3035
Ethernet LAN Adapter, based on the Intel® 1GbE
LAN Powerville I350-AM2 chip, offers two Gigabit
Ethernet ports for 10/100/1000BaseT.
Virtualization support and Wake-on LAN with
selectable port are just some of the features from
which you will benet. Optimal support for your
virtualization is provided by the support for Virtual
Machine Device Queues (VMDq), Single Root I/O
virtualization and sharing specication (SR-IOV).
SR-IOV requires corresponding support in the
system BIOS and in the operating system. PCI-SIG
SR-IOV denes extensions of the PCI Express (PCIe)
specication and enables PCI hardware resources
to be shared with several system images or Virtual
Machines.
The new functions for energy efcient Ethernet
(EEE) are also supported; this helps to decrease the
power consumption of the server itself.
Main Features Benefits
Based on the Intel® 1 GbE LAN Powerville I350 -AM2 chip Industry-leading, energy-efcient design for next-generation 1
Gigabit performance and multi-core processors
Power Management and Savings with EEE support This helps to decrease the power consumption of the server itself.
10/100/1000 Mbps Automatically compatible with Ethernet, Fast Ethernet, and Gigabit
Ethernet networks
Virtualization support via VMDq and SR-IOV Multi-port cards provide the platform with the port density required
for virtualized environments
Page 1 / 3 http://ts.fujitsu.com/Primergy
Data Sheet FUJITSU LAN Adapter D3035 Server
Technical details
Technical details
Controller type Ethernet Ctrl.
Controller Silicon Intel® I350-AM2 Gigabit Ethernet Controller
Controller vendor Fujitsu
Network protocol and standards
compatibility
Number of ports 2
Data transfer rate up to 1 Gbit/s
Auto Negotiation support Yes
Bus interface PCIe 2.1 x4
Bus transfer rate 5GT/s
HW Virtualization SR-IOV
Interrupt Levels INTA
WoL Yes
LEDs Link/Activity, Speed
Virtualization VMDq and SR-IOV support
Teaming With other Fujitsu and Intel LAN Adapters released for PRIMERGY servers
Switch fault tolerance (SFT) Yes
Adapter fault tolerance (AFT) Yes
Adaptive load balancing (ALB) Yes
Flow Control IEEE 802.3x
Remote boot support PXE 2.0
Additional features Jumbo Frames
Ofoading Tx/Rx IP, SCTP, TCP, and UDP checksum (IPv4, IPv6), Tx TCP segmentation (IPv4, IPv6)
iSCSI support Yes
IEEE 802.3i 10BASE-T
IEEE 802.3u 100BASE-TX
IEEE 802.3ab 1000BASE-T
IEEE 802.1q VLAN
IEEE 802.3x Flow Control
IEEE 802.3ad LACP
IEEE 802.3az Energy Efcient Ethernet (EEE)
IEEE 802.1as Timing and Synchronization
IEEE 1588 Precision Time Protocol
IPv4, IPv6 and mixed IPv4/IPv6 network protocols
DMA Coalescing (DMAC)
INTB
INTC
INTD
MSI
MSI-X
Environment
Temperature (operating) 0 - 60 °C
Storage temperature -20 - 70 °C
Compliance
Compliance notes According to the corresponding system
Compliance link https://sp.ts.fujitsu.com/sites/certicates
Page 2 / 3 http://ts.fujitsu.com/Primergy
Loading...