Fujitsu AOU12R2 Installation Manual

KEEP THIS OPERATION MANUAL

FUJITSU GENERAL LIMITED

FOR FUTURE REFERENCE

ASU9R2

ASU12R2

Outdoor Unit

AOU9R2

AOU12R2

HEAT & COOL MODEL

(REVERSE CYCLE)

ROOM AIR CONDITIONER

WALL MOUNTED TYPE

Indoor Unit

MANUAL DE FUNCIONAMIENTO

OPERATING MANUAL

P/N9314251030-01

Español

Français

MODE D’EMPLOI

English

•

–

≠

∞

(

™

)

5 6 4 7 8

OPERATION TIMER

SUPER QUIET

SWING

Fig. 6

Fig. 7

This figure shows the control display when all indicator lamps are on. It may differ from the actual display.

Fig. 5

Fig. 1

Fig. 8

En-1

Fig. 4

CAUTION!

Fig. 3

SAFETY PRECAUTIONS

DANGER!

Fig. 2

SLEEP TIMER OPERATION ................................ En-8

TIMER OPERATION ............................................ En-7

OPERATION ........................................................ En-5

PREPARATION .................................................... En-4

FEATURES AND FUNCTIONS............................ En-3

NAME OF PARTS ................................................ En-2

CONTENTS

SAFETY PRECAUTIONS .................................... En-1

● Do not use inflammable gases near the air conditioner. infants.

door or outdoor units.

equipment, or art works.

● Provide occasional ventilation during use.

● Do not direct air flow at fireplaces or heating apparatus.

● Do not climb on, or place objects on, the air conditioner.

● Do not hang objects from the indoor unit.

● Do not set flower vases or water containers on top of air conditioners.

● Do not expose the air conditioner directly to water.

● Do not operate the air conditioner with wet hands.

● Do not pull power supply cord.

● Turn off power source when not using the unit for extended periods.

● Check the condition of the installation stand for damage.

● Do not place animals or plants in the direct path of the air flow.

● Do not drink the water drained from the air conditioner.

● Do not use in applications involving the storage of foods, plants or animals, precision

● Do not apply any heavy pressure to radiator fins.

● Operate only with air filters installed.

● Do not block or cover the intake grille and outlet port.

● Ensure that any electronic equipment is at least one metre away from either the in-

● Avoid installing the air conditioner near a fireplace or other heating apparatus.

● When installing the indoor and outdoor unit, take precautions to prevent access to

● If the power supply cord of this appliance is damaged, it should only be replaced by

connect the power supply plug, and consult authorized service personnel.

the authorized service personal, since special purpose tools and specified cord are

required.

● In the event of a malfunction (burning smell, etc.), immediately stop operation, discord and so on.

airflow.

sonnel for repairs.

tion of the unit.

TROUBLESHOOTING ....................................... En-12

OPERATING TIPS.............................................. En-13

MANUAL AUTO OPERATION .......................... En-10

CLEANING AND CARE ..................................... En-11

ADJUSTING THE DIRECTION OF

AIR CIRCULATION .............................................. En-9

SWING OPERATION......................................... En-10

● Do not attempt to install this air conditioner by yourself.

● This unit contains no user-serviceable parts. Always consult authorized service per-

● When moving, consult authorized service personnel for disconnection and installa-

● Do not become excessively chilled by staying for lengthy periods in the direct cooling

● Do not insert fingers or objects into the outlet port or intake grilles.

● Do not start and stop air conditioner operation by disconnecting the power supply

● Take care not to damage the power supply cord.

ENTRADA DE ALIMENTACIÓN ........................................................................................................................................................................................................................................ 0,69 kW

CORRIENTE ............................................................................................................................................................................................................................................................................ 6,5 A

CAPACIDAD ................................................................................................................................................................................................................................................................

CALEFACCIÓN

ALIMENTACIÓN ............................................................................................................................................................................................................................................................... 115 V~60 Hz

REFRIGERACIÓN

ESPECIFICACIONES

CHAUFFAGE

PUISSANCE FRIGORIFIQUE .......................................................................................................................................................................................................................................

PUISSANCE ABSORBEE ....................................................................................................................................................................................................................................................

INTENSITE ............................................................................................................................................................................................................................................................................. 6,5 A

ALIMENTATION................................................................................................................................................................................................................................................................ 115 V~60 Hz

REFROIDISSEMENT

FICHE TECHNIQUE

PUISSANCE ABSORBÉE ...................................................................................................................................................................................................................................................

INTENSITÉ ............................................................................................................................................................................................................................................................................. 7,6 A

CURRENT ............................................................................................................................................................................................................................................................................... 6.5 A

HEATING

CAPACITY ...................................................................................................................................................................................................................................................................

INPUT POWER ...................................................................................................................................................................................................................................................................

COOLING

POWER SUPPLY ............................................................................................................................................................................................................................................................... 115 V~60 Hz

SPECIFICATIONS

UNITÉ EXTÉRIEURE

MODEL

MODÈLL

MODELO

INDOOR UNIT

UNIDAD INTERIOR

UNITÉ INTÉRIEURE

OUTDOOR UNIT

UNIDAD EXTERIOR

AOU9R2

ASU9R2

TYPE HEAT & COOL MODEL

TYPE MODÈLE RÉVERSIBLE

TIPO MODELO DE REFRIGERACIÓN Y CAlEFACCÓN

CALEFACCIÓN

REFRIGERACIÓN

ESPECIFICACIONES

CHAUFFAGE

MODEL

MODÈLE

REFROIDISSEMENT

FICHE TECHNIQUE

HEATING

COOLING

SPECIFICATIONS

MODELO

INDOOR UNIT

UNIDAD INTERIOR

UNITÉ INTÉRIEURE

OUTDOOR UNIT

UNIDAD EXTERIOR

UNITÉ EXTÉRIEURE

AOU12R2

ASU12R2

TYPE HEAT & COOL MODEL

TYPE MODÈLE RÉVERSIBLE

TIPO MODELO DE REFRIGERACIÓN Y CAlEFACCÓN

9.600 BTU/h

0 ,

82 kW

9.700 BTU/h

9.600 BTU/h

0,69 kW

9.700 BTU/h

0 ,

82 kW

9,600 BTU/h

0 .

69 kW

9,700 BTU/h

0 .

82 kW

12.800 BTU/h

0,99 kW

12.300 BTU/h

12.800 BTU/h

0,99 kW

12.300 BTU/h

1,07 kW

12,800 BTU/h

0.99 kW

12,300 BTU/h

1.07 kW

Fig. 1 Indoor Unit

Fig. 6 Remote Control Unit

1 Operating Control Panel (Fig. 2) 2 MANUAL AUTO button

3 Indicator Lamps (Fig. 3) 4 Remote Control Signal Receiver 5 OPERATION Indicator Lamp (red) 6 TIMER Indicator Lamp (green)

●

If the TIMER indicator lamp flashes when the timer is operating, it indicates that a fault has occurred with the timer setting (See Page 12 Auto Restart).

7 SUPER QUIET Indicator Lamp (green) 8 SWING Indicator Lamp (orange)

9 Intake Grille (Fig. 4) 0 Air Filter (left) A Air Flow Direction Louver B Right-Left Louver

(behind Air Flow Direction Louver)

C Drain Hose D Air Filter (right)

Fig. 5 Outdoor Unit

E Intake Port F Outlet Port G Pipe Unit

H MASTER CONTROL button I SET TEMP. / SET TIME buttons (+/-) J Signal Transmitter K TIMER button L FAN CONTROL button M START/STOP button N SLEEP button O SET button P SWING button Q ACL button R TIME ADJUST button

Rear side (Fig. 7) S TEST RUN

● Touch the two metal contacts with a

metallic object to send the signal to perform a test run.

● Perform a test run only when installing the air conditioner. If the signal to perform a test run is received during normal operation, the air conditioner’s thermostat will malfunction.

● If the signal to perform a test run is received during normal operation, the unit will switch to the test operation mode and the indoor unit’s OPERATION and TIMER indicator lamps will flash simultaneously.

● To stop the test operation mode, press the

START/STOP button to stop the air conditioner.

● Refer to the folded out page on the cover.

T Remote Control Unit Display (Fig. 8) U Transmit Indicator V Clock Display W Operating Mode Display X T imer Mode Display Y Fan Speed Display Z Temperature Set Display [ T imer Set Indicator \ Temperature Set Indicator

En-2

FEATURES AND FUNCTIONS

AUTO CHANGEOVER

The operation mode (cooling, heating) is switched automatically to maintain the set temperature, and the temperature is kept constant at all times.

SLEEP TIMER

When SLEEP is selected be pressing TIMER button during Heating mode, the air conditioner’s thermostat setting is gradually lowered during the period of operation; during Cooling or Dry mode, the thermostat setting is gradually raised during the period of operation. When the set time is reached, the unit automatically turns off.

SWING OPERATION

The Air Flow Direction Louvers swings automatically up and down so that the air speeds to every nook and corner of your room.

WIRELESS REMOTE CONTROL UNIT

The Wireless Remote Control Unit allows convenient control of air conditioner operation.

MILDEW-RESISTANT FILTER

The AIR FILTER has been treated to resist mildew growth, thus allowing cleaner use and easier care.

SUPER QUIET OPERATION

When the FAN CONTROL button is used to select QUIET, the unit begins super-quiet operation; the indoor unit’s airflow is reduced to produce quieter operation.

En-3

PREPARATION

Turn on the Power

In the case of a direct line connection, turn on the circuit breaker.

Load Batteries (R03 / LR03 × 2)

Press and slide the battery compartment lid on the re-

verse side to open it.

Slide in the direction of the arrow while pressing the mark.

Insert batteries.

Be sure to align the battery polarities ( ) correctly.

Close the battery compartment lid.

Set the Current time

Press the TIME ADJUST button (Fig. 6 R).

Use the tip of a ball-point pen or other small object to press the button.

CAUTION!

● Take care to prevent infants from accidentally swallowing batteries.

● When not using the remote control unit for an extended period, remove the batteries to avoid possible leakage and damage to the unit.

● If leaking battery fluid comes in contact with your skin, eyes, or mouth, immediately wash with copious amounts of water, and consult your physician.

● Dead batteries should be removed immediately and disposed of properly, either in a battery collection receptacle or to the appropriate authority.

● Do not attempt to recharge dry batteries.

Never mix new and used batteries, or batteries of different types. Batteries should last about one year under normal use. If the remote control unit’s operating range becomes appreciably reduced, replace the batteries and press the ACL button with the tip of a ballpoint pen or other small object.

Use the , / - SET TEMP. / SET TIME buttons (Fig. 6

I) to adjust the clock to the current time.

, button: Press to advance the time.

- button: Press to reverse the time.

(Each time the buttons are pressed, the time will be advanced/reversed in one-minute increments; hold the buttons depressed to change the time quickly in ten-minute increments.)

Press the TIME ADJUST button again.

This completes the time setting and starts the clock.

To Use the Remote Control Unit

● The Remote Control Unit must be pointed at signal receiver (Fig. 1 4) to operate correctly.

● Operating Range: About 7 meters.

● When a signal is properly received by the air conditioner, a beeping sound will

be heard.

● If no beep is heard, press the Remote Control Unit button again.

Remote Control Unit Holder

Insert

Press in

Screws

Slide up

Pull out

1 Mount the Holder. 2 Set the Remote Control

Unit.

3 To remove the Remote

Control Unit (when use at hand).

En-4

OPERATION

To Select Mode Operation

Press the START / STOP button (Fig.6 M).

The indoor unit’s OPERATION indicator lamp (red) (Fig. 3 5) will light. The air conditioner will start operating.

Press the MASTER CONTROL button (Fig.6 H) to se-

lect the desired mode.

Each time the button is pressed, the mode will change in the following order.

AUTO COOL DRY

HEAT FAN

About three seconds later, the entire display will reappear.

To Set the Thermostat

Press the SET TEMP. / SET TIME buttons (Fig. 6 I).

, button: Press to raise the thermostat setting.

- button: Press to lower the thermostat setting.

●Thermostat setting range:

AUTO .................................. 64 to 88 °F

Heating ............................... 60 to 88 °F

Cooling/Dry ........................ 64 to 88 °F

The thermostat cannot be used to set room temperature during the FAN mode (the temperature will not appear on the remote control

About three seconds later, the entire display will reappear.

The thermostat setting should be considered a standard value, and may differ somewhat from the actual room temperature.

unit’s display).

Example: When set to COOL.

Example: When set to 86 °F.

To Set the Fan Speed

Press the FAN CONTROL button (Fig. 6 L).

Each time the button is pressed, the fan speed changes in the following order:

AUTO HIGH MED LOW QUIET

About three seconds later, the entire display will reappear.

When set to AUTO:

Heating : Fan operates so as to optimally circulate warmed air.

However, the fan will operate at very low speed when the temperature of the air issued from the indoor unit is low.

Cooling : As the room temperature approaches that of the thermostat setting,

the fan speed becomes slower.

Fan : The fan runs at the low fan speed.

The fan will operate at a very low setting during Monitor operation and at the start of the Heating mode.

When set to QUIET:

SUPER QUIET operation begins. The indoor unit’s airflow will be reduced for quieter operation.

● SUPER QUIET operation cannot be used during Dry mode. (The same is true when dry mode is selected during AUTO mode operation.)

● Heating and Cooling performance will be reduced somewhat during SUPER QUIET operation.

ssss

To Stop Operation

Example: When set to AUTO.

Press the START/STOP button (Fig.6 M).

The OPERATION indicator lamp (red) (Fig. 3 5) will go out.

En-5

+ 12 hidden pages