www.frigidaire.com USA 1-800-944-9044 www.frigidaire.ca Canada 1-800-265-8352
Important Safety Instructions
NOTE:
This USE & CARE MANUAL provides specific operating instructions for your model. Use the dehumidifier only as instructed in this USE & CARE
MANUAL. These instructions are not meant to cover every possible condition and situation that may occur. Common sense and caution must be
practiced when installing, operating, and maintaining any appliance.
WARNING
Avoid fire hazard or electric shock. Do not
use an extension cord or an adaptor plug. Do
not remove any prong from the power cord.
Grounding type wall
receptacle
Do not, under any
circumstances, cut,
remove, or bypass the
grounding prong.
WARNING
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or
any other appliance. Read product labels for flammability and other warnings.
Discard water from bucket. Water is not potable and cannot be used for drinking.
For Your Safety
WARNING
Destroy the carton, plastic bags, and any packing materials immediately after the
dehumidifier is unpacked. Children should never use these items for play.
Do not leave children unattended in an area where the appliance is operating.
Do not allow them to sit or stand on the appliance.
Child Safety Precautions
WARNING
Power supply cord
with 3-prong grounding
plug
For your safety and protection, this dehumidifier is equipped with a three-prong grounding
plug on the power cord. Do not, under any circumstances, cut or remove the round ground
prong from the plug.
Your dehumidifier must be plugged directly into a properly grounded and polarized
three-prong receptacle. lf the wall receptacle you intend to use will not accept a
three-prong plug, or if you are not sure the outlet is adequately grounded or protected
by a time delay fuse or circuit breaker, have a qualified electrician install the proper outlet
according to the National Electrical Code and applicable local codes and ordinances. Do not
use an extension cord or an adapter plug.
Never unplug the dehumidifier by pulling on the power cord. Always grip the plug firmly
and pull straight out from the receptacle.
Do not pinch, bend, or knot the power cord.
Electrical Information
SAFETY PRECAUTIONS
This dehumidifier contains no user-serviceable parts. Always call an authorized Electrolux servicer for repairs.
Do not insert or place fingers or objects into the air discharge area or front grille of the unit.
Do not start or stop the dehumidifier by unplugging the power cord or turning off the power at the electrical box.
Do not cut or damage the power cord.
If the power cord is damaged, it should only be replaced by an authorized Electrolux servicer.
In the event of a malfunction (sparks, burning smell, etc.), immediately stop the operation, disconnect the power cord, and call an authorized
Electrolux servicer.
Do not operate the dehumidifier with wet hands.
Do not pull on the power cord.
Do not drink any water from the dehumidifier.
DANGER! Avoid Serious Injury or Death
SAFETY PRECAUTIONS
Do not direct airflow at fireplaces or other heat related sources as this could cause flare ups.
Do not climb on or place objects on the unit.
Do not hang objects off the unit.
Do not place containers with liquids on the unit.
Turn off the dehumidifier at the power source when it will not be used for an extended period of time.
Operate the unit with air filter in place.
Do not block or cover the intake grille, discharge area and outlet ports.
Ensure that any electrical/electronic equipment is one yard away from the unit.
Do not use or store flammable gases near the unit.
2009 Electrolux Home Products, Inc.All rights reserved.
CAUTION! Avoid Injury or damage to the unit or other property
2
Location & How It Works
Dripping Sound
Sound of Rushing Air
Gurgle/Hiss
High pitched Chatter
Location
How It Works
Normal Sounds
At the top of the unit, you may
hear the sound of rushing air
being moved by the fan.
Selecting a Location
IMPORTANT:
1. Dehumidifier must be operated in an enclosed area to be most effective. Close all doors,
windows, and other outside openings to the room. The effectiveness of the dehumidifier
depends on the rate at which new moisture-laden air enters the room.
2. Place dehumidifier in a location that does not restrict airflow through the front of the unit or
out of the louvers on the left side of cabinet.
3. A dehumidifier operating in a basement will have little or no effect in drying an adjacent
enclosed storage area, such as a closet, unless there is adequate circulation of air in and out
of the area. lt may be necessary to install a second dehumidifier in the enclosed area for
satisfactory drying.
4. The dehumidifier must be installed on a level floor that will support it with a full bucket of
water.
5. There should be a minimum of 12 inches clearance around the dehumidifier.
When the unit is started, the fan begins to pull moisture-laden air across the dehumidifying coils.
The coils condense or draw moisture from the air, and air flows through the top louvers into the
room as dry, warm air. Moisture removed from air is collected in a bucket on the front of the
dehumidifier.
The unit is designed to operate between 41 °F (5 °C), and 96 °F (35 °C). The unit will not work
properly if the temperature is out of this temperature range, or the performance of the unit will
fall greatly.
The "Compressor" circuit has an automatic 3 minute time delayed start if the unit is turned off
and on quickly. This prevents overheating of the compressor and possible circuit breaker tripping.
Make sure the tank is fitted correctly otherwise unit will not turn on.
“Gurgling or hissing” noise may be heard
due to refrigerant passing through
evaporator during normal operation.
The sound of dripping water may be
heard during the dehumidification cycle.
2009 Electrolux Home Products, Inc.All rights reserved.
Today’s high efficiency compressors
may have a high pitched chatter
during the dehumidification cycle.
3
FCC Statement
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by tuning the device off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the device and receiver.
Connect the equipment into an outlet other than the one used for the receiver.
Consult the dealer or an experienced radio/TV technician for assistance.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any interference received, including interference that may cause
undesired operation.
FCC CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Host device Labeling
This device includes the following module.
Contains FCC ID: 2AIBX-WD115
RF exposure statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum 20 cm between the radiator and your body. This transmitter must not be collocated or
operating in conjunction with any other antenna or transmitter unless authorized to do so by the FCC.
INDUSTRY CANADA (IC) STATEMENT
This Class B digital apparatus complies with Canadian ICES-003.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may
cause undesired operation of the device.
RF Exposure
The antenna (or antennas) must be installed so as to maintain at all times a distance minimum of at least 20 cm between the
radiation source (antenna) and any individual. This device may not be installed or used in conjunction with any other antenna
or transmitter.
Host device Labeling
This device includes the following module.
Contains IC: 21700-NIUX