Model VPAL2
Installation Instructions
ARCHITECTURAL LOUVER
For Use With Vert-I-Pak Units
Please read these instructions completely before attempting installation.
NOTE: These instructions apply to Vert-I-Pak Units ONLY. Refer to Chassis Installation/Operation Manual for additional
information.
IMPORTANT: The VPAL2 Architectural Louver is best installed onto the Outside Plenum
(Part A) PRIOR to the Wall Plenum installation. The louver installation is easier at this
point, and it will help keep the Wall Plenum square during installation.
Parts included in this kit:
A) 1 - Aluminum Architectural Louver
B) 4 - Attachment Screws (located in a plastic bag taped to the louver)
INSTALLATION OF THE LOUVER PRIOR TO VPAWP WALL PLENUM INSTALLATION
Hold the louver up to the Outside Wall Plenum Part A (see the VPAWP instructions) and line up the louver top with the
very top edge of the 3/4" flange. Line up the VPAWP holes with the threaded holes in the louver, install and tighten
the four screws. Note that there are eight flange holes, however, only the four inside holes are used.
920-077-01 (10-04)
INSTALLATION OF THE LOUVER AFTER INSTALLATION OF THE VPAWP WALL PLENUM
For safety, tie a rope or tether to the Architectural Louver, then to the divider in the Wall Plenum. This will
prevent the louver from falling from the building if it is dropped.
From inside the utility closet:
A) Grasp the louver as shown in the illustration.
B) Turn the louver sideways and push the louver out the bottom opening in the Wall Plenum.
C) Pull the louver back against the Wall Plenum and align the four holes.
D) Insert and tighten all four screws. When the louver is secured, remove the safety tether.
SAFETY TETHER
VERY IMPORTANT!
ATTACH THE VPAL2
LOUVER WITH THE 4
SCREWS PROVIDED
FRIEDRICH AIR CONDITIONING CO. INC.
Post Office Box 1540 · San Antonio, Texas 78295-1540
4200 N. Pan Am Expressway · San Antonio, Texas 78218-5212
(210) 357-4400 · FAX (210) 357-4480
www.friedrich.com
Printed in the U.S.A.
920-077-01 (10-04)