Franke FFP S700 SERIES Installation Manual

FFP S700 SERIES

Pull-Out Spray Faucet

Installation guide

2

ENGLISH

PARTS LIST

G 13396.XX Handle

G R0239.XX Ring cap

G 1156 Cartridge

G R0637 Fastening set (rubber washer, triangular ange, metal washer, nut)
G R1664 Valve-holder

G 1636 Counter weight and gaskets
G 1463 Flexible hose

G 1748.XX Spray head

G 1782 Supply exible hose

G 29016 Supply exible hose

TECHNICAL FEATURES

Maximum water ow 2.2 gpm - 60 psi
Recommended pressure range 15-75 psi - Over 75 psi PRV required
Complies with Proposition 65, NSF61, UPC and C-UPC requirements

TECHNICAL DATA

· Minimum working pressure 0,5 bar

· Maximum working pressure 5 bar

· Recommended working pressure 3 bar (in case of water pressure
higher than 5 bar it is recommended to install pressure reducers)

· Maximum working temperature 70°C

G 13396.XX

G R0239.XX

G 1156

G 1748.XX

G 1782

G R0637

G R1664

G 1636

G 1463

G 29016

3

ENGLISH

Faucet installation

Please remove all components from package and inspect prior to
installation (see itemized table and picture).

NOTE:

Call us immediately if you see inconsistencies. (1-800-626-5771)

or visit

www.frankeksd.com

TABLE OF CONTENTS

1 Faucet

2 Fastening set (rubber washer, triangular ange, metal washer, nut)

3 Counter weight and gaskets

4 Spray head

5 Valve-holder

Remove all mounting hardware from protecting plastic bag.

3

1

2

4

5

4

ENGLISH

Set the faucet into place on the sink as indicated in the gure.

NOTE:
the rubber O-ring should be sitting on top of the countertop and between
the faucet body. DO NOT use putty or other sealant at this location.

Install faucet to the sink or countertop