INSTALLATION GUIDE
Kitchen - FF2400, FF2460, FF2480
Bar/Prep - FFBP2400, FFBP2460, FFBP2480
KITCHEN
SYSTEMS
TECHNICAL DATA
Standard Water Flow - 1.2 GPM at 45 PSI
Maximum Water Flow - 2.2 GPM at 60 PSI
Recommended Pressure Range - 15 to 75 PSI
has certified that this faucet complies with NSF61, AB1953 and ASME 112.18.1-2011/CSA
B125.1-2011 requirements
INSTALLATION INSTRUCTIONS
Remove all contents from the package and check for completeness.
1
NOTE:
Call us immediately if you see inconsistencies.
(1-800-626-5771)
or visit
www.frankeksd.com
info.fks@franke.com
1
6
4
2
8
Ŧ
Installation tools:
Package Contents:
1 - Mixer
2 - Fastening Set
(2) Rubber Washers
(1) Nut
3 - Counterweight (2)
4 - Aerator Wrench
5 - Check Valve
6 - Sprayhead
7 - Pull-Out Hose - Factory Assembly
8 - Hose Riser Assembly
(attached to mixer by installer)
9 - Riser Sealing Washer
Pre-Assembled in item 8
*
*
- Factory Assembly
Ŧ
5
9/16" [14mm] - Supply Hose
9
7
3
5/8" [16mm] - Hand shower hose
1-5/8" [41mm] - Fastening set
Screwdriver - Phillips #2 - Weights
2
Installation
2
Flush the water supply to be sure it is free of
debris and then shut off the water supply.
Remove
check valve
3
4
Ensure O-ring is in place as shown to create
proper seal. If O-ring is missing, the faucet will
leak. Remove the check valve from the riser
swivel nut so the nut can be moved out of the
way. Install hose riser into mixer body. Use
wrench to tighten. Reinstall the check valve and
sealing washer onto the swivel nut, hand tight.
Before inserting the mixer in the hole in the sink
or counter top, make sure that the rubber washer
is properly positioned in its seat. Place the mixer
in the hole, orienting the spout toward the sink
bowl.
Note: Hole should be 35mm (1-3/8”) minimum
diameter
O-ring
Position
wrench
on hose
riser flats
Swivel nut
5
Install fastening set as shown: rubber washer
and threaded washer/nut. Tighten the
washer/nut with wrench.
DO NOT ROTATE MIXER BODY
to tighten the threaded nut.
Only tighten with wrench from the underside
of sink.
Rubber
Washer
Rubber
Washer
Washer/Nut
3