PM0.5 Studio Monitor
Preliminary Specifications
Acoustic Section
Frequency Response
Free field +/- 2dB, 50Hz to 20kHz
Low Freq Cut -off: 40Hz
High Freq Cut -off: 22kHz
Maximum Short Term SPL: 80Hz - 3kHz >
105dB SPL 1m
Amplifier Section
Output power: 40w+30w
Distortion: <0.01% THD @25W/8 ohm,
20Hz - 20kHz
S/N: >84dB, 20Hz - 30kHz
Slew rate: 15V/uSec
General
Weight: 14.3 lbs each
Dimensions: 7 1/8"(W) x 11"(H) x 10 1/4"(D) incl. Heat Sink
9"(D) excl. Heat Sink
PM0.5 Transducers
The 5” LF driver has been developed to obtain extremely pure music reproduction by employing the latest
technology in cone material.
• The cone uses a mixture of cut and milled fibers that are made from aromatic polyamide. It is then
impregnated with resins to simultaneously achieve high rigidity and optimum damping.
• The cone has an olefin film thermally adhered to its surface to control frequency response and to
establish long-term reliability.
• The center dust cap is made of non-wood cellulose material and is also impregnated with resin.
• The voice coil is made of super high purity copper wire to achieve very low distortion.
HF Driver
The .75” soft dome tweeter employ s Fostex’s UFLC technology (Poly Urethane Film Laminated Cloth) to
achieve lightweight and high stability performance.
MSRP: $399/pair
MAP: $299/pair
Availability: February 2003
Specifications are subject to change any time without notice
Loading...