Fortinet MD40 User Manual
FortiCam MD40
QuickStart Guide
March 2, 2018
1st Edition
Copyright © 2018 Fortinet, Inc. All rights reserved. Fortinet
®
, FortiGate®, FortiCare® and FortiGuard®,
and certain other marks are registered trademarks of Fortinet, Inc., and other Fortinet names herein
may also be registered and/or common law trademarks of Fortinet. All other product or company
names may be trademarks of their respective owners. Performance and other metrics contained
herein were attained in internal lab tests under ideal conditions, and actual performance and other
results may vary. Network variables, different network environments and other conditions may affect
performance results. Nothing herein represents any binding commitment by Fortinet, and Fortinet
disclaims all warranties, whether express or implied, except to the extent Fortinet enters a binding
written contract, signed by Fortinet’s General Counsel, with a purchaser that expressly warrants that
the identified product will perform according to certain expressly-identified performance metrics
and, in such event, only the specific performance metrics expressly identified in such binding
written contract shall be binding on Fortinet. For absolute clarity, any such warranty will be limited to
performance in the same ideal conditions as in Fortinet’s internal lab tests. Fortinet disclaims in full
any covenants, representations, and guarantees pursuant hereto, whether express or implied. Fortinet
reserves the right to change, modify, transfer, or otherwise revise this publication without notice, and
the most current version of the publication shall be applicable.
Technical Documentation http://docs.fortinet.com
Knowledge Base http://kb.fortinet.com
Forums https://forum.fortinet.com
Customer Service & Support https://support.fortinet.com
Training Services http://training.fortinet.com
FortiGuard Threat Research & Response http://www.fortiguard.com
Document Feedback Email: techdocs@fortinet.com
Table of Contents
Package Contents 4
Hardware Overview 5
Hardware Installation 6
Camera Connection 8
Technical Specifications 9
Register for Support 11
Regulatory Notices 12
Cautions and Warnings 13
Fortinet Product License Agreement / EULA and Warranty Terms 14
Package Contents
• 1x FortiCam camera
• 1x torx screwdriver
• 3x screws and 3x anchors
• 1x waterproof connector assembly
• 1x cable adapter plate
Page 4
Hardware Overview
Page 5
Hardware Installation
Caution: Adequate grounding must be provided to the unit and the PoE
injector, in compliance with your local electrical code or regulations.
Note: Suggest to avoid exposure to direct sunlight in outdoor installation
for better image quality and longer service life.
To install
1. Remove the dome cover.
2. Attach the camera to the wall or ceiling.
Page 6
3. To adjust the lens angle, lock and unlock lens alignment with the
screw at the lens base. Then install the dome cover.
To assemble the waterproof connector
1. Thread the Ethernet cable through the screw nut, rubber ring and
crew bolt.
2. Insert the rubber ring into the screw bolt and connect the screw nut
to the screw bolt.
3. Attach the O-Ring to the network port connector.
4. Connect the network cable to the connector and attach the screw
bolt to the connector.
Page 7
Camera Connection
1 2 3 4
CONSOLE
USB
USB
FortiRecorder 200D
FortiRecorderPoE SwitchCamera
Caution: This device complies with IEEE 802.3af PoE specification. Do
not use any PoE injectors that are not IEEE 802.3af compliant as they may
damage your device.
To connect the camera
1. Connect the camera’s Ethernet port to the FortiRecorder NVR via a
PoE switch. The camera gets its IP address from the DHCP server
automatically.
2. Go to the FortiRecorder web UI to configure the discovered
camera. For details, see the FortiRecorder Administration Guide on
http://docs.fortinet.com.
To reset the comera to factory default
1. Remove the dome cover.
2. Press and hold the Reset button for more than 5 seconds.
Note: The camera’s default IP address is 192.168.1.245.
Page 8
Loading...