Page 1
Formax OnSite FD 8402CC
Cross-Cut Paper Shredder
Instruction Manual
Page 2
Paper Shredders
FD 8400CC Cross-Cut
FD 8400SC Strip-Cu
t
OPERATOR MANUAL
Safety Devices and Other Features
Automatic Reverse Rotation
When too much paper is inserted, the cutter stops operating
Automatic Stop
When the shredded paper fi lls the wastebasket, the “FULL”
the wastebasket and empty paper scraps. Replace the wastebasket,
Automatic Power Shut-Off
minutes, the power is automatically shut off.
down. When the fl ashing stops the shredder is ready to be used again.
The “MANUAL” LED will fl ash after every four (4) hours of operation as an
oiled. NOTE: the shedder will still operate when the LED is fl ashing but at a
decreased load capacity.
To oil:
Spread shredder oil onto the cutters through the feed opening, and allow
the oil to sit for a few minutes to permeate the cutting blades, then press the “REV”
Maintenance
very dirty, use a neutral detergent, then wipe again with a soft cloth.
discoloration.
MyBinding.com
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920
Page 3
Operation
Auto Start/Auto Stop
When the “START A/M” button is pushed, the signal lamp
Safety Precautions
To avoid personal injury, and damage to the shredder, observe the following safety
Set-up Guidelines
sunlight.
2. Insert plug into wall outlet with the appropriate voltage, 110V. If the outlet
Specifi cations
20” W x 20” D x 34” H
20” W x 20” D x 34” H
20 gal.
20 gal.
Weight:
shredder will automatically operate in reverse. If this occurs, remove the inserted
shredded differs according to paper quality, humidity and voltage. If the shredder is
to be used continuously, do not insert more than half of the maximum capacity.
the wastebasket, close door, and continue to shred.
In case of emergency, push the
Keep hands, long hair, clothing, ties, jewelry
and loose items away from the feed opening
and shred outlet.
Do not use the shredder for anything other
than its intended purpose. Never use it to shred cloth, plastic, cardboard or any
hard material that will cause damage to the shredder blades.
Do not allow children to use the machine.
Do not operate with a damaged power cord or plug, or when the machine
damaged in any manner.
Unplug the shredder when it is being moved, or if it is not in use for an
period of time.
disconnecting.
Keep the shredder away from direct sunlight.
Do not sit on the shredder or place anything on top of it.
Never open the fi xed switch or cover.
Loading...