Formax FD 340 User Manual

FD 340
Document Folder
4
3.5” X 5” TO 11” X 17” (88.9 W x 127 L TO 311W x 432 L mm)
Weight:
4. Attach telescoping outfeed stacker.
(Fig. 2).
outlet.
the “Fault detect” light.
when a fault happens and light is lit, only press the button one time. If
you press it a second time, you will reset the counter.
4
When doing a “Single” fold, be sure to move the
4. Move the stacker wheels to the proper position for
press the Batch
Measure the length of panel “A”
Adjust the upper fold plate so that the stop plate lines
Measure the length of panel “B”
Adjust the lower fold plate so that the stop plate lines
Load forms and press test. If folds are too long or too
Measure the length of panel “A” & “B”
Adjust the upper fold plate so that the stop plate lines
that it lines up with the 10” mark on the fold plate.
Measure the length of panel “B”
Adjust the lower fold plate so that the stop plate lines
Load forms and press test. If folds are too long or too
table.
paper size. Loosen the brass thumb screw, open
or close the guides to fi t the paper width and
retighten the thumbscrew (Fig 8a).
feeder. When feeding stapled sets the documents
should be placed with the staple on the operators
side and leading (Fig 9).
4. The sheets of paper will be automatically pulled into
the folder (there is a one second delay after the
paper is placed in the feeder).
8.5" x 11" 8.5" x 14" 11" x 17"
Letter Zig-Zag Single Gate Fold Out Double ll
A A B A B A
A or B A or B
B B C A
B B C C C
A or B
weight and type. If the paper is too heavy it may not be
weight position #2 (Fig. 14) as indicated in the pictures below. Position # 2 may also be good for small folded
WHEEL SETUP FOR
Do not use any chemicals other than the roller cleaner & rejuvenator or water.
folders have four (4) rubber rollers (Fig. 15).
4. Make sure to run 10-15 sheets of blank copy paper
wires.
fold rollers are dirty.
Loading...