Flymo Garden Vac 2500 User Manual [ru]

IMPORTANT INFORMATION

Read before use

& retain for future reference

Original Instructions

®

1

Carton Contents

IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product.
IF ANY PAR TS ARE MISSING CONTACT:­Husqvarna UK Ltd. Customer Service Department direct
Telephone : [phone] UK 1800 882 350 ROI Fax : [phone]

Safety

If not used properly this Gardenvac can be dangerous. The warnings and safety instructions must be fol­lowed to ensure reasonable safety and efficiency in using this product. The operator is responsible for
following the warnings and instructions in this manual and on the product.

Explanation of Symbols on the Garden­vac

Warning

Read the user instructions
carefully to make sure you
understand all the controls
and what they do.

Do not operate in the rain
or leave the product out­doors while it is raining.

Switch off! Remove plug
from mains before ad­justing, cleaning or if
cable is entangled or
damaged.

The use of eye protection
is recommended.

Keep bystanders away.

BEFORE USING YOUR GARDEN

-

VAC FOR THE FIRST TIME

Assemble debris bag to
bag frame.

EVERY TIME YOU USE YOUR GAR

-

DENVAC

Switch off and disconnect
from the mains electricity
supply BEFORE

fitting
cutting line to cutting head
& clipping into place and
BEFORE REMOVING
cutting line.

Switch off and disconnect
from the mains electricity
supply BEFORE FITTING
fully assembled debris
bag to product and BE

-

FORE REMOVING

fully
assembled debris bag
from product.

NEVER CONNECT THE PRODUCT
TO THE MAINS ELECTRICITY SUP­PLY UNTIL THE FULLY ASSEMBLED
DEBRIS BAG IS FITTED COR­RECTLY

1

2

trigger

nozzle

mode indicator

debris bag

Air inlets

cutting lines

2 handle knobs

adjustable handle

2 handle bolts

debris bag frame

instruction manual

adjustable
shoulder
harness

General

1.

This product is not intended for use by persons (in­cluding children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowl­edge, unless they have been given supervision or in­struction concerning the use of the product by a
person responsible for their safety. Children should
be supervised to ensure that they do not play with
the product. Local regulations may restrict the age of
the operator.

2. Never allow children or people unfamiliar with the in­structions to use the machine.

3. Stop using the machine while people, especially chil­dren, or pets are nearby.

4. Only use the product in the manner and for the func­tions described in these instructions.

5. Never operate the product when you are tired, ill or
under the influence of alcohol, drugs or medicine.

6. The operator or user is responsible for accidents or
hazards occurring to other people or their property.

2

Electrical

1. The British Standards Institute recommend the use of
a Residual Current Device (R.C.D.) with a tripping
current of not more than 30mA. Even with a R.C.D.
installed 100% safety cannot be guaranteed and safe
working practice must be followed at all times. Check
your R.C.D. every time you use it.

2. Before use, examine cable for damage, replace it if
there are signs of damage or ageing.

3. Do not use the product if the electric cables are dam­aged or worn.

4. Immediately disconnect from the mains electricity sup­ply if the cable is cut, or the insulation is damaged. Do
not touch the electric cable until the electrical supply
has been disconnected. Do not repair a cut or dam­aged cable. Replace it with a new one.

5. Your electric cable must be uncoiled, coiled cables can
overheat and reduce the efficiency of the product.

6. Do not pull cable around sharp objects.

7. Always switch off at the mains before disconnecting
any plug, cable connector or extension cable.

8. Switch off, remove plug from mains and examine electric
supply cable for damage or ageing before

winding cable
for storage. Do not repair a damaged cable, replace it
with a new one. Use only genuine replacement cable.

9. Never carry the product by the cable.

10. Never pull on the cable to disconnect any of the plugs

11. Always wind cable carefully, avoiding kinking.

12. Use only on AC mains supply voltage shown on the
product rating label.

13. Our products are double insulated to EN60335.
Under no circumstance should an earth be con­nected to any part of the product.

Preparation

1. Always wear suitable clothing, gloves, and stout shoes.

2. The use of eye protection is recommended.

3. The use of ear protection is recommended.

4. To prevent dust irritation, the wearing of a face mask
is recommended.

5. Do not wear loose clothing or jewellery that can be
drawn into the air inlet.

6. Do not wear clothing with attachments, i.e. toggles or
drawstrings that can be drawn into the air inlet.

7. Inspect your product before each use, especially the
parts of the cutting head. Replace cutting line if worn
or damaged.

8. Do not use if any part is damaged or broken or if any
of the screws are loose. Have it repaired by an autho­rised repairer.

9. Always check your product is in a safe operating con­dition before use.

Use

1. Use the product only in daylight or good artificial light.

2. Do not use the product when it is raining or in damp
and wet areas.

3. Never use the product in or near water or ponds.

4. Know how to stop the product quickly in an emergency.

5. On slopes, be extra careful of your footing and wear
non-slip footwear.

6. Walk, do not run.

7. Never pick up or carry the product by the cable.

8. Keep children, pets and bystanders at a safe distance
when using your product.

9. Keep long hair away from air inlet.

10. Keep all inlets clear of debris.

11. Always remain alert.

12. Do not attempt to use your product without the fully
assembled debris bag fitted.

13. Never blow debris in the direction of bystanders.

14. Do not overreach. Keep proper footing and balance
at all times.

15. The cutting head and cutting line continue to rotate
after your product has been switched off.

16. Remove the plug from the mains :-

- before removing or replacing cutting line;

- before removing or replacing fully assembled debris bag;

- before leaving the product unattended for any period;

- before clearing a blockage;

- before checking, cleaning or working on the appliance;

- if the product starts to vibrate abnormally. Check im­mediately. Excessive vibration can cause injury.

Maintenance and storage

1. Keep all nuts, bolts and screws tight to be sure the
product is in a safe working condition.

2. Replace worn or damaged parts for safety.

3. After use the product should be stored in a safe place
where it is protected from damage.

4. Inspect the collection bag regularly. If the collection
bag becomes worn or damaged, replace.

5. Store in a cool, dry place and out of reach of children.
Do not store outdoors.

6. Allow the product to cool for at least 30 minutes before storing.

CABLES
IMPORTANT

• Use only 1.00mm

2

size cable up to 40 metres length

maximum.

Maximum rating :

1.00mm

2

size cable, 10 amps 250 volts AC.

• THE GARDENVAC IS SUPPLIED WITH CABLE WIRED
DIRECTLY INTO THE PRODUCT.

1. Flymo Mains Cables and Extension Cables are avail­able from your local Husqvarna UK Ltd., Approved
Service Centre.

2. Do not wire an extension cable directly to your product
yourself. Please contact your local Husqvarna UK Ltd.
Approved Service Centre for further information on the
connectors and kits available.

3. Only use extension cables specifically designed for
outdoor use.

CONNECTORS
IMPORTANT

• Flymo connectors are suitable for use with 2 core cable
only. Under no circumstances should these connectors
be used for earthed products.

• All Flymo connectors and cables are of splashproof con­struction. They are not waterproof and must not be left out­side permanently nor should they be submerged or
immersed in water. Do not let cable lay or trail through
pools of water or splashed with water from hose pipes.

MAINS PLUG REPLACEMENT
IMPORTANT

• If the plug supplied is cut off it should be destroyed.

There is an electric shock hazard if a cut off plug is in­serted into a 13 amp socket.

1. No earth required. Flymo products are double insu­lated to EN60335 and under no circumstances
should an earth be connected to any part of the prod­uct.

2. Ensure the mains voltage suits your product

3. IMPORTANT!
The wires in the mains lead are coloured in accor­dance with the following code:
BLUE - NEUTRAL BROWN - LIVE
The wire which is coloured BLUE must be connected
to the Terminal which is marked with the letter 'N' or
coloured BLACK.
The wire which is coloured BROWN must be con­nected to the Terminal which is marked with the letter
'L' or coloured RED.

4. It is important that the outer sheath is clamped cor­rectly into the 3-pin plug.

5. If in doubt consult your local Service Repairer or quali­fied electrician before the machine is used.

6. A 13 Amp fuse must be fitted to the Mains Plug.

7.

The normal plug fuse and household fuse only protect
the electrical equipment and are not a safeguard
against electrocution.

If your product is hard wired i.e. non-detachable mains
electric cable, a conversion kit and extension cable is avail­able from all Husqvarna UK Ltd. Approved Service Centres
which can be found in your local Yellow Pages.