Page 1
24 Volt T rimline Electric F ans
Installation Instructions
Puller Mode (as shipped from the manufacturer)
Through Core Mounting Instructions
(SEE DIAGRAM “A”)
1.Position the electric fan against the radiator,
and mark mounting hole locations.
2. Pass a small Phillips screwdriver through the
marked holes, carefully spreading the fins to
allow easy passage for the nylon bolts. Fit the
bolts to the mounting tabs, and pass the bolts
through the shroud holes in the radiator.
3.Push on the speed nuts until snug.
4. Cut off the end of the mounting bolts,
leaving 1/4” remaining.
Pusher Mode Thr ough Core Mounting Instructions
1.Remove retaining clip from motor shaft.
2.Remove fan blade, flip it over, and re-fit to shaft. Make sure that pin on shaft is seated into
groove in fan hub. Replace retaining clip.
3. Proceed with instruction above.
Note: some vehicles have a/c condensers or tranny coolers
Push
Nut
Diagram A
Puller Mode
Shown
mounted in front of the radiator. Modifications may be necessary to accommodate the fan.
Nylon
Bolt
Wiring Instructions
Important: Pusher fans use:
Black wire is positiv e (+).
Blue or Red wire is negative(-).
Important: Disconnect the battery prior to wiring any of the products below.
Direct Connect: (Fan will operate when the ignition is “on”)
1.Attach the positive fan motor wire to a 24 V positive ignition controlled source, e.g. fuse box.
Use the 15 amp inline fuse provided for each fan.
2.Attach the negative fan motor wire to a ground, e.g. negative side of battery, chassis etc.…
3. Reconnect battery.
Important: Puller fans use:
Blue or Red wire is positive (+).
Black wire is negative (-).
The Flex-a-lite Limited Warranty
Flex-a-lite Consolidated, 7213-45th St. Ct. E., Fif e, W A 98424, Telephone No. 253-922-2700, warr ants to the original purchasing user , that all Fle x-a-lite products to be free of
defects in material and workmanship for a period of 365 days (1 year) from date of purchase. Flex-a-lite products failing within 365 da ys (1 year) from date of purchase ma y
be returned to the factory through the point of purchase, transportation charges prepaid. If, on inspection, cause of f ailure is determined to be defectiv e material or workmanship and not by misuse, accidental or improper installation, Flex-a-lite will replace the product free of charge, transportation prepaid. Flex-a-lite will not be liable for
incidental, progressive or consequential damages. Some states do not allow the e xclusion or limitation of incidental or consequential damages, so the abo ve limitation or
exclusion may not apply to you. This wa rranty gives you specific legal rights and you may have other rights, which vary from state to state. The Flex-a-lite warranty is in
compliance with the Magnuson-Moss Warranty Act of 1975.
Rev. 03-22-10 99824
Loading...