Fisher-Price G2579 User Manual
w
w
w
.
f
i
s
h
e
r
-
p
r
i
c
e
.
c
o
m
Please keep this instruction sheet for future reference,
as it contains important information.
Requires four “C” (LR14) alkaline batteries
for operation (not included).
Requires one KPR113 Krypton light bulb (included).
Tool required for battery installation and light bulb replacement:
Phillips screwdriver (not included).
TELESCOPE & PROJECTOR
G2579
Instructions
Battery Installation
• Locate the battery compartment
door on the top of the toy.
• Loosen the screw in the battery
compartment door with a
Phillips screwdriver. Lift the battery compartment.
• Insert four “C” (LR14) alka-
line batteries.
Hint: We recommend the use of
alkaline batteries for longer
battery life.
• Replace the battery compartment door and tighten the screw
with a Phillips screwdriver. Do
not over-tighten.
Battery
Compartment
1.5V x 4
“C” (LR14)
Shown Actual Size
2
Battery Safety Information
Batteries may leak fluids that can cause a chemical burn injury or ruin your toy.
To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types:
alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove
exhausted batteries from the toy. Dispose of batteries safely. Do not
dispose of batteries in a fire. The batteries may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging.
• If removable, rechargeable batteries are used, they are only to be
charged under adult supervision.
Assembly
Hole
Threaded Bar
Plastic Screw
Tripod
• Place the projector/telescope upside-down on a flat surface.
• Position the tripod with the rib side facing down.
• Insert the tripod into the center slot on the projector/telescope.
• Align the holes in the projector/telescope with the hole in the tripod.
• Push the threaded bar through the holes in the projector/telescope
and the tripod.
• Place the plastic screw on the end of the threaded bar and tighten.
Do not over-tighten.
3
Loading...